查询词典 absorption of heat

The conclusions were as follows: theνO-H andνC=O IR absorption maxima shifted towards higher wave numbers after imprinting 17β-estradiol on TFMAA-co-TRIM copolymer with the red shift of theνO-H groups being apparent after precipitation polymerization for 16h while that forνC=O groups being observed after polymerization for 24h. A strong interaction between TFMAA and 17β-estradiol was confirmed by the high selectivity for 17β-estradiol, as indicted by the values of the separation factor of isomers of 17β-estradiol/17α-estradiol (2.28) and the imprinted factor (3.01). Particle diameter of TFMAA-co-TRIM polymer was between 300 nm and 1.5μm, which suited well for solid phase sorbent throughout at low column pressure. The recognition of imprinting TFMAA-co-TRIM polymer for sterol molecules was driven by enthalpy eluted with acetronitile, and low temperature was in favor of the separation of sterol structure analogues on imprinting column. TFMAA-co-TRIM polymer possessed of determinate anti-heat stability, with melting point beginning at 255.84℃, Tp=257.40℃, control TFMAA-co-TRIM polymer and imprinting TFMAA-co-TRIM polymer were respectively decompounded at 267.79℃and 343.11℃, and solid micro-extraction noddle prepared by the special polymerization also showed definite recognition for 17β-estradiol by GC/MS detecting at 270℃. By selection of various washing and elution solvents, elution reagents of close polymerization system were of more advantage in template molecules retention and recognition on molecularly imprinted solid phase extraction column. At a certain extent, progesterone, 17α-estradiol, 17β-estradiol and 4-androstene-3, 17-dione could be intercepted on the MISPE column. Especially, MISPE had high selectivity for progesterone, and imprinting TFMAA-co-TRIM polymer could achieve adsorption balance within 50 min by absorption kinetics test for 17β-estradiol. However, MISPE column showed better selectivity and enrichment property for 17β-estradiol than C18 and CSPE columns according to the data from HPLC and GC/MS analyses. Recovery of 17β-estradiol on MISPE column was up to 85.5% while when prime extracting solution of milk powder was sampled, the recovery of CSPE and C18 columns were 43.7% and 30.7%, respectively.

通过研究阐明：紫外聚合产物TFMAA-co-TRIM中的νO-H振动吸收峰在聚合16h后红移，νC=O振动吸收峰在聚合24h后红移；TFMAA-co-TRIM对雌二醇异构体的印迹因子达到了3.01，α为2.28，优于其它功能单体参与得到的聚合物识别特性；TFMAA-co-TRIM聚合物粒径介于300 nm至1.5μm之间，作为色谱固定相具有良好的通量和低的柱压；在乙腈流动相中，TFMAA-co-TRIM分子印迹固定相的分离过程主要被焓驱动，低温有利于分子印迹固定相分离甾醇结构类似物；TFMAA-co-TRIM分子印迹聚合物在255.84℃时开始熔融，Tp=257.40℃，聚合物CP的降解温度在267.79℃，MIP降解温度在343.11℃，制备的固相微萃取头初步经GC/MS 270℃的耐热性测定；不同的洗提溶剂筛选证明了选择接近聚合溶剂的洗脱体系更有利于MISPE发挥识别效应；分子印迹固相萃取柱对孕酮、17α-雌二醇、17β-雌二醇和雄烯二酮都具有不同程度的保留特性，可作为此类化合物的吸附材料，特别对孕酮强保留的富集特性，可作为孕酮的选择性识别吸附剂，其分子印迹聚合物对17β-雌二醇的吸附动力学测定显示在50 min内基本达到吸附平衡，具有作为传感器核心敏感材料的潜力；对比萃取奶粉中17β-雌二醇性能，MISPE柱比非分子印迹固相萃取柱和C18柱具有更高的保留，回收率依次为85.5%，43.7%和30.7%。

A numerical model was established by combining the seven-flux model of light propagation with the two-dimensional hyperbolic heat conduction model in cylindrical coordinates. It showed that there exists a great discrepancy between the results obtained by treating the laser irradiation as volumetric absorption (i.e. taking laser scattering and absorption into consideration) and those obtained by treating the laser irradiation as the second boundary condition.

