查询词典 a

Thuban has no real anomalies other than it's quite rare to have a giant star in the A class, A being usually reserved for main sequence and the occasional supergiant.

右枢除了是一颗罕见的A形巨星之外，没有异常的现象。A型在

In order to get a timeable test case, I concatenated 110 copies of an article I wrote to get a file a bit over 2MB, and about 41k lines and 300k words.

为了获得atimeable测试案例，I串连110份的一篇文章I写信给获得a档案a位以上2MB，约41k线和300k话。

Due to the complexity of the cell jitter, the NonSynchronous Tining Recovery methods are currently not mature With the emphasis being given to the Class A CBR traffic, this paper analyzes the performance of the queueing delay and cell jitter at the source node and intermediate nodes, and discusses the Source Timing Recovery at the destination node in ATM networks Firstly, this paper presents a description of the cell jitter of CBR traffic, and gives the definitions of two kinds of cell jitter regarding the Source Timing Recovery for CBR traffic Then, by using exact mathematical models and analysis methods, this paper analyzes the impact of the factors, such as the capacity of the queueing buffer, the randomness, the deterministic nature and the correlation in cell arrivals of the background traffic sources, on the queueing delay and cell jitter performance of the CBR traffic through Statistical Multiplexitng To obtain an insight into the power spectral distribution and look for better schemes for the depression and filtering of the cell jitter, within the analyses we succeed deriving the power spectrum of the cell jitter for CBR traffic Hence, not only the power spectral distribution of the cell jitter can in the frequency domain be qualitatively understood, but also can the rms (root-meansquare) value of the cell jitter be quantitatively obtained so as to more accurately measure the amplitude of the jitter In the end-to-end performance analysis of the queueing delay and cell jitter, we propose a kind of quasi-periodic cell stream model to characterize the jittered CBR traffic, and present an initial queueing analysis of the CBR traffic following such a model at a generic intermediate node Additionally, we briefly discuss the buildout/playout and Source Timing Recovery functions of the destination node Finally, regarding the Source Timing Recovery of CBR traffic, this paper systematically discusses several important principles of the cell jitter filtering and depression reported in the literature, introduces several implementation schemes of the Source Timing Recovery e.

由于信元抖动的复杂性，非同步定时恢复方法目前还很不成熟。本文针对A类CBR业务流在ATM网络源节点和中间节点的排队时延和信元抖动性能，以及在目的节点的源定时恢复问题作了较为全面的研究。首先，文中描述了CBR业务流的信元抖动，并具体地给出了两种与CBR业务源定时恢复有关的信元抖动的定义。然后，采用了精确的数学模型和分析方法，有针对性地分析了业务背景中信元到达的纯随机性、确定性和相关性以及排队缓存器容量等因素对CBR业务流经过统计复用后的排队时延和信元抖动性能的影响。为了了解信元抖动的功率频谱分布和寻求更好的抑制和滤除抖动的方法，在性能分析中，我们成功地完成了CBR业务流信元抖动的功率谱分析，使得不但可以从频域定性地认识信元抖动的能量分布特性，而且还可以定量地求出信元抖动的均方根值(rms：root-mean-square)，以更为准确地衡量抖动的大小。在CBR业务流的多节点端-端排队时延和信元抖动性能分析中，我们提出了一种准周期性(quasi-periodic)信元流模型来描述感染了信元抖动的CBR业务流，并基于这一模型进行了CBR业务流中间节点的初步排队分析。

The effects of solution\'s pH value, mol ratio between phenyl aldehyde and L-Arginine, concentrations of sodium chloride, ammonia chloride andL-Lystine, initial concentration of L-Arginine on precipitation rate of a -tolylene arginine were investigated, the results indicated that phenyl aldehyde precipitation method\'s appropriate pH value was higher than 11, suitable mol ratio between phenyl aldehyde and L-Arginine was 1.25, initial concentration of L-Arginine was must higher than 15g/L, sodium chloride had little effect on precipitation rate, on the contrary, ammonia chloride and L-Lystine had great effect on it, both of them must be eliminated; At the same time, adsorption isotherm at 25 C of L-Lystine on anion exchange resin A was measured, the result showed that the maximal equilibrium adsorbance was 30mg/g, the influences of solution\'s pH value, temperature, concentration of chloride ion on adsorption of L-Lystine by anion exchange resin A were also studied, the results indicated that appropriate operational pH value was 0.5 0.2, the effect of temperature on adsorption ratio was little, process could be operated at room temperature, the concentration of chloride ion must be eliminated.

