查询词典 acrylic acid

Acrylic acid that the cardinal plane reinforces a tier is that rolling direct cement sharpening agent (SRA-01) Tu follows the evidence air temperature on surface, but adds appropriate amount addition Shimizu commixture dilution with acrylic acid in clean base of drying.

丙烯酸基面加强层是用丙烯酸水泥加强剂（ SRA-01）直接滚涂于干燥洁净的基面上，跟据气温可加适量添加清水混合稀释。

According to the properties of acrylic acid series polymer of scale inhibition. A kind of amphiprotic tercopolymer of acrylic acid, acrylamide and dimethyldiallylammonium chloride is synthesised, with water as solvent, persulfate and hypophosphate as initiator. Through the tests, the copolymer can show the good scale inhibiting effect and bactericidal action, and become a multifunctional scale inhibition.

本研究根据丙烯酸聚合物阻垢剂的特点，使用过硫酸铵(NH_4_2S_2O_8、次亚磷酸钠(Na_2PO_3)构成的氧化——还原型引发剂，水为溶剂，合成了新型可用于处理工业循环冷却水的丙烯酸—丙烯酰胺—二甲基二烯丙基氯化铵两性型三元共聚物。

Acrylic Resins are derived from methacrylic acid, acrylic acid or other related compounds, these substances are related to thermosetting plastic or thermoplastic.

丙烯酸树脂是来自甲基丙烯酸，丙烯酸或其他相关的化合物，这些物质都与热固性或热塑性塑料。

This result agrees well with the literature values of 23.5 and 22.0 kcal/mol obtained for the solution polymerization of partially neutralized acrylic acid (pH = 11) and undissociated acrylic acid(pH = 1), respectively.

这一结果也同意与文学价值的23.5和22.0千卡/摩尔获得的溶液聚合部分抵消丙烯酸（ pH值= 11 ）和undissociated聚丙烯酸（ pH值为1），分别。

The amido of Chitosan and thecarboxyl of acrylic acid made Chitosan-acrylic acid hydrogel pH-sensitive andion-sensitive.

壳聚糖的氨基，聚丙烯酸的羧基，使得壳聚糖-丙烯酸水凝胶具有pH和离子敏感性。

He best reaction conditions of TMAA were as follows: p-benzenediol as the polymerization inhibitor and the amount 1% of acrylic acid, reaction temperature 180 ℃,reaction time 3 h, raw material mass ratio of methyl eleostearate /acrylic acid 1:0.247 and the yield of TMAA was 85%.

MAA的最佳合成条件为：反应温度180℃，反应时间3 h，桐酸甲酯和丙烯酸的质量比为1：0.247，阻聚剂对苯二酚的加入量为丙烯酸质量的1%，产率为85%。

Acrylic acid and ester mainly is acrylic acid, methyl acrylate, ethyl acrylate, butyl acrylate, isobutyl acrylate, etc.

丙烯酸及酯主要是指丙烯酸、丙烯酸甲酯、乙酯、丁酯、异辛酯等。

The first synthetic route uses 1,2,4-trimethoxybenzene and chloroacetonitrile in forming 2,4,5-trimethoxy-a-chlor-acetophenone under the anhydrous condition, then the intermediate condensates with papaverine forming the core pyrro[2,l-a]isoquinoline, followed by formation and lactonization to form the lactone ring. The second synthetic route uses prepared aldehyde with prepared ethyl nitroacetate by Knoevenagel condensation to obtain 2-Nitro-3-(2,4,5-tris-methoxy-phenyl)-acrylic acid ethyl ester and 2-Nitro-3-(2,4,5-tris-benzyloxy -phenyl)-acrylic acid ethyl ester etal intermediates. The lamellarin skeleton could arise from condensation of the papaverine and these intermediates by Michael reaction, the ester group is provided for subsequent lactonization. The third synthetic route uses coumarin or indan-l,3-dione derivatives and papaverine to form lamellarin under basic conditions.

第一条路线首先从1，2，4-三甲氧基苯出发与卤乙腈作用合成卤代芳酮中间体，然后与罂粟碱反应合成开链片螺素，最后经乙酰化、去保护、成内酯环得到片螺素；第二条路线由制备的芳醛和制备的硝基乙酸乙酯经缩合得到2-硝基-3-芳基丙烯酸乙酯，然后由该中间体与罂粟碱反应，在完成关环的同时也引入酯基，最后去保护、成内酯环得到片螺素；第三条路线是由香豆素或茚二酮出发，经溴代后的中间体与罂粟碱反应，得到片螺素的基本框架。

Acrylic acid, starch and SPS were used as raw materials of solution polymerization to synthesize starch-g-acrylic acid superabsorbents interpenetrated with sodium PVA sulfate.

