查询词典 accuracy of measurement
- 与 accuracy of measurement 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The theory of the system is combining formation of image and parallel white light projection. The system uses many edg measurement methods with subimage-element accuracy, and has many merits such as hige measurement accuracy, strong anti-interference function, intuitionistic measurement, convenient using and esay maintenance and so on. The repeatability of position measurement is below 0.1μm (0.05 pixel). EDG is used in practical machining of feedback stick, which is used in astronavigation industry.
在分析研究各种CCD工业检测技术基础上,研制了基于CCD和PC数字图像处理技术的反馈杆刚度检测系统,该系统采用成像法和平行白光投影法相结合的原理,综合运用了多种亚像素精度边缘检测方法,具有检测精度高、抗干扰能力强、检测直观、使用方便和易于维护等优点,其位置检测的重复精度可稳定在0.1μm(0.05像素)以内。
-
On the basis of study on two projects:"10-DOF ultrasonic detection system for complex surfaces part" and "Ultrasonic water-logging automatic survey system for rods", this thesis studies the technologies of ultrasonic measurement, kinematic and dynamic modeling of 10-DOF ultrasonic system, real-time sensitivity auto-adjusting, integrated technology of ultrasonic measurement, surface construction and ultrasonic detection for complex surface parts and rods, thus improving the accuracy and efficiency of ultrasonic detection for parts of complex surfaces. Meanwhile, an auto-detection system for metal rods with rough surfaces and bad columniform accuracy is presented for the first time.
本文结合&10自由度复杂曲面超声检测系统&和&棒材水浸超声自动检测系统&两个项目的研究,主要开展了超声测量、检测机器人运动学和动力学建模、误差补偿、灵敏度自动补偿和曲面构件超声检测一体化技术和轴棒类构件超声检测一体化技术的研究工作,进一步提高了复杂型面构件超声检测的效率和精度,并首次针对表面粗糙、圆柱度较差的金属轴棒类构件开发出了高效率的自动化检测设备。
-
The output power could be adjusted with the change of control voltage, and the reflecting power could be gotten by measuring the output voltage of attenuator and detector. 4.The thrust measurement device was calibrated, and the accuracy was 2%FS. At the same time the signal of thrust measurement was input to the computer. E-type chromel-constantan thermocouple was used to measure the temperature of MPT, and the accuracy was 5%FS.The vacuum measurement was realized by using ZDF-5427M vacuometer, and the accuracy was 3%FS.
4对推力测量系统进行了标定并实现了计算机采集,推力测量系统最大相对误差为2%FS;温度测量目前还只限于对MPT谐振腔壁温的测量,使用E型镍铬—康铜热电偶即可较容易实现,其测量精度为5%FS;真空测量采用ZDF-5427M微机型复合真空计,其由热偶计和热阴极电离计复合而成,该真空计测量控制精度为3%FS。
-
The roundness tester is a highly precision instrument that is wildly used to measure the rotary work piece in mechanical industry. The aged roundness tester was astricted by the technique condition of that time, so its way of measurement is not at all advanced. Because these roundness testers have been used for a long time, they have a highly failure rate and their accuracy can not be insured.
圆度仪是机械工业中应用最广泛的检测回转体零件圆度误差的高精度仪器,由于老式的圆度仪受当时技术条件的限制,评定方法落后,再加上这些圆度仪的使用时间较长,使用时仪器的故障率一般都较高,测量精度也不能保证。
-
In order to improve the measurement accuracy of impact flowmeters,measuring characteristic of the impact flowmeter is analyzed by the experiments.
为提高冲板流量计的测量精度,对冲板流量计的测量特性进行了实验分析。
-
The approach comprises following steps: grouping available measurements in various possible subsets, solving target position in Cartesian co-ordinate corresponding to each measurement subset, selecting several subsets with higher accuracy of position location, fusing the data of target-position corresponding to subsets selected by step .
本文围绕双/多基地系统的配置,利用各站可能获得的观测量怎样实现对目标的精确定位与跟踪这个问题来展开研究的,并以探索双/多基地系统的定位与跟踪性能为目的,对双/多基地系统的定位方法和定位精度、定位跟踪算法及其性能等方面进行了深入的分析和研究。
-
It is indicated that the accuracy of the measured value is determined rather by the practical relative error than by the maximum relative error. It is correct that the nearer the scale reading approaches the maximum, the more accurate the measurement is. The scale reading need not be required above 2/3X.
指出使用电表进行测量时,测量值的准确性是由其实际相对误差而非最大相对误差决定的;并非电表的读数越接近满刻度,测量值的准确性就越高;使用电表进行测量时,电表的读数不必被限定在2/3X上。
-
Mr. Bill Clinton, some experts said that you and your NATO calculate the bombing accuracy of guided bombs with the metre and even the centimetre as the units of measurement.
克林顿 先生,据专家说,您和您的北约的制导导弹轰炸精确度可以以米甚至以厘米为单位来计算。
-
The improved loss calculation method can improve the accuracy of digital oscilloscopes with a measurement error of less than 5%.
通过分析提出了开通和关断损耗的改进计算方法,在获得较高准确度(95%)的同时可降低对示波器测量分辨率的要求。
-
A measurement for the time resolution limit produced by a photomultiplier, with the accuracy of ± 2 ~ 5 X 10-9 Sec., has been made.
对光电倍增管所产生的时间分辨限制进行了测量;测量准确度是±2~55×10~(-9)秒。
- 推荐网络例句
-
Plunder melds and run with this jewel!
掠夺melds和运行与此宝石!
-
My dream is to be a crazy growing tree and extend at the edge between the city and the forest.
此刻,也许正是在通往天国的路上,我体验着这白色的晕旋。
-
When you click Save, you save the file to the host′s hard disk or server, not to your own machine.
单击"保存"会将文件保存到主持人的硬盘或服务器上,而不是您自己的计算机上。