查询词典 a block of

During building the 3D mode, I use the concepts of point, triangle, plane and block, that is from point to triangle to stratum surface or fault to closed block, and finally all the closed block will form a 3D model. Especially the auto-adaption triangle grid method for interface fitting and the 3D visualization technique for building 3D model are the feature of our method.

在三维建模中，引用点、三角形、面、块的概念，即由点形成三角形面，由三角形面形成地层面或断层面，再由面围成封闭的块，所有块构建成三维模型；其中提出了自适应界面拟合三角形网格方法及用于三维模型建立的三维可视化技术等。

After wavelet transform and quantification, a prediction module is introduced to estimate the entropy of EBCOT code block within available bit plane, then using the summation estimate entropy of each code block to allocate the rate for each code block. T2 encoder sends feedback to control the coding depth by the pre-allocation bit rate and complete the rate-distortion optimization truncation.

算法引入了预测模板，对图像小波变换和量化后EBCOT编码码块的有效比特平面进行独立的熵估计，并以码块估计熵总和指导码率预分配，同时T2编码器由预分配编码比特率自适应地反馈控制编码深度、完成优化截取。

The iris radius of 60 (93 eye) patients with early pupillary block primary angle closure glaucoma was measured with this method, it showed:(1) there was a statistically significant difference in iris radius between the patients with early stage primary pupillary block angle closure glaucoma and the normal subjucts (53 cases 106 eye) with the age matched group (P.01),(2) it is proved with the stepwise discriminatory analysis that the iris radius-the most significant bio-anatomic parameter of the anterior segment is usefull to diagnose early primary pupillary block angle closure glaucoma by stepwise discriminatory analysis.

本研究用此测量法测量了60例93只眼早期原发性瞳孔阻滞性闭角型青光眼的虹膜曲率半径，发现：（1）早期原发性瞳孔阻滞性闭角型青光眼患者的虹膜曲率半径小于同年龄正常人（53例106眼）的虹膜曲率半径，其差异具有显著性统计学意义（P.01）；（2）经多因素逐步判别分析证明本研究所提出的活体眼前节解剖学测量参数——虹膜曲率半径有助于原发性瞳孔阻滞性闭角型青光眼早期诊断。

At last the mould was designed by the antitype of some kind of notepad. The study of the technology parameters such as drawing temperature , drawing speed , block holder pressure , lubricate condition showed that when the mould clearance was 1.6mm, drawing temperature was 220~280℃, the block holder clearance was 1.16, the block holder pressure was 2 ton we can formed a qualified notepad shell of the fillet radius of 2.4mm.

最后，以某型号笔记本电脑外壳为原型，自行设计、加工了笔记本电脑外壳热拉深模具，对其拉深温度、拉深速度、压边力、润滑条件等拉深工艺参数研究表明，当模具间隙为1.6mm，拉深温度为220～280℃，压边间隙为1.16，采用石墨+机油润滑时，可获得最小圆角半径为2.4mm的笔记本电脑外壳拉深件，所得拉深件贴模性良好、回弹小，达到了设计要求。

Combined the geological analysis with analogue modeling experiments,the evolution of the Yinggehai basin could be divided into four main stages:(1) Before 42Ma,controlled by the southeastward extension of the Beibu Gulf basin on the northern continental margin,the Yinggehai basin experienced dextral pull-apart.Bounded by NS-trending Yingxi fault,the transtensional areas mainly are the northwest part and along the eastern boundary of the basin.(2) From 42 to 21Ma,the development of the main rift body in Yinggehai basin was mainly controlled by the southward slip and clockwise rotation of the Indochina block along the Red River fault zone,and the sedimentation was strengthened due to the sinistral transtension.In the east,the subsidence is deepened due to the dextral transtension.(3) From 21 to 10.4Ma,the sinistral movement of the Indochina block slowed down to still.From 21 to 15.5Ma,the northwest part of the basin began to inverse locally because of post-rift thermal subsidence of the whole basin.(4) From 10.4Ma to present,the basin was affected by the dextral movement of the South China block along the Red River fault zone and thermal accident in a new phase at 5Ma.

结合地质分析和物理模拟实验，莺歌海盆地的演化大致可以分为以下4个主要阶段：早期(42 Ma以前)主要受到南海北部陆缘裂解造成的右旋转换伸展作用的影响，但影响范围较小，主要为莺歌海盆地西北部和东部边界。42～21 Ma期间，主要受控于印支地块左行走滑和顺时针旋转作用的影响，莺歌海盆地在此期间发育了主体裂陷体系，东侧受到右旋转换伸展应力场的叠加影响而导致沉降加强；21～10.4 Ma期间，受印支地块逐渐减弱直至停止的左行走滑作用的影响，盆地西北部在21～15.5 Ma期间发生局部反转褶皱，但盆地整体进入以热沉降为主的时期；10.4 Ma以后，盆地受华南地块沿红河断裂右旋走滑作用和5 Ma以后新一期热事件的影响。

The upper movable stand that is fixedly connected with the glide cushion block is glidingly connected with the lower movable stand. The rope adjusting cylinder that is connected with the gliding cushion block is fixedly connected with the lower movable stand. A load transducer is fixedly arranged at the connecting part of the glide cushion block and the connecting rod of the rope adjusting cylinder.