将激光传输的七流模型与圆柱坐标系内的二维双曲型导热模型相结合建立了理论模型；将激光照射处理为容积吸收(即考虑激光在生物组织中的散射和吸收)所得到的计算结果，与将激光照射处理为第二类传热边界条件所得到的计算结果相比，两者差别很大；考察了激光照射下散射系数和吸收系数对生物组织内双曲型导热的影响。

The influences of the inlet solution flow rate, the inlet solution temperature, the absorption pressure and the colling condition on heat and mass transfer of absorption process have been discussed.

在此基础上，设计、研制、安装并调试了竖板及矩形通道降膜吸收试验台本体；确定测量方法，选取测量装置并对测量系统不确定度进行了分析。

The effects of various optical coefficients(such as scattering and absorption coefficients, anisotropy parameter, etc.) and thermophysical properties(such as surface convective coefficient, etc.) and physiological coefficients(such as blood perfusion rate and metabolic heat generation, etc.) on the thermal behavior of the LILC method wet-c discussed in detail. The results show that the size and location of cauterized tissue under the skin can be bontrolled by properly adjusting the absorption and scattering coefficients and irradiation power and so on.

在此基础上，详细讨论了散射系数、吸收系数、各向异性系数等光学参数，激光加热功率、照射半径、表而对流换热系数等热学参数，以及血液灌注率和新陈代谢等生理参数对这种低损伤加热疗法的影响，结果发现，只要通过适当调节吸收系数、散射系数和照射功率等参数就可实现对加热区域位置和范围的控制。

The dilute solution of the absorption apparatus of the refrigeration system serially backflows to the low, middle and high temperature solution heat exchangers and generators in turn and reflows to the absorption apparatus finally, thereby achieving the reasonable utilization of different grade energy and having relative high thermal efficiency of the unit.

该制冷系统吸收器的稀溶液串联倒流依次进入低、中、高温溶液热交换器和发生器，最后流回吸收器，能够实现对不同品位能量的合理利用，其机组热效率也相对较高。

The absorption spectral properties of several novel subphthalocyanine compounds in different media, such as in solution and in solid films. The effects of solvent vapor treatment and heat treatment on the absorption spectra of these films were also studied and discussed.

本文研究了几种新型亚酞菁化合物在不同介质中（稀溶液、高分子介质、蒸发膜和溶液旋涂膜）的吸收光谱特性，研究了溶剂处理和热处理对该类薄膜吸收光谱的影响，并结合酞菁类化合物的能级结构、聚集特性以及亚酞菁特有的非平面结构对以上结果作了合理的解释。

The metal supporting elastic card plates optical absorption film which conductes the heat to the bottom of the heat conduction working fluid ring cavity.

金属支撑弹卡镀有光吸收膜，将热量传导于导热工质环腔管的底部。

Assuming that the temperature distribution close to the concrete surface is the quadratic function of the coordinate, the back-analysis equations of thermal conductivity, heat transfer coefficient and absorption coefficient of solar radiation are derived based on one dimension Fourier equation of heat conduction and thermal boundary conditions.

为了选取更接近实际的热工参数，采用试验和反演分析相结合的方法，计算影响日照条件下混凝土结构温度场和温度效应分析结果的热工参数。

A single plate was adopt to study the effect of the parameters such as cooling water flow rate, inlet solution temperature, inlet solution flow rate on absorption heat and heat transfer coefficient of plate absorber.

实验采用单层光滑换热平板，研究系统冷却水流量，进口溶液的温度、流量等参数对平板式吸收器吸收热以及传热系数的影响。

Absorption heat transformer is one of the strong competitive technologies for heat recovery.

吸收式热变换器是很有竞争力的热回收技术之一。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"