查询词典 abelian equation

In chapter three,we have derived a generalized dual London equation for the Abelian "electric" field A_μfrom the effective dual Abelian-Higgs model.The approximative result and the numerical simulation result as well as their figs were shown via solving the dual Abelian-Higgs model with different methods.Hereby the vortex solution of the chromo-electric field and the vortex energy density were also discussed.Finally,we have studied the dual Abelian-Higgs model with additional vacuum constant,and have unpuzzled the vacuum constant corresponding to the bag model.When the quark sources is introduced, the vacuum constant in the MIT bag model is proportional to the quartic of the monopole mass.

利用不同方法求解该方程，给出了该方程的近似结果和数值模拟结果，并分别对两种情形画出图像作了比较，据此还讨论了色电场的涡旋解及能量密度，最后讨论了含有附加真空常数的对偶阿贝尔-黑格斯模型并对应口袋模型给出了附加真空常数的物理解释，引入夸克源之后还预言麻省口袋模型中的真空常数正比于单极质量的四次方。

Arad and Blau proved that an abelian table algebra can be viewed as a group algebra of some abelian group G. Chapter 3 of this paper gives the structural theorem of abelian table algebras by defining a group structure in table basis. Furthermore, the structure of elementary abelian table algebras is discussed using the number of composition series of table algebras.

Arad和Blau证明了abel表代数等价于某个有限生成abel群G的群代数，受此启发本文第3节通过定义表基的一个群结构给出了abel表代数的结构定理，并从合成列数目的角度对初等abel表代数进行了细致刻画。

In this topic, the dynamic analysis methods for piezoelectric vibrator are studied systematically based on the theoretical model, FEM numerical experimentation and FEM governing equation for given compound-mode vibrator, and some valuable conclusions are obtained. The main work accomplished is summarized as follows: 1.Elaborate the main modeling methods for piezoelectric vibrator and the significance and necessity to study the dynamic characteristics of piezoelectric vibrator which emphasize the urgency of this paper. 2.Take the bending deformation induced by piezoelectric ceramic as example, the energy transfer mechanism of electric energy to mechanical energy are analyzed; the motion and force transfer mechanism are analyzed for the longitudinal-bending vibrator. 3.Based on mode assumption and Hamilton principle, the coupling model of piezoelectric vibrator of linear USM is built; moreover, the equivalent circuit model is obtained and a coupling equation represents the relation between electric parameters and mechanical parameters is derived which provides foundation to match the vibrator and driving circuit. 4.Combine the constitutive equation of piezoelectric ceramic with elastic-dynamical equation, geometric equation in force field and the Maxwell equation in electric field and the corresponding boundary condition equation, the FEM control equation for piezoelectric vibrator of USM to solve dynamic electro-mechanical coupling field is established by employing the principle of virtual displacement. The equation lays the foundation to study the non-linear constitutive equation of piezoelectric ceramic driven by high-power. 5.Define the dynamic indexes of characteristic of vibrator and carry out variable parameters simulation by calculating the model parameters and the electric characteristics of vibrator are simulated according to the equivalent circuit model. By numerical experimentation, the working mode of vibration of vibrator and the shock excitation results of the working frequency band which provides the mode frequency to realize bimodal are analyzed. Detailed calculation of the electro-mechanical coupling field parameters is made by programming the FEM control equation.

本课题从理论模型、有限元数值试验、有限元控制模型等方面以复合振动模式振子为例对超声电机压电振子的动力学特性及其分析方法进行了全面系统地研究，得出了许多有价值的结论，主要概括如下： 1、阐述了目前针对超声电机压电振子的主要建模方法，对压电振子动态特性的研究意义和必要性进行了论述，突出了本文研究内容的迫切性； 2、以压电陶瓷诱发弹性体发生弯曲变形为例，分析了压电陶瓷通过诱发应变来实现机电能量转换的机理；对基于纵弯模式的压电振子的运动及动力传递机理进行了分析； 3、基于模态假定，利用分析动力学的Hamilton原理，建立了面向直线超声电机压电振子的机电耦合动力学模型，并据此建立了压电振子的等效电路模型，导出了电参量与动力学特性参量的耦合方程，为压电振子与驱动电路的匹配提供了依据； 4、从压电陶瓷的本构方程出发，综合力场的弹性动力学方程、几何方程、电场的麦克斯韦方程以及相应的边界条件方程，采用虚位移原理，建立了压电振子动态问题机电耦合场求解的有限元控制方程，为研究其大功率驱动下的非线性本构模型奠定了基础； 5、界定压电振子的动力学特性指标，对压电振子的机电耦合动力学模型参数进行计算及变参数仿真；依据等效电路模型，对压电振子的电学特性进行了仿真分析；通过有限元数值实验，对压电振子工作模态附近的模态振型及工作频率附近的频段进行了激振效果分析，找出了实现模态简并的激振频率；利用有限元控制方程，通过编程计算，对压电振子的力电耦合场参数进行了详细计算，得出了一些有价值的结论。

Several important nonlinear equations of mathematical physics such as φ4 equation, Klein-Gordon equation, the approximate equations of sine-Gordon equation and sinhGordon equation, Landau-Ginzburg-Higgs equation, Duffing equation, nonlinear telegraph equation are the special cases of the nonlinear wave equation presented in this paper.

