查询词典 a load carried by a pack-animal

C. Load Modelling and Allocation Function The load modelling and allocation function adjusts the load values at network load points to match the actual measuredloads recorded at the feeder head of the feeding substation.

C。 负荷 Modelling 和配置功能负荷 modelling 和配置功能调整负荷价值在网络负荷指出相配在逐渐强烈的分局饲养者头被记录的真实 measuredloads 。

Load resistance can adjust the size of load resistance by adjusting the tightness of friction belt of the tensioning adjustment device,Load resistance value can display directly through the load device.

套在阻力轮上的摩擦带与阻力轮产生摩擦形成负荷阻力，负荷阻力可以通过张紧调节装置调节摩擦带的松紧度来调节负荷阻力的大小，负荷阻力值又可以通过负荷指示装置显示出来。

The results of its 1D test demonstrate that the MARED code is suitable for simulating implosions on different devices and with a wide range of load parameters. Combination of the wire-array Z-pinch experiment simulation and analysis shows that under the same load conditions, the X-ray radiation power produced by the tungsten wire-array implosion is much greater than the power generated by the aluminum wire array. With the same load current, the greater load mass gains the lower X-ray power.

结合丝阵Z箍缩实验的数值模拟和分析表明：相同负载质量条件下，钨丝阵内爆产生的X光辐射功率远大于铝丝阵产生的X光功率；相同负载电流条件下，负载质量越大，计算得到X光功率越低；X光功率随着负载电流增加而增加。

For the condition where both outlet states of cold plate are at superheated states, the mass flowrate for the fixed heating load is marginally higher than that of the smaller heating load, and the difference is insensitive to the rise of heating load. For this situation, the effect of accelerational pressure is negligible, and it is mainly attributed to two-phase/single-phase distribution pertaining to the effect of heating load.

若两冷板的出口均为过热状态下，固定热负载一端的流量会略多於施加瓦数较高的一端，且其差异量会随热负载不同而缓慢增加，在此一状况下，则加速度压降可以忽略不计，其原因在於单相／两相流在热负载下单相区与两相区所占的比重不同所致。

First, CLBAC, a central load balance mechanism based on AC is proposed in this paper to increase security. Second, a distributed load balance mechanism is proposed. In DLB, each user can pre-estimate the actual load of each cell by means of virtual distributed coordination function, and then access the cell whose load is the lightest.

本文首先提出基于接入控制器的集中式负载均衡策略以提高网络安全性，然后提出分布式负载均衡策略：各用户在接入网络的时侯，首先采用虚拟的分布式协调功能预测各小区的实时负载，然后接入负载最轻的小区。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 4 4.2 7.6 0.13 0.8 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR...Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 2 1.5 2.9 0.045 0.47 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR...

载荷钢球圈列数 DN值预压预压方法导轨型号 3列 1.00圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 EK4， FK4 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性无单一螺帽右螺纹无 35.0 螺纹条数防尘措施防尘罩形式 W清洁环与QZ润滑装置配用 1 无。。。

As to load model, it contains unbalance dynamic load, wheel flaw, abrasive load and rail gap exciting load.

在车辆的响应分析中，对于载荷模型可以分为：动不平衡载荷；轮缺陷及其擦伤载荷以及直轨道轨缝、接头处引起的激振载荷。

Self-balanced loading test is a static load test method, in which load cell is embedded in the pile exerts load. Double load cell technique refers to meeting different designing needs.

摘要］自平衡试桩法是通过埋置于桩身中的荷载箱施加荷载的一种新型静载试验方法。

This design after determination frame layout, has carried on the level first the load generation of tabular value computation, extracts the wind load with the D value law the function, then uses the bending moment two methods of distribution to calculate the vertical load under the function structure endogenic force, and discovers most disadvantageous group of or a several group of endogenic force combination.

本设计在确定框架布局之后，先进行了层间荷载代表值的计算，用D值法求出风荷载的作用，接着用弯矩二次分配法计算出竖向荷载作用下的结构内力，并找出最不利的一组或几组内力组合。

This design after determining the frame layout, has carried on the level the first load generation of tabular value computation, extracts the wind load with the D value law the function, then uses the bending moment two methods of distribution to calculate the vertical load under the function structure endogenic force, and discovers most disadvantageous group or a several group of endogenic force combination.

本设计在确定框架布局之后，先进行了层间荷载代表值的计算，用D值法求出风荷载的作用，接着用弯矩二次分配法计算出竖向荷载作用下的结构内力，并找出最不利的一组或几组内力组合。

But this is impossible, as long as it is engaging in a market economy, there are risks in any operation.

但是，这是不可能的，只要是搞市场经济，是有风险的任何行动。

We're on the same wavelength.

我们是同道中人。