查询词典 Young modulus

The effect of microstructure evolution on the tensile strength and Young's modulus was investigated.

采用冷拉拔制备了Cu-6%Ag及Cu-12%Ag纤维相复合强化合金线材，研究了组织纤维化对Cu-Ag合金强度与弹性模量的影响。

The experimental results also show that Young's modulus in the thickness direction of woven hybrid material is also strain rate dependent.

实验结果还表明，编织状混杂复合材料层合板沿厚度方向的弹性模量也是应变率相关的。

The theory and method of bending test on nanobeam for the measurement of Young′s modulus based on atomic force microscope are introduced.

阐述了基于原子力显微镜的弯曲测试测量纳米梁杨氏模量的理论和方法。

Through mechanical analysis, a formula was derived to calculate the Young's modulus of zona pellucida from measurements.

通过力学分析，推导出一个近似计算杨氏模量的实验公式。

The variable Young's modulus which changes with time and reproduced objective stress of concrete are considered in the mechanical mode.

在应力场的有限元模拟中，混凝土的弹性模量随着水化度或时间而变化，有效地模拟了混凝土真实的应力场。

Finally, an example of the cantilever beam is used to illustrate the feasibility of the method given, which shows that the effect of the elastic Young's modulus on the eigenvalues is greater than that of the mass density.

通过一个悬臂梁的算例表明，弹性模量对振动控制闭环特征值的影响要大于质量密度的作用，表明了文中方法的可行性。

The mechanical and calorifics properties of composites rise with the increase of SWNTs concentration,composites showed higher mechanical properties such as Young's modulus,tensile strength and elongation along the stretched direction than perpendicular to it.

对复合材料进行了力学性能测试，随着碳纳米管含量的增加，复合材料的弹性模量、拉伸强度和延伸率均得到明显提高，并表现出明显的各向异性。TGA分析表明SWNTs的加入明显提高了复合材料的热稳定性。

The above-mentioned T8 glass-ceramic showed only 25 % decrease in IR transmittance, 17 % increase in hardness, 61 increase in dilatometric softening point, and 19 % increase in Young s modulus.

上述试片之IR穿透率与T8起始玻璃比较，仅下降了25 %，但硬度上升了17%；与未添加成核剂的玻璃比较，膨胀仪软化点上升约61℃，杨氏系数上升约19 %。

The biomechanical tests showed that two kinds of artificial bones had not significant difference on compressive strength and Young\'s modulus(P＞0.05),while the flexural strength of nano-nacre artificial bone was less than the control group(P＜0.05).3.The results of CCK-8 showed that the difference were not significant in each group,the proliferation of osteoblast reached the peak at the 5th day;7 days after being co-cultured,the total protein content of study group was higher than control group and blank group(P＜0.05),while the difference between control group and blank group was not significantP＞0.05The difference of alkaline phosphatase activities among three groups was not significant(P＞0.05The SEM view showed that osteoblast attached and grew well in two kinds of artificial bone.4.X-ray photography showed that two kinds of powder started to degrade in 2 weeks;this phenomenon became more appear in 4 weeks,nano-nacre powder degraded faster than micron-nacre powder,while the hole shadow was easy to be found;in 8 weeks,all the femoral holes recovered and returned to normal bone mineral density in all groups.Analysis of tetracycline fluorescent double marks in the hard tissue grinding slices indicated that new bone grew fastest around the bone defect area in study group,while most slowly in blank groupP＜0.05 SEM(scanning electron microscope observation showed that nano-nacre powder degraded more quickly.The same result can be found through the demineralized sections morphometric analysis,and both of the composite artificial bones made from those two kinds of nacre powder had the good connection with the adjacent tissue in rats body without apparent inflammatory response.5.X-ray photography showed that rabbit\'s bone defects healed faster in study group since NNAB implanted than in control group since MNAB implanted.At 24 weeks after operation,bone density in radial defects had nearly accessed to the normal area,while lower in control group,and turned up nonunion in blank group;The checking of BMD showed that results in study group were higher than those in control group at 8,16 and 24 week(P＜0.05), and the difference between the BMD values in study group at 24 week and those in blank group was not significant(P＞0.05).The gross specimens showed satisfactory histocompatibility both in study group and in control group,with bone tissue growing from two sides into the center of implanted materials; Normal slices in HE stain and hard tissue grinding slices in Stevenel\'s blue/Van Geison\'s picro-fuchsin stain showed that the bone growth tendency was better in study group than that in control group,and the medullary cavity had been penetrated to the implanted materials in study group at 24 week;Analysis of tetracycline fluorescent double marks in the hard tissue grinding slices indicated that new bone in both groups grew fastest 8 weeks after surgery,while slow down at 16 week.

