查询词典 Young modulus

Results show that when improving spot pitch in weld bonded joints with high elastic modulus adhesives, stresses in weld spot zone are decreased while stresses and strains at edges of overlap region are increased slightly. For the joints with low elastic modulus adhesives, both stress concentration degree at the weld spot and the shear strain at edges of overlap region are increased with the spot pitch increasing.

结果表明，高弹性模量胶粘剂胶焊接头中，增大焊点间距，焊点区应力减小而搭接区边缘胶层中的应力应变略有增大；低弹性模量胶粘剂胶焊接头中，焊点处应力集中程度和搭接区边缘胶层中的剪应变值都随焊点间距的增加而增大，增加焊点间距，两种接头的胶层断裂强度都将降低。

With analysing the the fatigue mechanism, the general mode of interply fatigue damage propagation is denoted by delamination length and crack density. Based on the power-law, the relationship between number of cycles and delamination length and crack density are established. The specimen is modeled as an equivalent six-ply material system. Starting with the analysis of interply stress, the interply shear stress under cyclic loading is calculated by using nonlinear three-demension FEA. According to the stage regularity of fatigue damage propagation, such models as average strain, effective modulus, ratio of delamination length and crack density, experimental relationship between crack density and effective modulus, are proposed by introducing subsection coefficient.

通过对疲劳机理的分析，确定了以脱层长度和裂纹密度表示的层间疲劳损伤演化的一般模式，利用指数法则建立了脱层长度和裂纹密度随疲劳循环周次变化的关系；从层间应力分析入手，以等效六层的材料模型对循环载荷下的层间剪切应力进行了三维非线性有限元分析；根据疲劳损伤扩展的阶段性，引入分段系数，分别建立了平均应变与载荷循环周次的分段线性模拟模型、有效刚度随载荷循环周次的变化关系模型、裂纹密度变化和脱层长度变化关系随载荷循环周次变化的分段线性模型以及疲劳裂纹密度和有效刚度关系的经验模型。

Usually, maximum shear modulus is determined by strain method in laboratory, rather than by shear velocity method in-situ,and based on it,shear modulus ratio and damping ratio of soil can be provided.

最大剪切模量是影响土的动剪切模量比、阻尼比和土层地震反应的最重要参数之一。

First, based on the relations of stress and strain between the whole medium and its macroscopically isotropic constituents, an explicit relation between elastic matrices of the whole medium and its constituents was derived. Combining the explicit relation of elastic matrices with the strain's relation, two coefficient tensors were defined and analyzed to get a general relation between the hulk and shear modulus of the whole medium under the assumption that all the field variables are in a unified coordinate system. Secondly, combining these relations with the classical Hashin-Shtrikman elastic modulus bounds, four new expressions of elastic medium of the whole medium were obtained and compared with the original hounds. Last, these formulae were applied in the computation of effective elastic moduli of clean sandstone saturated with pore water.

首先基于整体介质与宏观各向同性组分满足的应力和应变组分关系，推导出整体介质弹性矩阵与组分弹性矩阵之间的显式关系，联合其应变关系，定义和分析了对应的两个系数张童，并据此导出了相关场变量位于统一坐标系时整体介质体积模量与剪切模量的关系；然后将经典的Hashin-Shtrikman弹性模量边界模型与上述关系式结合，得到4个新的整体介质弹性模量的估算公式，再与原始的Hashin-Shtrikman弹性模量边界进行了比较，最后针对饱和水纯净砂岩介质进行了试算。

Its main mechanism of action is that XLGB could enhance the biomechanics response accommodate function of macrostructure os integumentale, increase femoral diameter, aggrandize area of the bone cortex, augment torsional section modulus and rectangular section modulus, and enhance the density of bone mineral substance in ovariectomized rats.

仙灵骨葆能够提高股骨宏观结构的生物力学应答调节功能，使股骨干外径增粗，皮质骨面积增加，骨丢失减少使股骨结构的抗弯、抗扭截面模数增大，使骨的力学结构优化，骨强度提高。

Single factor experiments were done with the factors including the width of protrusion and the trolley's velocity, which showed that the surface frictional coefficient decreases with the width of protrusion increasing, and doesn't change with the trolley's velocity changing, which was consistent with the results of the orthogonal experiment. A theoretical model of the horizontal projection of a corrugated bionic surface's contact area was built, which showed that the contact area's horizontal projection decreases with width and interval increasing respectively and that the ratio of the contact area's horizontal projection and the vertical load decreases with the vertical load increasing. It indicated that the surface frictional coefficient decreases with the above three factors increasing respectively. Finite element modeling and analysis of interactions of a plate and soils was done using ANSYS, which showed that the plate frictional coefficient is little relative to soil elastic modulus and decreases with vertical surface pressure and that trolley's pull and vertical displacement of bionic surface's control pilot keep constant almost during the plate being pulled. Finite element modeling and analysis of interactions of a corrugated bionic surface and soils was done using ANSYS, which showed that surface frictional coefficient is little relative to soil elastic modulus and decreases with bionic surface's structural parameters and vertical pressure increasing. However, the three factors all didn't affect the surface frictional coefficient remarkably on the condition of 90% dependability. For the first time, bionic surfaces were applied to screw piles, which formed bionic screw piles, and the contrast experiments showed the bionic screw pile had certain resistance-decreasing effects.

