查询词典 X-disease

The diagnosis of OP is dependent on bone mineral density measured by dual energy X-ray absorptiometer which is used as a golden standard. But the body fat could interfere the measurement of BMD by DXA.

双能X线吸收测量法(dual energy X-ray absorptiometer，DXA)测量骨密度是诊断骨质疏松的金标准，但它的精确性受身体脂肪含量的影响。

The optical waveguides fabricated by using single benzoic acid and 60% ratio dilution were analyzed by double crystal X-ray diffraction.

用双晶X射线衍射法对单苯甲酸和混合摩尔比为60%制作的光波导进行X射线衍射。

Pitch circle diameter: d = mz = 3X12 = 36 Tooth crown heights: ha = m (f0 + x)= 3X (l +0.5)= 4.5 Tooth High: hf = m (f0 + cx)= 3X (l +0.25-0.5)= 2.25 Tooth full height: h = ha + hf = 4.5 +2.25 = 6.75 Addendum circle Chemical pumps diameter: Da = d +2 ha = 36 +2 X4.5 = 45 Fixed string tooth thickness: Sxn = m (π/ 2 * cos2a + xsin2a)= 3X (1.387 +0.6428 X0.5)= 5.125 Fixed string of high gear tooth thickness measurement: hxn = m (π/ 8 * sin2a + xsin2a)= 3X (0.7476X0.117X0.5)= 2.42 Modulus coefficient x0.5 m3 O20 ° pressure angle tooth thickness Sxn5.12 fixed string Addendum Coefficient string f1 fixed gear tooth thickness measurement most high hxn2.42 Teeth z12 2, shaft wear and tear maintenance: Axis gear pump wear is mainly because with the support roller shaft at both ends between the friction and wear, so that smaller shaft diameter.

分度圆直径：d=mz=3X12=36 齿顶高：ha=m（f0+x）=3X（l+0.5）=4.5 齿根高：hf=m（f0+c-x）=3X（l+0.25-0.5）=2.25 齿全高：h=ha+hf=4.5+2.25=6.75 齿顶圆直径：Da=d+2ha=36+2X4.5=45 固定弦齿厚：Sxn=m（π/2*cos2a+xsin2a）=3X（1.387+0.6428X0.5）=5.125 固定弦齿厚测量用齿高：hxn=m（π/8*sin2a+xsin2a）=3X（0.7476X0.117X0.5）=2.42 模数m3变位系数x0.5 齿形角o20°固定弦齿厚Sxn5.12 齿顶高系数f1固定弦齿厚测最齿高hxn2.42 齿数z12 2、轴的磨损维修：齿轮泵中轴的磨损主要是因为轴两端与支撑滚针间的摩擦磨损，使轴径变小。

First, we introduce and discuss the various methods of multivariate polynomial interpolation in the literature. Based on this study, we state multivariate Lagrange interpolation over again from algebraic geometry viewpoint:Given different interpolation nodes A1,A2 .....,An in the affine n-dimensional space Kn, and accordingly function values fi(i = 1,..., m), the question is how to find a polynomial p K[x1, x2,...,xn] satisfying the interpolation conditions:where X=(x1,X2,....,xn). Similarly with univariate problem, we have provedTheorem If the monomial ordering is given, a minimal ordering polynomial satisfying conditions (1) is uniquely exsisted.Such a polynomial can be computed by the Lagrange-Hermite interpolation algorithm introduced in chapter 2. Another statement for Lagrange interpolation problem is:Given monomials 1 ,2 ,.....,m from low degree to high one with respect to the ordering, some arbitrary values fi(i= 1,..., m), find a polynomial p, such thatIf there uniquely exists such an interpolation polynomial p{X, the interpolation problem is called properly posed.