考察了溶液pH值、苯甲醛与L-精氨酸摩尔比、氯化钠与氯化铵浓度、L-赖氨酸浓度、L-精氨酸初始浓度对苯甲醛沉淀L-精氨酸的影响，结果表明，沉淀反应的适宜pH值大于11，苯甲醛与L-精氨酸的适宜摩尔比为1.25，(来源：Aa6BC论文网www.abclunwen.com)L-精氨酸适宜的初始浓度在15g/L以上，氯化钠的存在对沉淀率基本上没有影响，而氯化铵和L-赖氨酸的存在使沉淀率下降；同时测定了25℃时阴离子交换树脂A吸附L-赖氨酸的吸附等温线，表明其最大平衡吸附量为30mg/g，考察了溶液pH值、温度、氯离子浓度对阴离子交换树脂A吸附脱除L-赖氨酸的影响，结果显示从L-精氨酸和L-赖氨酸混合液中吸附分离出L-赖氨酸的适宜pH值为10.5±0.2，温度对L-赖氨酸吸附率影响不大，吸附过程可在室温下进行，氯离子的存在使L-赖氨酸的吸附率降低。

The invention relates to a pipeline polyurea outer anticorrosive coating and the making method thereof, making heated prepolymerization reaction on dibenzo-methane diisocyanate, carbodiimide diisocyanate, polyether binary alcohol and polyether trihydric alcohol to prepare prepolymer solution A, and making end amino polyethylene oxide ether, dimethyl sulfur-based toluene diamine, diethyl diamine, iso-propyl titanate solution, polyacrylate, carbon black, titanium dioxide and lightweight calcium carbonate into solution B, and as using, respectively heating the solutions A and B to 65 deg.C and then mixing them, then quickly spraying and curing to form a coat.

本发明涉及一种管道用聚脲外防腐涂料及制造方法，由二苯基甲烷二异氰酸酯、碳化二亚胺化二异氰酸酯、聚醚二元醇和聚醚三元醇通过加热预聚反应制成预聚物的A液、由端氨基聚氧化乙烯醚、二甲硫基甲苯二胺、二乙基甲苯二胺、钛酸异丙酯溶液、聚丙烯酸酯溶液、碳黑、钛白粉和轻质碳酸钙配制而成的B液组成，使用时将A液和B液分别加热至65℃后混合，然后快速喷涂固化形成涂层。

At present,the total capacity of trimellitic anhydride in the world is about 230,000t/a, with output of 165,000 t/a and total consumption about

目前世界偏苯三酸酐的总生产能力约为 2 3 0万t/a ，产量约为 16 5万t/a ，消费量约为 16 0万t/a。

A isotherm of a monolayer at air-water interface for a quaternary ammonium salt type trimeric surfactant (shortly called 12-2-12-2-12) was investigated by the Langmuir balance technology. The surface tension at collapse pressure,γ, and the molecular limited area, A, were determined and compared with the surface tension of the surfactant solution at CMC concentration,γ.

利用Langmuir膜天平研究了季铵盐三聚表面活性剂12-2-12-2-12在空气－水界面单分子膜的表面压－分子面积等温线，得到它的崩溃压对应的表面张力γ(下标 collapse)和分子极限面积A。

The inner reorganization energy and the exothermicity of the reaction are then determined. Closed shell HF SCF calculations have been carried out for the systems Tryptophy1-Tyrosine and Tyrosyl-Tryptophan for different values of R, and the Koopmans^,theorem is invoked to estimate the energy level splitting A.From the obtained A~m~i~n, the values of electron transfer matrix element V~D~A are determined to be 0.96kJ. mol^-^1 and 0.87kJ.mol^-^1 for Tryptophyl-Tyrosine and Tyrosyl- Tryptophan, respectively.

对色氨酰酪氨酸和酪氨酰色氨酸体系进行闭壳层HF自洽场计算，按Koopmans定理计算体系分子轨道分裂能值A，在R约为0处发现了A的极小值，从而获得色氨酰酪氨酸及酪氨酰色氨酸体系分子内电子转移的电子转移矩阵元V~D~A分别为0.96kJ.mol^-^1和0.87kJ.mol^-^1。

Athena's name is possibly of Lydian origin.It may be a compound word derived in part from Tyrrhenian "ati", meaning "mother" and the hame of the Hurrian Goddess "Hannahannah" shortened in various places to "Ana". In Mycenaean Greek, She possibly appears in a single inscription in the Linear B tablets: A-ta-na-po-ti-ni-ja /Athana potniya/ appears on a text from the Late Minoan II-era "Room of the Chariot Tablets" in Knossos, the earliest Linear B archive anywhere.

雅典娜这个名字可能起源于利底亚，它是由第勒尼安语中的&ati&和胡里安人的女神&Hannahannah&名字的简化&Ana&拼合而成，在迈锡尼文明时期，起源于米诺斯王朝后期，位于科诺索斯的&战车铭文之室&的一则铭文中，雅典娜也许是以&A-ta-na-po-ti-ni-ja /Athana potniya&这个名字出现的。

Results L* in pat of opaque and body become decrease and a*,b* become increase generally with the increase of each group of color guide stage,then a*、b* of incisor translucent and cervical increase tendency unapparently.

结果 随着A、B、C、D各组比色板色阶的增大，不透明瓷、牙本质瓷的L*值呈递减趋势，a*、b*值呈递增趋势，但是颈部瓷、透明瓷的a*、b*值的递增趋势变化不明显。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。