查询词典 absorbent power

The reasons: first, the ink dry slowly tends to be a result of the slow evaporation rate of water, usually as a result of viscidity exorbitance or monochamus version xuetie deep and too thick membrane or for non-absorbent plastic, aluminum foil, and so on do not absorb ink, the other is for full wind conditions or no drying equipment condition or drying (including infrared small magnetic dry power) caused by the temperature low and so on.

原因：一是油墨干燥慢往往是因水的蒸发速率慢引起的，通常也会因粘度过高或版穴深而墨膜过厚或因非吸收性塑料，铝箔等不吸收油墨导致的，二是因完全无风状态下或无烘干设备条件或烘干(包括红外磁波干燥功率小)温度低造成的等等。

The result showed that the optimal condition of inorgano-absorbent manufacture as following: concentration of vitriol is 15%, the bentonite carrier must be soaked in the 0.4% La(superscript 3+) solution, the pH is 10, microwave radiation power is 340 W for 5 min. The optimal condition of organo-absorbent manufacture process as following: concentration of CTMA is 5%. The rate of wave must 166 W and the time of radiation is 6 mi In addition, the experimental results showed that with inorgano-absorbent the pH number is 3~6 and the reaction time is 45 min, the removal efficiency of phosphor will be up to 99% and the amount of adsorption will be up to 41 mg/g. And with organo-absorbent the pH number is 3~4 and the reaction time is 45 min, the removal efficiency of phosphor is more 30% than that of inorgano-absorbent. The removal efficiency of phosphor will be up to 99% and the number of adsorption will be up to 60 mg/g.

实验表明：①制备无机稀土吸附剂的适宜条件为：硫酸浓度15%，镧浓度0.4%，浸渍pH值10，微波功率340 W，辐射时间为5 min；②制备有机稀土吸附剂的适宜条件为：表面活性剂浸泡浓度为5%，微波功率为166 W，微波辐射时间为6 min；③无机稀土吸附剂当溶液的pH值为3~6，振荡时间为45 min时，对磷去除率为99%以上，吸附量达到了41 mg/g以上，有机稀土吸附剂当溶液的pH为3~4，振荡时间为45 min时，其效果比原来镧改性的无机吸附剂吸附量提高了30%，磷去除率为99%以上，吸附量达到了60 mg/g以上。

Trans-Blot Cells and Systems 170-3825 Trans-Blot Cell With Wire Electrodes and PowerPac HC Power Supply, 100120/220240 V, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm), power supply, power cord, instructions 170-3850 Trans-Blot System With Plate Electrodes and PowerPac HC Power Supply, 100120/220240 V 170-3853 Trans-Blot System With Plate Electrodes, Super Cooling Coil, and PowerPac HC Power Supply, 100120/220240 V, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm), power supply, power cord, instructions 170-3910 Trans-Blot Cell With Wire Electrodes, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) 170-3939 Trans-Blot Cell With Plate Electrodes and Super Cooling Coil, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) 170-3946 Trans-Blot Cell With Plate Electrodes, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) Trans-Blot Cell Accessories 170-3912 Super Cooling Coil, required for all high-intensity transfers 170-3913 Gel Holder Cassette, includes 2 fiber pads 170-3914 Fiber Pads, 15.5 x 20.5 cm, 6 170-3920 Trans-Blot Standard Wire Electrode Card, cathode 170-3921 Trans-Blot Standard Wire Electrode Card, anode 170-3922 Trans-Blot Cell Buffer Tank 170-3923 Trans-Blot Cell Lid With Power Cables 170-3943 Trans-Blot Platinum Anode Plate Electrode 170-3944 Trans-Blot Stainless-Steel Cathode Plate Electrode 170-3945 Trans-Blot Plate Electrode Pair, platinum anode and stainless-steel cathode 16 规格:说明: Trans-Blot Plus

