查询词典 X ray

The prepared materials were characterized by X-ray diffraction and scanning electron microcopy. The electrochemical properties of the prepared materials were investigated by charge-discharge test.

采用了X射线衍射、扫描电子显微镜等手段对产物的结构和微观形貌进行了表征，同时通过充放电测试考察了所得样品的电化学性能。

The deposited films were characterized by X-ray diffraction, atomic force microscopy and field emission scanning electron microcopy to investigate the influence of the buffer layer on the crystalline quality and surface morphology.

采用X射线衍射仪、原子力显微镜和场发射扫描电子显微镜研究了缓冲层对薄膜结晶特性和表面形貌的影响。

The microstructure and characteristics of them were tested by X-ray diffraction, scanning electron microcopy, AC impedance, and four-probe direct current methods.

利用扫描电子显微镜、X射线衍射分析、交流阻抗、直流四探针法等技术，对材料的结构及性能进行表征。

Metallographic analysis, analysis for fracture surface of scanning electron microcopy photographs, electron-probe analysis,X-ray powder diffraction analysis, transmission electron microscope analysis have been done for the analysis of microstructurs、fracture apperance、structure,and has carried on the preliminary discussion to the toughening Mechanisms.

采用金相分析、扫描断口分析、能谱分析、x射线粉末衍射结构分析、透射电镜分析对合金化以及引入韧性第二相后的TiFe_2合金的显微组织、断口形貌、微观结构进行了分析，并对合金的韧化机制进行了初步的探讨。

Atomic force microcopy, transmission electron microcopy, X-ray diffraction and electron probe are applied to study the microstructure, morphology and chemical composition of the chips, either as-implanted or annealed at different temperatures. It was found that the as-implanted Zn atoms aggregate into clusters scattering about 35 nm beneath the surface of the chips.

利用电子探针、薄膜X射线衍射仪、原子力显微镜和透射电子显微镜，对注入和热氧化后的薄膜成分、表面形貌和微观结构进行表征，探讨了热氧化温度以及注入剂量对纳米ZnO团簇的成核过程及生长行为的影响。

Its morphologies and structure were characterized by scanning electron micrograph and X-ray diffraction, and its electrochemical properties were studied by charge-discharge test.

用扫描电子显微镜和X射线衍射研究了材料的表面形貌和晶体结构，用充放电循环实验对制备的锂离子电池性能进行了测试。

Scanning electron micrograph and X-ray diffraction were used to analyze the structural change and the compositions of the adhesive treated at different temperatures.

利用扫描电镜和X射线衍射对不同温度热处理后的粘接界面结构形貌及粘接剂组成进行了分析，研究了酚醛树脂中的B4C添加剂在粘接过程中的结构变化及其对提高粘接性能的作用机理。

With corn starch as main raw material,the optimal dispersing process for starch film modified by nano-silica was studied and the structure of the film was analyzed by infrared spectroscopy,X- ray diffraction and scanning electron micrography.

以玉米淀粉为主要原料，研究了蚋米SiO_2改性淀粉薄膜的最佳分散处理工艺，并通过测定样品的红外吸收光谱、X-射线衍射图和扫描电镜照片对该膜的结构进行了分析。

Scanning electron micrography and X-ray fluorescence spectrometry were employed to characterize the construction process of the immunosensor. Cyclic voltammetry and differential pulse voltammetry were used to study its electrochemical properties. The content of CAP was determined with competitive immunoassay.

采用扫描电镜、X射线荧光光谱表征了免疫传感器的制备过程，采用循环伏安法和示差脉冲伏安法研究了免疫传感器的电化学性质，结合竞争性免疫分析法测定了CAP浓度。

The obtainted quantitatively statistical results of the assemblages of the quartz grain surface textures formed by the chemical erosion precipitation are well correlated to the analytical results of mineral X ray diffraction and micropaleontology and can better explain the changes of sedimentary environment and paleoclimate which the marine zone concerned underwent.

石英颗粒因化学溶蚀－沉淀作用形成的组合表面特征的定量统计结果与矿物的X射线衍射和微体古生物的分析结果相对应，能较好地解释该海区经历的沉积环境和古气候变化。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。