查询词典 adjusting screw

Sometimes, the value of the printed on a flat brush wheel pressure too seriously, to gauge side must increase resistance paper La poorly in this case, you should set the oblato brush round of adjusting screw meanders by inverse rotation axis until the brush, and then press stop to pre-senile meanders turn 1 ~ 2 go, so that the brush can turn in the rotation on paper with the same ease even better.

有时，负纸版上的扁毛刷轮压得太轻，给侧规处事补充必定的阻辛而变成纸弛不推不到位，在这种环境下，答不兵扁毛刷轮的调度螺丝按逆时钟标的目的不静弹，直至毛刷轴罢手不静弹，然后按顺时钟标的目的不静弹1～2不停，使毛刷轮在纸背上能不静弹自若不离算调度好了。

To readjust reduced pressures, loosen check nut and turn adjusting screw clockwise to raise reduced pressure and counterclockwise to lower reduced pressure.

如果要重新调节压力，则松开锁进螺母，顺时针旋转调节螺丝，提高减压；逆时针旋转，降低减压。

And then switch on the offset printing presses, and tweak the adjustment nut, rubber plastic knife blade slowly to the oscillating roller surface contact, left and right extremes of adjusting screw contact pressure requires uniform, rubber knife and oscillating roll each part can even contact curettement innovativeink across the Board.

然后启不静胶印机，并且拧不静调度螺母，使橡皮胶刀的刀刃迟缓不天向串不朱辊的暗不天隔绝，把握两头的调度螺丝隔绝不张力给求平均，橡皮刀与串不朱辊每一个部位平均隔绝，不妨片面不天刮不兴油不朱。

A steering shaft, a steering column, a steering gear housing with side and lower covers, a globoid worm, a pitman shaft with a triple roller, an bearing and a pitman shaft adjusting screw .

操纵机构由方向盘、驾驶杆、带有侧盖和下盖的转向器壳、球面蜗杆、带有三重滚轴连杆轴、轴承和调节转动的连接杆轴组成。

And 6 intake valves. Tighten valve adjusting screw locknut to 27 N·m (20 lb-ft).

将气门调节螺丝防松螺母拧紧至27牛顿·米（20磅-英尺）。

Valve plate and valve seat sealing surface for the oblique cone structure, oblique cone surface in the valve plate welding temperature, corrosion resistant alloy materials; fixed in the regulation of the spring between the ring plate and the plate with the adjusting screw assembly structure.

阀板与阀座的密封面为斜圆锥结构，在阀板斜圆锥表面堆焊耐温、耐蚀合金材料；固定在调节环压板之间的弹簧与压板上调节螺栓装配一起的结构。

Valve plate and valve seat sealing surface for the oblique cone structure, oblique cone surface in the valve plate welding temperature, corrosion resistant alloy materials; fixed in the regulation of the spring between the ring plate and the Butterfly Valves plate with the adjusting screw assembly structure.

水力控制阀阀板与阀座的密封面为斜圆锥结构，在阀板斜圆锥表面堆焊耐温、耐蚀合金材料；固定在调节环压板之间的弹簧与压板上调节螺栓装配一起的结构。

If valve clearance needs to be adjusted, loosen the locknut on rocker arm adjusting screw. Turn adjusting screw until feeler gauge slips with a slight drag.

如果气门间隙需要调节，松开摇臂调节螺丝上的防松螺母，转动调节螺丝直到测隙规滑动时稍带阻力为止。

If trip-under stop happens in shifting from higher to lower gear position,screw out the upper adjusting screw.

如果跳闸停止下发生的转变，以降低较高的齿轮位置，螺杆上的调整螺钉。

If trip-under stop happens in shifting from lower to higher gear position,screw out the lower adjusting screw.

如果跳闸停止下发生的变化从低到高齿轮的立场，螺杆出较低的调整螺钉。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了