电泳转印槽组件 1。缓冲液槽及带有电缆的盖 2。凝胶支架转印夹 3。纤维衬垫 4。电极丝 5。电极板 6。特级冷却芯 Trans-Blot 转印槽是功能灵活的转印设备，可理想地用于多种转印应用。Trans-Blot 转印槽特点包括：*能进行多胶转印，可容纳3 块PROTEAN I xi 凝胶、6块Criterion 凝胶、12块Mini-PROTEAN 3 或Ready Gel 预制胶*多组参数灵活可设，可调节的电压设置（从30 V 的过夜转印到200 V 的1 小时快速实验）*电极间距设置为8 cm 用于标准印迹杂交，或设置为4cm 用于高强度印迹杂交*可选择板式电极：涂有铂金的钛作为正极，不锈钢为负极，能提供高强度电场和比其它电极更高的电流密度。或选择较经济的铂金电极丝*通过特级冷却芯和水循环仪来调节温度―是天然酶（4°C）或高强度转印的理想选择，随着转印时间增加（多达24 小时），不会引起缓冲液耗竭（在高强度转印中必须使用冷却芯，也推荐用于所有板式电极的应用）*带铰链的凝胶支架转印夹能避免滑动，确保凝胶与印迹膜间的紧密接触；每个转印夹都有颜色标记以保证在转印槽中的正确定位 Trans-Blot 转印槽的锁闭凝胶支架转印夹系统。转印夹（1）支撑凝胶（2）印迹膜（3）两侧有纤维衬垫和滤纸（4）确保凝胶三明治内的完全接触。凝胶夹垂直插入缓冲液槽中（5）。

Trans-Blot Plus Cell 170-3990 Trans-Blot Plus Cell With Plate Electrodes and Super Cooling Coil, includes 3 gel holder cassettes, buffer tank, lid with power cables, 6 fiber pads, 1 pack blot absorbent filter paper (26.5 x 28 cm, 30 sheets), roller, stirbar 170-3991 Trans-Blot Plus Cell and PowerPac HC Power Supply Accessories 170-3994 Trans-Blot Plus Gel/Cassette Assembly Tray 170-3995 Fiber Pads, 27 x 28.5 cm, 2 170-3996 Blot Absorbent Filter Paper, 26.5 x 28 cm, 60 sheets 170-3997 Stirbar 170-3998 Trans-Blot Plus Roller, 6 wide 170-39 Trans-Blot Plus Gel Holder Cassette With Clamps 170-4990 Trans-Blot Plus Super Cooling Coil 170-4991 Trans-Blot Plus Platinum Anode Plate Electrode 170-4992 Trans-Blot Plus Stainless-Steel Cathode Plate Electrode 170-4995 Trans-Blot Plus Cell Buffer Tank 170-4996 Trans-Blot Plus Cell Lid With Cables 170-4997 Gel Holder Cassette Clamps, for Trans-Blot Plus cell, set of 3 9 规格:说明:运用Mini-PROTEAN II 多道筛选仪,可以快速有效地筛选 40 种不同的抗体或血清,无需把western

转印条件可调，能在很大的分子量跨度上获得最佳转印效果*耐用的板式电极能产生强大而均一的电场，而且电极在槽内的位置灵活可换；不论运行1、2 或3 个转印夹，电极间距可调节到最小以获得最大的场强和转印效率*凝胶支架转印夹保证整个凝胶与印迹膜表面的均衡接触*转印夹的铰链设计能防止凝胶滑动，便于转印夹组装*颜色标记的转印夹及电极板确保在转印槽内的正确定向*特级冷却芯和冷却水循环器进行温度调节―可理想地用于天然酶或高强度转印，或用于延长转印时间时减少缓冲液的损耗*可选择的组装盘是凝胶三明治和转印夹组装的理想选择 Trans-Blot Plus 转印槽能从单向和双向大格式凝胶上均一、高效地转移蛋白―配合使用新推出的 PowerPac HC 电源，多数蛋白都可在1530 分钟内完成转印。

The basic concept of FOP can be summarized as to further optimize effective prescription according to the standard of curative effects and with the aid of modern science and technology and theories of traditional Chinese medicine.

其基本内涵可概括为：以确有疗效的中药复方为研究对象，以现代科学技术和传统中医药理论为技术支持，以该复方所治病证的药效响应为评价标准，以优化重组疗效更优的新复方为研究目的。

Ever since our world has been a world, native forests have been indiscriminately exploited by man.

自从我们的世界一直是世界原生森林被任意剥削人。