查询词典 adiabatic

In retrofitting the burners, primary air was concentrated, the distance between primary air and secondary air was enlarged, oil gun was raised, tertiary air was changed to self-induced way which is advantageous for combustion and the furnace was covered with adiabatic materials. The purposes of taking these measures are to raise the furnace temperature and improve the ignition and combustion of anthracite.

对燃烧器的改造，采取了一次风进一步集中，将一二次风之间的距离拉开、油枪位置上提、三次风改为更利于燃烧的自引式、炉膛中增敷了卫燃带等技术措施，提高了炉膛的温度水平，更利于无烟煤的着火、燃烧。

Serre was improved for Cauchy problem of compressible adiabatic flow through porous media, and a complete result on the global existence and the blow_up phenomena of classical solutions of these systems.

Serre得到的关于多孔介质中可压缩流体力学方程组解的存在性结果，给出了其Cauchy问题的一个关于经典解整体存在和破裂的完整结果·这些结果说明强耗散有助于&小&解的光滑性

The concept of geometric phase first introduced by Pancharatnam in his study of interference between light waves in distinct states of polarization and rediscovered by Berry for quantal systems undergoing cyclic adiabatic evolution has been refined and applied during the past years.

几何相的概念首先是由Pancharatnam在研究偏振光干涉时提出来的，Berry在研究做绝热演化的量子体系时发现了Berry绝热相。从此几何相理论引起了人们的普遍重视。

The concept of geometric phase first introduced by Pancharatnam in his study ofinterference between light waves in distinct states of polarization and rediscovered by Berryfor quantal systems undergoing cyclic adiabatic evolution has been refined and applied duringthe past years.

几何相的概念首先是由Pancharatnam在研究偏振光干涉时提出来的，Berry在研究做绝热演化的量子体系时发现了Berry绝热相。

This article presents that adding manhole to vacuum powder adiabatic tank used for liquid carbon dioxide is important and necessary, describes this manhole's structure, design thinking and assembly processing requirements.

本文论述了真空粉末绝热液态二氧化碳贮罐增设人孔的重要性和必要性，并详细介绍了这种贮罐人孔的结构、计思路及组装工艺要求。

Two models were developed, one for calculating the leakage rate of water from heat transfer tubes due to one broken double ended guillotine tube in the steam generator of LMFBR using the one dimensional method of characteristics, and anotherone for temperature, adiabatic spherical to columnar hydrogen bubble growth model in large sodium water reaction.

采用一维特征线方法建立了快堆蒸汽发生器单管发生双端断裂情况下，水从破裂传热管流出的泄漏率计算模型和钠水反应气泡从球状到柱状的变温绝热生长模型。沸腾是钠冷快堆安全分析工作中必须要考虑的一个问题，而堵流是众多导致发生沸腾原因中十分重要的一个。

A new method for assessing the local shear strain in adiabatic shear band of Ti-6Al-4V is proposed by using of gradient-dependent plasticity.

中文摘要：提出了利用梯度塑性理论计算Ti-6Al-4V绝热剪切带的局部剪切应变新方法。

This paper reports the current studies on the film cooling characteristics of single-row holes on flat plate at different blowing ratios, and analyzes the distributions of adiabatic film cooling effectiveness and heat transfer coefficient downstream the film holes.

对不同吹风比条件下的典型单排孔冷却结构的平板气膜冷却特性进行了实验研究，对冷却孔下游的气膜冷却效率及换热系数分布规律进行了分析。

This paper deals with how thermal inertia and adiabatic effect of an object welding And what flame should be applied in oxy-acetylene welding with silver-copper solder and the high temperature area of flame are also discussed then the effect of free oxygen and free carbon on welding is analyzed.

探讨了物体的热惰性和绝热效应对焊接的影响，讨论了采用银铜焊料进行氧－乙炔焊时应该运用的火焰和火焰的高温区域。

Experimental analysis show: When the temperature of flue gas approach to adiabatic saturation temperature, the capacity factor of Ca and the desulfuration efficiency are improved.

实验分析表明：当烟气接近绝热饱和温度时，脱硫效率及钙利用率提高。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。