查询词典 Young modulus

The paper takes Breakingfruit Chinkapin fibre and other wood fiber compound manufacturing MDF's Processing-parameter for research object. Use the diagonal intersection trial law designing the trial scheme. The focal point is studied the major Processing-parameter of Breakingfruit Chinkapin with other woods to manufacture MDF. And internal bond strength, modulus of rupture, modulus of elasticity, formaldehyde emission content, thickness expansion rate of water absorbing and density of MDF are analysed. From Variance, Range and other methods seek the better Processing-parameter.

本文以黎蒴栲材热磨纤维与其他树种热磨纤维复合制造MDF工艺为研究对象，采用正交试验法设计试验方案，并根据国家标准规定的测试方法对压制成的MDF的内结合强度、静曲强度、静曲弹性模量、甲醛释放量、吸水厚度膨胀率等多项性能进行分析，利用方差、极差等分析手段寻找合理的制造工艺参数。

The digital simulation of thedynamic processes under step load input and supply oil pressure fluctuation were carried on by MATLAB. Analysis of the dynamic characteristics was done with the changes of the supply pressure, load, structural parameters of spherical hydrostatic bearing and the effective bulk modulus of oil. The conclusions show that structural parameters of the spherical bearing and the effect bulk modulus of oil have significant influence to dynamic characteristics, but the elasticity deformation of interior supporting collet has very small influences on the output response characteristics of the suspension system. The collets deformation can be neglected on the project.

在此基础上，建立了考虑内支撑筒的弹性变形与否时悬浮系统的数学模型，同时，建立了线性化的仿真模型，利用MATLAB对阶跃负载输入和油源压力脉动输入下的系统进行动态过程的数值仿真，结果表明球面副的结构参数，油液的有效体积弹性模数对系统的响应特性有明显的影响，而内支撑筒的弹性变形对悬浮系统的响应特性的影响很小，在工程上可以忽略其弹性变形。

The Hilbert modulus is defined as the sum of the square of a signal and its conjugation.Hilbert modulus is used to covert the fundamental component in original phase current to direct current component,the fault characteristics frequency of bar break is transformed into the twice slip frequency.The problem is solved that fault characteristic component in the spectrum analysis of the current is easily to be blanketed by fundamental component and is hard to highlight fault characteristics.

将Hilbert模量定义为原始信号与其共轭信号的平方和，利用Hilbert模量将原相电流中的基波分量转变为直流分量，原频谱分析的转绕组断条的故障特征分量转变为频率为二倍转差频率的电流分量，决了相电流频谱分析方法中断条故障特征成分容易被基波湮没而难以突出故障特征的问题。

At the phase inversion point,the viscosity of the system at low stress increases slightly and the dynamic rheological parameters (storage modulus,loss modulus and complex viscosity) reach their minimum values.

摘 要 以动态应力流变仪DSR对双酚A型环氧树脂在低乳化剂浓度(2.33wt%)下的相反转乳化过程进行了稳态应力扫描及动态频率扫描实验。

The company worked for research and development of motorcycle gear and automobile gear, and become a lead in manufacture mid modulus gear and small modulus gear.

自公司建立以来就致力于各型摩托车齿轮和汽车齿轮的研发与制造，并逐渐成长为中小模数齿轮生产厂家的领先企业。

The storage modulus is increased with the increase of Cf, while the peak temperature of loss factor and the temperature of loss modulus are not changed with the variation of Cf, which means that the reinforcement of chitin fiber has no effect on the motion of molecular segment for PCL.

动态热机械分析表明，复合材料的储能模量随纤维含量的增加而增加，表征玻璃化转变温度的损耗因子松弛峰的峰值温度和损耗模量的温度都不随纤维含量的改变而变化。

The results showed when the coated PVC fabric scraps were palletized by means of extrusion directly, the strength of the moulded part was weaker than that of the part made from PVC monomer. After the compounding of the fabric scraps with nonwoven PP fabric scraps and waste PE fishnet, the strength and elastic modulus of the composite increased obviously, the toughening effect of the glass fiber was especially noticeable in the form of tensile modulus.

