查询词典 abel summation method

An improved method for measurement of complex permittivity using six-port reflectometer is presented. Error caused by incomplete superposition between the measured plane and reference plane, which is often in the case of conventional measuring method, is eliminated with the developed novel algorithm by separating the two planes.

提出了六端口反射计测量介质材料复介电常数的一种改进方法，新的算法使测量面与参考面分离，消除了传统测量方法中测量面与参考面无法完全重合引入的误差。

In this paper, we study the iteration method approximating zero points of m-accretive operators in reflexive Banach space. The strong convergence of the revised method is proved. These results extend and improve corresponding results of others.

文章在自反Banach空间中研究了m-增生算子的零点迭代逼近问题，证明了修正的迭代算法强收敛到m-增生算子A的一个零点，此结果推广和改进了一些相关结论。

Finally, recommends one method to transform knowledge organization tool in the traditional library, constructs the knowledge network in order to support the method of query reformulation based on concept.

介绍了一个将传统图书馆中的知识组织工具加以改造来构造知识网络以支持基于概念的检索式扩展的方法。

Through many experiments, we find tracing without ray method can solve the problem. The method applies the refractional wave's geometric properties, and exports the velocity models.

无射线追踪法层析静校正将首波方法的稳定性和回转波方法的灵活性结合起来，隐式使用折射波的几何特性，并由此导出速度模型，达到不使用显式射线追踪法进行层析重建的目的。

On that basis,the authors used the single-factor assessment method and multi-factor assessment method(comprehensive pollution index and Nemeron pollution index)to assess the data of groundwater pollution by this refuse landfill site.

结果表明，该垃圾场对地下水的污染极其严重：综合污染指数可达到59；单项污染组分如NO2-、NH4+、COD等普遍比参照值高出几十倍，致癌物质NO2-则高出340多倍。从水质的角度看，地下水中有的污染物(NO2-、NH4+、COD)已经超出地下水Ⅲ类水质标准数十倍甚至100多倍，到了不能饮用的程度。

Standard curve ; linear regression method ; quasi-linear regression method ; function

标准曲线；直线回归法；拟线性回归法；函数

On the basis of the previous results and according to the central composite experimental design principles,the method of response surface method with 3 factors and 3 levels was adopted.then the factors influencing the technological parameters were determined by means of regression analysis.response surface and contour were finally graphed with the extraction rate as the response value.resultsthe optimum conditions of lycium barbarum polysaccharides extraction were as follows:the ratio of material to solvent of 1∶32,extraction temperature of 84℃ and extraction time of 2.3 h,one time extraction.conclusionthe yield of lycium barbarum polysaccharides is 11.10% under the optimum conditions.

方法在单因素实验基础上选取实验因素与水平，根据中心组合（box-benhnken）实验设计原理采用3因素水平的响应面分析法，依据回归分析确定各工艺条件的影响因子，以多糖提取率为响应值作响应面和等高线。结果在分析各个因素的显著性和交互作用后，得出枸杞多糖水浸提的最佳工艺条件为：料液比1∶32；浸提温度84℃；浸提时间2.3h；浸提1次。结论在最佳工艺条件下，枸杞多糖的实际提取率可达11.10%。

According to the Capital Asset Price Model, this part set up a linear regression model with a single regressor and tested the developed countries'popular method ofβcoefficient in hedge ratio. A significant fault was observed on method ofβcoefficient of a classic text book.

该部分根据资本资产定价模型，建立了一元线性回归方程，对西方流行的β系数法进行了检验，无意间发现了经典教科书的一个理论失误。

The main contents is: analyzing some detection method to moving target nowadays; particular studying the principle of detection moving target in SAR; analyzing SAR imaging theory and the echo model of moving target; discussing conventional SAR imaging , the movements of target cause the changes of doppler mass center and regulable frequency, and the changes cause effect the imaging result; introducing the estimation method of doppler parameter; analyzing theory of DPCA, derivating the formula needed, and validating it's validity and practicability through simulation; advancing the improved DPCA algorithm that combine the advantage of DPCA and ATI, and validating it through computer simulation; using the revision algorithm to range ambulate based on keystone transformation, and validating it through computer simulation; discussing the compensation art of SAR imaging.

主要内容有：分析了现有的一些动目标的检测方法；详细研究了SAR动目标检测的原理；分析了SAR成像理论和运动目标的回波模型；探讨常规SAR成像时，目标运动引起的多普勒质心和调频率变化，以及这些变化对成像结果的影响；介绍了多普勒参数的估计方法；分析了DPCA原理，推导所需要的基本公式，并仿真验证其有效性和实用性；提出了结合DPCA和ATI优点的改进DPCA算法，并仿真验证；探讨了SAR成像中的运动补偿技术。通过对仿真结果的分析，本文提出的方法具有一定的指导意义和参考价值。

A comparative study of porosity, oxide contents, bond strength and wear resistance of 3Cr13 stainless steel coatings deposited by high velocity and regular arc spray processes was carried out. An orthogonal and rotational regression experimental method and an ordinary single-factor experimental method were adopted to evaluate the coating hardness with respect to the effect of processing parameters. The quantitative formula of processing parameters with coating hardness was obtained by means of microcomputer.

摘 要：对比研究了3Cr13不锈钢高速电弧喷涂涂层和普通电弧喷涂涂层的孔隙率、氧化物含量、涂层结合强度和滑动磨损性能，并采用多因素正交旋转回归设计和单因素对比试验的方法研究了高速电弧喷涂工艺参数对3Cr13不锈钢涂层显微硬度的影响，用微机回归得到了喷涂工艺参数与涂层硬度之间的定量关系式。

The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.

论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。

I have not really liked him,I do not like his this kind of disposition.

我没有真的喜欢他，我不喜欢他的这种性格。