建立了波纹型仿生曲面与土壤的接触面积的水平投影的理论模型，表明接触面积的水平投影A随着波纹型仿生曲面突起宽度、两相邻突起间距的增大而减小，接触面积的水平投影与波纹型仿生曲面表面垂直载荷之比随着波纹型仿生曲面表面垂直载荷的增大而减小，进而得出仿生曲面摩擦系数随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小；利用ANSYS软件对平板与土壤的相互作用进行了有限元建模与分析，表明平板摩擦系数与土壤弹性模量关系不大，而随着表面垂直载荷的增大而减小；平板牵引过程中台车牵引力和仿生曲面控制节点垂直方向位移基本保持不变；利用ANSYS软件对波纹型仿生曲面与土壤的相互作用进行了有限元建模与分析，表明波纹型仿生曲面系数在一定范围内基本不受土壤弹性模量的影响，随着波纹型仿生曲面突起宽度、两相邻突起间距以及表面垂直载荷的增大而减小，但在可信度为90％的前提下，三个因素影响都不显著；首次将波纹型仿生曲面应用于与土壤作用方式以挤压为主的螺旋桩，形成仿生螺旋桩，并与普通螺旋桩进行了沉桩对比试验，表明波纹型仿生曲面应用于螺旋桩桩体表面具有明显的降阻作用。

Due to different properties of the signal and noise in wave-let coefficient modulus under different scale of wavelet transformation, we can extract the edge characteristic through detecting the local maximum of the wavelet transformation coefficient modulus.

基于信号与噪声在不同尺度下小波系数模的变化特征，可以通过检测小波变换系数模局部极大值来提取图像的边缘特征。

Audio denoising is the pre-step in the audio processing,and wavelet domain denoising has been a main research area.In order to give people a summary knowledge of wavelet domain audio denoising,based on many literatures,this paper attempts to make a survey of wavelet domain audio denoising.First,it introduces wavelet transformation and the characteristics,and gives the optimal selecting and dealing criterion of wavelet domain denoising,the basis wavelet selection.Second,describes five classical methods of audio denoising,for example,threshold,multi-wavelet,wavelet packet,modulus maximum and scale correlation,then introduces their development.Third,introduces a new algorithm based on modulus maximum and scale trading theory.At the end,the future trend of wavelet domain audio denoising is pointed out.

音频降噪是音频处理前期的必要步骤，小波域降噪是其中一个重要的研究方向，为了使人们对小波域音频降噪有概括了解，在对小波域音频降噪相关文献进行分析和理解的前提下，首先介绍了小波变换及其特性，同时阐述了小波降噪的最优选取和处理准则，及对音频进行小波变换时小波基的选取原则；然后评述了用于音频降噪的阈值，多小波、小波包、模极大值和尺度相关法等5类方法及各自的发展；接着介绍在前人基础上，提出新的基于模极大值和尺度理论的降噪算法；最后探讨了小波域音频降噪的发展方向。

Following conclusions stand as long as the condition above is true 1,Cosmological redshift Hubble constant is a sort of presentation of information modulus of the universe , it is derived from total numbers of completable space time the universe has so far which is called information modulus of the universe.

在本文假定条件成立下有： 1，宇宙学红移哈勃常数是宇宙信息模的另外一种表现形式，是宇宙已经生成的完备时空的数量的一种反映。

Except cellulose acetate fiber,the strength of other four-kind fibers in completely dry state is decreased notably after MHT.With the initial moisture regain increased,the breaking elongations of cotton,rayon and loycell are improved remarkably after MHT.The increasing level is rayon＞loycell＞cotton,but ramie seems little improved.As the moisture regain is low,the fiber initial modulus is enhanced.However,when the moisture regain is higher,the fiber initial modulus did not change obviously.

除了醋酸纤维素纤维，其余四种纤维在初始回潮率为0的时候，经过微波处理，纤维强度都是显著性下降的：随着初始回潮率的增大，棉纤维、粘胶、天丝的断裂伸长率有了显著性的提高，其中升高的幅度为粘胶＞天丝＞棉纤维，苎麻没有显著性提高；在回潮率较小的范围内，微波处理之后纤维的初始模量是增大的，随着回潮率的增大，初始模量变化不显著。

Article 144 The Government of the Hong Kong Special Administrative Region shall maintain the policy previously practised in Hong Kong in respect of subventions for non-governmental organizations in fields such as education, medicine and health, culture, art, recreation, sports, social welfare and social

第一百四十四条香港特别行政区政府保持原在香港实行的对教育、医疗卫生、文化、艺术、康乐、体育、社会福利、社会工作等方面的民间团体机构的资助政策。原在香港各资助机构任职的人员均可根据原有制度继续受聘。

Small wonder, then, that the Chinese spend more in the shop than any other group of foreign visitors do .

这样的小惊喜，使中国顾客比任何国家的人消费得更多。