实验结果表明：利用纤维类下脚直接挤出造粒工艺，其注塑成型品的强度要低于PVC单体的强度；通过与PP和PE复合后，复合材料的强度和弹性模量得到显著提高，特别是弹性模量方面显示出了玻璃纤维的增强效果。

The main research tasks and results are as follows:(1) Through comparing the stress intensity factor of compact tension specimen calculated by finite element software with the theoretical value, the feasibility of calculating fracture parameters of crack tip in ABAQUS software was verified.(2) The relationship between the elastic modulus of the material and research scale was studied based on deriving the cohesive stress theory and other relevant theories. And the elastic modulus of the material on meso-scale was determined.(3) Global model and sub-model of the finite element were built in th...e macro-scale, and stress-strain field nearby the crack tip was analyzed, and the results show that the detailed stress-strain in the crack tip could be obtained by using the sub-model technique.(4) In meso-scale, the crack growth model was also established by assuming the crack propagating along the grain boundary, and the detailed stress-strain field in the crack tip was obtained.(5) The effect of crack length on Von Mises stress, and maximum principal stress and strain was analyzed in meso-scale when equivalent KI equals 30MPa.m1/2. And the results show that except for crack tip area, the stress-strain distribution in whole specimen is not affected.

主要完成研究内容和取得成果如下：(1)利用有限元软件计算出紧凑拉伸试样的裂纹尖端应力强度因子KI值，其结果与理论值一致，从而验证了利用ABAQUS计算裂纹尖端相关断裂参量的可行性；(2)在研究内聚应力等相关理论的基础上，推导出了研究尺度与材料弹性模量的近似关系，并确定了介观尺度上的弹性模量；(3)在宏观尺度上建立了全局有限元计算模型和子模型，得到了裂纹尖端应力应变场分布，结果表明利用子模型技术获得比较准确的裂纹尖端应力应变场分布是可行的；(4)在介观尺度上利用平均晶粒尺度的方式建立了裂纹沿晶扩展模型，得到了裂纹尖端断裂过程区的微观应力应变场；(5)当应力强度因子为30MPa.m1/2时，分析了介观尺度上在裂纹沿晶扩展过程中裂纹长度对Mises应力、最大主应力和应变的影响，结果表明，裂纹扩展长度对试样整体应力应变分布影响不大，而对裂纹尖端区域有较大影响；(6)介。。。

The process method of kaolin was introduced using A-151 and ester titanate coupling agent. Effect of dosage of A-151 and ester titanate coupling agent on stretch strength and modulus, bending strength and modulus , impact strength of UPR was investigated.

介绍了用A - 15 1与钛酸酯偶联剂处理高岭土的方法，研究了处理剂的用量与偶联高岭土的加入量对UPR的拉伸强度和模量、弯曲强度和模量以及冲击强度的影响。

When the elastic modulus is high, stress and strain are mainly concentrated at edge of the overlap region, while those in weld spot zone are relatively even; when the elastic modulus is low, stresses in the adhesive layer are small while stresses are concentrated to a certain extent at edge of the weld spot.

分析发现，胶粘剂弹性模量对接头中应力应变分布的趋势有明显影响，胶粘剂弹性模量高时，搭接区边缘附近区域应力应变高，焊点区应力应变值相对较小；弹性模量低时，焊点边缘处存在一定的应力集中，胶层中应力较小。

Vishnu entered a dark fourth dimensional dream that did not support his field or continued life.

毗瑟挐进入了一个第四密度的黑暗梦想，那里并不支持他的能量场或继续生命。

Leaders and decision-making persons use it to collect the data, including the information of unit work, handing in fee, oweing fee, prepaying fee,changing and afterpaying and account transfering of joining-insurance employee, and account paying of all kinds of insurances from hospitalization insurance institutions.The collected data is picked up, organized, switched and showed to user.

该子系统主要面向各级领导、决策分析人员；从各个医疗保险经办机构和定点医疗机构采集数据，包括在各个医疗保险经办机构处理的单位办公信息，单位缴费、欠费、预缴费信息，参保职工变更信息，参保职工增减变动信息，参保职工补缴信息，参保职工帐户划拨信息：包括各定点医疗机构处理的各险种帐户支出信息，各险种的统筹金支付信息等；将采集的数据提取，组织和转换，然后展示给用户。