纳米珍珠层/消旋聚乳酸复合人工骨与微米珍珠层/消旋聚乳酸复合人工骨分别与成骨细胞共培养后，其各时间点CCK-8法检测值与空白对照无显著差异(P＞0.05)，成骨细胞均在第5天达到增殖高峰期；培养7天后，实验组细胞蛋白含量高于对照组及空白组(P＜0.05)，后两者之间则无显著差异P＞0.05碱性磷酸酶活性在三组间均无显著差异(P＞0.05电镜下可见成骨细胞在两种人工骨上都有良好生长贴附能力。4.X-ray显示两种粉体在大鼠股骨骨洞植入第2周时都开始出现了降解，第4周时更为明显，纳米珍珠层粉较之微米珍珠层粉降解更快，而空白对照组骨洞阴影仍可见，至8周时，则所有组骨洞均己闭合修复，X-ray下已不可见原钻孔痕迹，恢复正常骨质密度；硬组织磨片四环素荧光双标记结果显示纳米珍珠层粉植入组较其余两组在骨缺损区周围新骨生长速度更快，空白组速度最慢P＜0.05电镜观察及常规脱钙切片亦可见到纳米粉体降解较快；由以上两种原材料制得的纳米珍珠层/消旋聚乳酸复合人工骨与微米珍珠层/消旋聚乳酸复合人工骨在大鼠体内均与周围组织结合良好，无明显炎症反应。5.X-ray显示纳米珍珠层/消旋聚乳酸复合人工骨植入兔桡骨缺损区后其骨愈合速度较对照组微米珍珠层/消旋聚乳酸复合人工骨植入的快，至植入术后24周，实验组骨缺损区接近正常骨密度，对照组骨缺损区密度较低，空白组则呈现骨不连状态；骨密度测量结果显示术后8周、16周、24周实验组的骨密度值高于对照组(P＜0.05，24周实验组的骨密度值与术前所测得的正常值无显著性差异P＞0.05动物取材大体所见均显示组织相容性良好，骨组织逐渐由植入材料两端向中央生长；常规切片HE染色及硬组织磨片Stevenel\'s blue/Van Geison\'s picro-fuchsin联合染色均可见实验组骨缺损区长势优于对照组，至术后24周，实验组骨髓腔与材料已呈相交通状；硬组织磨片荧光显微镜下观察，两组材料在术后8周处于骨生长最快速时期，16周时速度开始减慢，术后4、8、16周时实验组的新骨生长速度均较对照组的快

Result The flexibility of the scaffold material was powerful. The load-elongation curve of the mechanical testing was similar to that of ACL, the maximum load, the ultimate stress and the Young's modulus of the scaffold materials were 52.61 N, 14.96 MPa and 202.08 MPa respectively. Human ACL cells displayed the representative characteristercs of the ligamentous fibroblasts, and synthesized extracellular matrix, such as type Ⅰand Ⅲ collagen protein. The scaffold materials had no cytotoxicity. Human ACL cells adhered, grew and proliferated well both on the surface and in the holes of the scaffold materials.

结果］韧带支架材料的柔韧性强，拉力测试的负荷－拉伸曲线与韧带的拉伸曲线相似，其最大负荷、极限应力和弹性模量分别为52.61N、14.96MPa和202.08MPa；体外分离培养的人前交叉韧带细胞呈典型的成纤维细胞特征，能在体外分泌Ⅰ、Ⅲ型胶原等细胞外基质；支架材料无细胞毒性，人前交叉韧带细胞可在支架材料上黏附、生长并分泌细胞外基质。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。