文中首先对现有的多元多项式插值方法作了一个介绍和评述，在此基础上我们从代数几何观点重新讨论了多元Lagrange插值问题：给定n维仿射空间K~n中两两互异的点A_1，A_2，…，A_m，在结点A_i处给定函数值f_i(i=1，…，m)，构造多项式p∈K[X_1，X_2，…，X_n]，满足Lagrange插值条件：p=f_i，i=1，…，m (1)其中X=(X_1，X_2，…，X_n)，与一元情形相似地，本文证明了定理满足插值条件(1)的多项式存在，并且按"序"最低的多项式是唯一的，上述多项式可利用第二章介绍的Lagrange-Hermite插值算法求出，Lagrange插值另一种描述是：按序从低到高给定单项式ω_1，ω_2，…，ω_m，对任意给定的f_1，f_2，…，f_m，构造多项式p，满足插值条件：p=sum from i=1 to m=Ai=f_i，i=1，…，m (2)如果插值多项式p存在且唯一，则称插值问题适定。

The representative points of positive case support vectors and negative case support vectors in sample set are defined, the measure and eigenfunction between sample x and y allusiveness from initial space to eigen space under a kernel function k are researched, and a correlative theorem with demonstration is given.

定义了样本集中的正例支持向量和反例支持向量的代表点，研究了原始空间样本x，y在核函数k映射下在特征空间中的x，y映象之间的度量和特征函数并给出了相关的定理及证明。

Objective:To study X-ray diagnosis,classification and differential diagnosis of pulmonary alveolar proteinosis.

目的：探讨肺泡蛋白沉积症的X线诊断、X线分型与鉴别诊断。

The unit cell parameter of polypropylene crystallized with different method and condition was studied:curves of wide angle X-ray diffraction are determined by stepwise scanning method,X ray multi peaks resolution program and simulation program of unit cell parameter developed by the general inverse matrix method are used as data processing of determined results.

研究了不同方式和条件下形成的等规聚丙烯结晶的晶胞参数，用步进扫描测定试样的宽角X-射线衍射，用广义逆矩阵法编的计算机分峰程序和晶胞参数拟合计算程序对测定结果进行计算和数据处理。

The MGPXRC can be used to measure the focal spot size of X-ray source with a larger emitting angle than the critical angle of the total reflection of X-rays.

分别利用多毛细管准直器法和常用的小孔成像法测量了同一微焦斑X射线光源的焦斑直径，测量结果分别为60.8和59.4 μm。

Methods Collect 20 cases history of anklebone fracture scaned by X?ray,normal CT scan and quasi coronary CT scan.n,compare the result of exam result.Estimate the application of quasi coronary scan in anklebone fracture in X?

收集踝关节骨折病例20例，均行X线、CT常规横轴位扫描及准冠状位扫描检查，比较三者的检查结果，评价CT准冠状位扫描技术在踝关节骨折检查中的作用。

The α-BaB〓O〓 crystal is colorless, transparent and without cracking. The cracking problem has been overcome by a special growth procedure. The dislocation density, crystallization morphology and growth habit of α-BaB〓O〓 crystal have been systematically studied by chemical etching method, X-ray laue orientation of synchrotron radiation, double-crystal diffraction topography. The growth striation and irregular dislocation consist of the primary defect in α-BaB〓O〓 crystal. The convex solid-liquid interface is stable during the whole growth process.

在国际上首次采用提拉法生长出φ50×40mm〓的α-BaB〓O〓晶体，生长方向为[0001]，晶体完整、无色透明；提出了三种固相反应的原料制备方法，并保证B〓O〓过量1mol%；采用独特的生长装置和程序有效地解决了α-BaB〓O〓晶体易开裂的问题；首先采用化学腐蚀法、白光X射线衍射术、X射线双晶衍射形貌术等研究了α-BaB〓O〓晶体的位错密度；首次采用同步辐射X射线劳埃定向术研究了α-BaB〓O〓晶体的结晶形态及生长习性；结果发现α-BaB〓O〓晶体的缺陷以位错为主，部分α-BaB〓O〓晶体中存在生长条纹。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