查询词典 X alloy

And the caution of aluminum alloy pipe butt weld X-ray detection was described.

并对铝合金管道对接焊缝X射线检测注意事项进行了阐述。

Morphology of Sn-0.7Cu and Sn-3.5Agpowders, the course of mechanical alloying and the effect of ball milling conditionson the formation of mechanical alloy were analyzed using a scanning electronmicroscope, a differential thermal analyzer and an X-raydiffractometer.

利用扫描电镜、差热分析仪、X 射线衍射仪对 Sn-0.7Cu、Sn-3.5Ag 合金粉末的形貌、机械合金化进程、球磨条件对机械合金化合金相的影响、机械合金化 Sn-0.7Cu、Sn-3.5Ag 的反应机制进行了研究。

In order to study the composition segregation region s in bulk metallic glass,small angle X-ray scattering technique and differential scanning calorimetry were used to investigate the evolution of microstructure in Cu55Zr30Ti15 amorphous alloy heated from 310 K to 783 K.

为了研究大块非晶合金中成分分离区的存在状态及其在晶化过程中的作用，应用小角X射线散射技术和差示扫描量热仪研究Cu55Zr30Ti15非晶合金从310 K到783 K之间微结构的演化情况。

By using optical metallography;TEM and x-ray diffractometer, microstructure and texture of 3004 aluminium alloy sheet from cast rolling plate are studied.

通过光学金相、透射电镜和x射线衍射技术等分析方法，研究了3004铝合金铸轧板的组织和织构特征。

The effect of current density on the composition, structure and morphology of Ni-W alloy electrodeposit obtained in pyrophosphate bath were studied by the methods of spectrophotometry, X-ray diffraction and metallurgical microscope.

采用分光光度法、X射线衍射和金相显微镜等方法研究在焦磷酸盐体系中，电流密度影响下所获得的Ni-W合金电沉积层的组成、结构和表面形态。

Effects of yttrium and erbium on the microstructure and the mechanical properties of the 2519 aluminum alloy were investigated by means of optical microscope, SEM, X-ray and tensile test.

用光学显微镜、扫描电镜、X射线衍射分析、拉伸实验等研究了钇、铒对2519铝合金组织及力学性能的影响。

Using of optical microscopy, X-ray diffraction, transmission electron microscopy, hardness and tensile testing, the effect of thermal exposure at high temperatures on the microstructures and of high-temperature tensile properties of rapidly solidified AlCrYZr have been studied. The results show that there are two main phases,Al20Cr2Y(cubic, a=1.437 nm) and DO23Al3Zr(terganal, a=0.4 013 nm , c= 1.732 nm), in the as-solidified alloy. The Al20Cr2Y phase can maintain its cubic structure at 500℃, but the particles coarsen remarkably and even become lumpish. In coarse lumpish Al20Cr2Y phase the plane faults and twin structures exist.

摘 要：采用金相、 X射线衍射、透射电镜、硬度测定和拉伸试验研究了高温热暴露对快速凝固AlCrYZr合金显微组织影响和高温下力学性能的热稳定性，结果表明，快速凝固AlCrYZr合金主要第二相为Al20Cr2Y(立方，a=1.437nm)和DO23Al3Zr(正方，a=0.401 3nm， c=1.732nm)，Al20Cr2Y在500℃热暴露尚能保持其立方结构，但质点明显粗化，甚至块状化，在粗大的Al20Cr2Y相中存在有层错和孪晶结构。

To further improve the overall properties of the alloys, the 〓 alloy having a higher discharge capacity was selected and the effect of Al substitution for Ni on the phase structure and electrochemical properties of the 〓(x=0-0.03) quinary alloys was studied.

为了进一步提高合金的综合性能，从上述研究的合金中选择了一种放电容量最高的〓合金为基础，进一步研究了在含Co合金中Al对Ni的部分替代对〓（x=0-0.03）五元合金相结构和电化学性能的影响。

InNSb alloy films were prepared on GaAs (001) substrates by N2 radio frequency plasma-assisted molecular beam epitaxy, the N composition and micro-structures of the samples were characterized by atom force microscopy, scanning electron microscopy, X-ray diffraction and Raman spectroscopy.

本文利用射频氮等离子辅助分子束外延（RF-MBE技术在GaAs（001）衬底上生长稀氮InNSb半导体薄膜，并通过原子力显微镜、电子扫描显微镜、X射线衍射仪、拉曼散射光谱等测量手段对样品的微结构和氮组分等进行了表征。

The microstructure, mechanical properties and hardness of Mg-2% Mn-x%Y alloy were analyzed by optical microscope, mechanical apparatus and sclerometer.

用光学显微镜、力学万能试验机和显微硬度仪等分析了Mg-2% Mn-x% Y合金的显微组织和力学性能。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。