几个有重要应用的非线性数学物理方程，如矿方程，Klein-Gordon方程，Sine-Gordon方程，及Sinh-Gordon方程的近似，Landau-Ginzburg-Higgs方程，Duffing方程，非线性电报方程等都可作为该方程的特殊情形得到相应的显式精确解，这里方法也可推广到n+1维空间情形。

Establish the steady-state and transient model using the three hydrodynamics equations (Continuity equation, Momentum equation and Energy equation). By comparing different state equation, it selects the BWRS state equation which is considered the most accurate state equation in current natural gas measurement. It calculates compression factor, density and other Thermal parameters based on BWRS state equation. In Numerical solution of the steady-state and transient model, compression factor, friction coefficient and all the other Thermal parameters are recalculated in each small time step to reduce the numerical calculation error.

在稳态模型的建立上，利用流体力学三大方程(连续性方程、运动方程和能量方程)，通过比较不同的状态方程选用了目前被认为最精确的用于天然气计量的BWRS状态方程，并以此方程为基础进行压缩因子、密度等热物性参数的计算；在稳态模型的求解上，选用容易计算，精度较高的标准型龙格—库塔(Runge-Kutta)法进行数值求解，并且在迭代过程的每一小步都重新计算燃气的压缩因子，摩阻系数等所有的计算参数，以减少数值计算的误差。

Chapter 2 is devoted to study of exact solutions of the nonlinear evolution equations. Using solutions of a Bernoulli equation instead of tanh in tanh-function method we find some more general solutions of the KdV-Burgers-Kuramoto equation , and by using the nonlinear telegraph equation we show that there are many different choices on its balancing number m and the power n of the nonlinear term in Bernoulli equation by which we can recover the previously known solutions and also can derive new square root type solitary wave solutions. Exact solitary wave solutions for a surface wave equation are obtained by means of the homogeneous balance method. We also present an approach for constructing the solitary wave solutions and non-solitary wave solutions of the nonlinear evolution equations by using the homogeneous balance method directly, which is also used to find the steady state solutions, solitary wave solutions and the non-solitary wave solutions of the 2+1 dimensional dispersive long wave equations. The soliton-like solutions of the BLMP equation and the 2+1 dimensional breaking soliton equation are found by use of the symbolic-computation-based Method.

第二章中研究了非线性发展方程的精确解：用双曲正切函数法中的双曲正切函数换为Bernoulli方程的解的方法而给出KdV-Burgers-Kuramoto方程的精确解并用非线性电波方程为例说明了平衡数m和Bernoulli方程中非线性项的次数n有着多种选择的可能，它不但使我们能找到已知解而且也能找出新的根式孤立波解；用齐次平衡法给出一个曲面波方程的精确孤立波解，并提出直接用齐次平衡法寻找非线性发展方程的孤立波解、非孤立波解的方法，作为应用给出2+1维色散长波方程组等的定态解、孤立波解、非孤立波解等；用Symbolic-computation-basedMethod获得BLMP方程和2+1维破裂孤子方程的类孤子解；提出sine-Gordon型方程的直接求解方法，并获得sine-Gordon方程、双sine-Gordon方程、sinh-Gordon方程、MKdV-sine-Gordon方程和Born-Infeld方程等的精确孤立波解。

Using the main result, we also obtain a simple criterion to check if a given C(superscript *)-algebra A is Abelian, that is, A is Abelian if and only for any two positive elements a, b∈A, there is a'∈A such that ab=ba'.

利用文中的主要结论，还得到了判断C-代数A是交换一个简单条件，即A是交换的当且仅当对A中的任何两个正元a，b存在a'∈A使得ab=ba'。

Using the main result, we also obtain a simple criterion to check if a given mathrm C^*-algebra A is Abelian, that is, A is Abelian if and only for any two positive elements a, bin A, there is a'in A such that ab=ba'.

利用文中的主要结论，还得到了判断 mathrm C^*-代数 A 是交换一个简单条件，即 A 是交换的当且仅当对 A 中的任何两个正元 a， b 存在 a'in A 使得 ab=ba'。

Group is an important concept in Modem Algebra. Viewed from a different angle it may be divided into two different categories: finite group and infinite group; and Abelian group and non-Abelian group.

群是《近世代数》的一个重要概念，从不同的角度出发，群可以分为有限群和无限群两大类，又可以分为交换群和非交换群两大类。

Let G be a finite Abelian group ,an ideal in the grouping Zpr is called an Abelian code over Zpr.

设G为有限阿贝尔群，群环Zpr中的理想称为Zpr上的阿贝尔码。

The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.

论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。

I have not really liked him,I do not like his this kind of disposition.

我没有真的喜欢他，我不喜欢他的这种性格。