上移动架与下移动架滑动连接，上移动架与滑动垫块固定连接，调绳油缸与下移动架固定连接，该调绳油缸与滑动垫块接触连接，在滑动垫块与调绳油缸连杆的连接处固定连接载荷传感器。

In trial 2, according to the similarity of calving date and milk yields, 25 primiparous Holstein cows were divided into five equal groups in a randomized block design with 49 days period. The general diet of dairy farm was fed to cows of control. The alfalfa block 2.7kgd^(-1 was substituted respectively by rice straw block Ⅰ,Ⅱ,Ⅲ or Ⅳ as treatments.

试验2，选取25头初产荷斯坦泌乳母牛采用随机区组设计按产犊日期、产奶量一致原则等分为5组，对照组用奶牛场常规日粮饲喂，试验Ⅰ、Ⅱ、Ⅲ、Ⅳ组分别用稻草块Ⅰ、Ⅱ、Ⅲ、Ⅳ等量替代苜蓿草块，每头替代量为2.7kgd^(-1)，试验期49d。

We're going to fault-failure analysis of the phenomenon, advice and information on parts of drawings, by fax Muller Martini, in line with company maintenance engineer Muller Martini is the second reasons and maintenance advice: first, check book block fixture tension of main spring length is 127mm; second, the book block fixture of the regulation to make the connection to the book block fixture of the chain and connect the main motor gear respectively correspond to a single yellow line is consistent with the relative distance between.

我们将故障产生的现象、故障的分析意见及有关零部件的图纸，通过传真发给马天尼公司方面，马天尼公司维修工程师一致认定是第二种原因所致，并提出了维修意见：第一，检查保持书芯夹具张力的主弹簧长度是否为127mm；第二，书芯夹具初始位置的调节要使连接书芯夹具的链条与连接主马达的齿轮上各自相对应的一根黄线之间的相对距离一致。

Modal analysis on engine block combination structure of a piston engine;2. Research and Optimized Desegn The Structure of The 492QBZL Diesel Engine Block;3. Study on coupling dynamics of compressor crankshaft block

在表格中单击右键，然后在子菜单中不选Show Prefered Only可以显示所有的加工参数，如落刀点的设置，螺旋下刀的角度等。

Based on these, an improving μ-synthesis is presented, with which the high-purity distillation is designed well. 2. The robust performance problem of MIMO plant is explained with the plant direction angle, which shows that the robust performance varies with different input uncertainties and the μ-synthesis should be applied correctly according to the uncertainty structure. 3. Condition number and bandwidth are the important items for robust performance design in MIMO system. The H〓 two-block problems can not deal with the robust performance design of MIMO system because of the condition number cancellation. A general μ-synthesis procedure for MIMO system with uncertainties is presented. 4. For the SISO system, the object function in robust performance is amplified by at most 〓 than that of H〓 two-block problems in value: So the robust performance of SISO system can be done with the H〓 two-block problems to avoid the complicated μ-synthesis procedure. 5. All the conclusions and methods presented in this paper are demonstrated by some typical design examples.

从而形成一种改进的μ综合方去，并对精馏塔病态对象进行了鲁棒性能设计，得到令人满意的结果；（2）利用对象的方向角解释了MIMO对象鲁棒性能设计出现问题的原因，并提出不同输入摄动形式下系统的鲁棒性能问题也并不相同，因此利用μ综合处理鲁棒性能设计时，应根据不同的摄动情况采用不同的结构进行设计：（3）条件数问题和带宽问题是MIMO系统鲁棒性能设计的两个主要问题，指出由于条件数对消的存在使得一般H〓两块问题无法处理MIMO系统的鲁棒性能设计，而μ综合方法则是处理MIMO系统鲁棒性能设计的有效方法，并给出了其处理MIMO系统鲁棒性能设计的一般性方法；（4）提出对于SISO系统H〓两块问题（S/T问题、S/KS问题）的设计指标函数与鲁棒性能设计的μ指标函数在数值上最大差〓倍，因此对于一般SISO系统的鲁棒性能设计可以简单地用一般的H〓的两块问题处理，而避免μ综合设计的复杂过程；（5）本文中提出的结论和算法都利用H〓/μ发展中的典型例子：Doyle-Stein问题，Safonov的战斗机模型，精馏塔对象等进行了设计验证。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。