采用浓硫酸磺化法制备了聚乙烯醇硫酸钠；以丙烯酸、淀粉和SPS为原料采用水溶液聚合法合成了淀粉接枝丙烯酸－聚乙烯醇硫酸钠互穿网络高吸水性树脂。

Two series of polyurethane acrylate grafted acrylic resins (Acr-g-TPU-PETA and Acr-gPPU-PETA) self-emulsifying systems are obtained by grafting -NCO group modified polyurethane acrylates with acrylic copolymer prepared from n-butyl acrylate, styrene,βhydroxyethyl methacrylate and acrylic acid The self-emulsifying systems showed Newtonian fluidity with viscosity closed to that of water, the solid contents were around 30% The T〓 of 15～4℃ for dried film before photocuring favored film formation at room temperature DSC and DMA results showed that PU-PETA is compatible with acrylic resin in the grafted resin The TG and dTG curves for Acr-g-PU-PETA samples were substantially different from the corresponding blends, and the brodened dTG peaks for photocured grafted resin suggest that there might be multiple interactions among chain segments The photocued film of the grafted resins self-emulsifying system exhibited good overall properties with polyurethane acrylate grafts ranging from 30% to 50%, and Acr-g-TPU-PETA series showed better properties than Acr-gPPU-PETA series The adhesion of the photocured film was 1～2 grade, impact strength was 50kg-cm and flexibility was 1mm The Shore hardness and the adhesion of the film decreased markedly if PETA was replaced by HEMA as photoactive group due to the lower C=C double bond content in the grafted resin The polyhydroxy amine-linked thioxanthones photoinitiators can be evenly dispersed in self-emulsifying system without color spot appearing in the dried film The films photocured with IV〓～IV〓 generally exhibited higher Shore hardness, gloss and solventresistance than that cured with Irgacure 2959 and did not induce the rusting of the iron substrate Pigmenting with titanium oxide had no effect on the photocuring The polyhydroxy amine-linked thioxanthone IV〓 and IV〓 can be new candidates for the formulation of titanium oxide pigmented photocurable water-borne coatings for their pale-yellow appearance and slight interference with the color of the coatings WB 4759 with high water-solubility coalesced and separated from the dried resin film, and even induced the rusting of iron substrate.

以丙烯酸丁酯，甲基丙烯酸-β-羟乙酯，丙烯酸及苯乙烯合成厂丙烯酸共聚树脂，并与含-NCO端基的聚氨酯丙烯酸酯接枝反应，经水性化后，得到两个系列（Acr-g-TPU-PETA和Acr-g-PPU-PETA）各5个不同配比的丙烯酸树脂接枝聚氨酯丙烯酸酯自乳化体系，粘度与水相近，为牛顿流体，固含量30％左右。光固化前干燥涂膜的玻璃化转变温度在-15℃～4℃之间，有利于室温下成膜。DSC及DMA谱表明两种树脂基本相容。Acr-g-PU-PETA的热失重行为明显不同于共混材料，接枝样dTG峰明显宽化，表明接枝样中链段之间的相互作刚有多重性，丙烯酸树脂与聚氨酯之间有一定的相容性。接枝树脂自乳化体系光固化涂层的综合性能以聚氨酯丙烯酸酯成分为50％～30％者相对较好，且以Acr-g-TPU-PETA系列更理想。光固化膜的附着力为1～2级，冲击强度为50kg·cm，柔软性多为1mm。以HEMA代替PETA作为接枝树脂的活性基团，碳—碳双键密度太低，光固化膜交联点太少，硬度和附着力均较差。多羟基胺连硫杂蒽酮光引发剂能均匀分散于树脂自乳化体系和接枝树脂干膜中，不出现色斑，光固化膜肖氏硬度一般高于以Irgacure 2959为光引发剂的光固化膜，光泽度及耐丁酮溶剂性能均有所提高，不会诱导铁基生锈，钛白着色对光固化结果几乎没有影响。本论文所合成的多羟基胺连硫杂蒽酮光引发剂IV〓与IV〓为浅黄色，对光固化涂层的颜色干扰较小，为配制钛白着色光固化水性涂料提供了新的光引发剂。水溶性太强的WB 4759在干膜中易聚结析出，且对所附着的铁基有诱导锈蚀作用。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。