查询词典 U-boat

Imbues u with the locale loc, returns the previous locale used by u if any.

将 u 的区域设为 loc，返回 u 之前使用的区域。

If u bet to the right way u can lose to the most unbelievable way.

如果u投注正确的做法u能失去最不可思议的方式。

The objectives of this paper were to investigate the simulation and design of continuous multiple-station rolling forming process for a U-Section Steel Bar by CAE software-DEFORMTM Due to the limitation of elements number using a short strip 120mm went through all the stations to simulate the real continuous rolling forming on factory The roller gap was fixed as 0 30mm roll speed was 20 rad/sec and progressive angles were all equal for each rolling process which were the formed angle divided by by the number of station Three rolling processes were selected with 6 9 and 12 stations respectively During simulation processes two cases occurred Case A the strip was through a single station Case B the strip across two stations Because the strip laterals side was stretched and twisted during the process The model of case B closer to the practical process than case A and the calculated stress and strain on the tip of U section for case A were lower than these for case B by up to 15% From the result of case B for each process the stress for 12-station process was smallest 9-station process second and 6-station process next Because less-station can save larger cost and forming time but the bigger stress and strain for 6-station caused wrinkles on lateral sides not found on 9-station and 12-station Therefore 9-station process was a more suitable design than 12-station process smaller stretched and twisted and stress The progressive angles for 12-station was 7 5?

本文主要是以DEFORMTM有限元素软体模拟U型钢片连续道次成型与单一道次成型以确认单一道次模拟的是否可取代连续道次模拟之研究。因DEFORMTM 软体对於网格元素上的限制故使用较短素材120mm通过所有的成型站以模拟工厂实际连续成形方法。辊轮间隙固定为0 3mm；辊轮转速为20 rad/sec；弯曲角度的方法为将成型角度平均除以成型站数。有三种辊轮成型方式被选择分别为6站，9站，与12站。在模拟的过程中有两种现象会产生 Case A，素材通过单一成型站。Case B，素材会通过两个成型站。因为在模拟过程中素材的两端会有拉应力与扭力。Case B的模拟比Case A像实际的制程，并计算应力与应变在U型断面的Tip部中可发现Case A比Case B低约15%。从Case B的每站的结果可以得知，12站的成型应力最小，9站次之，6站最后。

Plastic gift: Professional development and production of various types of soft gifts, such as Block Mobile \ Mobile Phone Charm \Mobile \ cell phone non-slip pad \ frame \ cartoon frame \ lock key chain \ notebook \ luggage tag \ wrist band \ silicone hand Central \ mug \ car front anti-skid pad \ shockproof mat \ cup \ cushions \ bar pad \ mats \ mouse pad \ Mobile Sassafras \ U disk shell \ U disk sets \ brooch \ bracelet \ Watch band \ Fridge paste \ hairpins \ bookmarks \ book folder \ pen \ cartoon cap of a pen, such as soft / Epoxy / PVC micro-injection products, the other for all types of clothing, sports shoes, handbags, toys and gifts such as plants to provide plastic chapters, screen printing, printed standard, self-adhesive stickers, woven Tianbiao, Paper card, tag and other accessories.

塑胶礼品：专业开发生产各类软胶礼品，如手机座\手机吊饰\手机来电闪\手机防滑垫\相框\卡通相框\锁匙扣\笔记本\行李牌\手腕带\硅胶手环\马克杯\汽车前台防滑垫\防震垫\杯垫\桌垫\酒吧垫\地垫\鼠标垫\手机檫\U盘外壳\U盘套\胸针\手镯\手表带\冰箱贴\发夹\书签\书夹\笔筒\卡通笔套等软胶/滴胶/PVC微量射出制品，另外为各类服装、运动鞋、手袋、玩具等厂及礼品提供胶章、丝印、印标、不干胶贴纸、织标、皮牌、吊牌等辅料。

The results showed:①Anthocyanin content in mature fruits was 132170 U·g-1FW in bud mutation which was very significantly higher than that in'Ralls'(49140 U·g-1FW);②Activities of PAL and UFGT were almost the same between the two materials, but CH I and DFR activitieswere significantly high in bud mutation, which were related to the increase of anthocyanin levels in the mutant;③Bagging treatment inhibited anthocyanin synthesis of bud mutation. But anthocyanin content had significantly increased after removing the bags. Activities of CHI and UFGT increased rap idly and were much higher than those in the control after the bag removal. The increase was consistentwith the imp rovement of anthocyanin levels.

结果显示：①在果实发育期间，芽变果皮的花青苷含量明显高于'国光'，尤其是成熟期芽变果皮花青苷含量为132170 U·g-1FW，而'国光'仅为49140 U·g-1FW；②在果实发育期间，两个品种间PAL 和UFGT的酶活性无明显差异，但芽变的CHI和DFR酶活性明显高于'国光'，表明芽变花青苷合成能力的提高与CHI和DFR酶活性高有关；③套袋抑制芽变果皮花青苷的合成，但解袋后花青苷的含量极显著升高，解袋后4种酶的变化趋势差异较大， CHI和UFGT活性均迅速升高，明显高于对照，这与解袋后花青苷迅速合成相吻合。

The major works are as follows: 1 The 3-D numerical model of U-sharp flow passages is set up. The single-phase fluid flow and heat transfer are simulated for the U-sharp smooth and rib-roughened flow passages with FLUENT software. Their performance curves, temperature field and velocity vector are obtained and the local heat transfer and flow pressure-drop distribution along flow passage are analyzed. It is revealed that the ribbed flow passages can enhance heat-transfer and make the temperature more uniform, but it increases the pressure-drop to more extent. 2 The influences of diaphragm depth, channel width and board spacing on the performance are investigated.

建立了层叠式蒸发器U形流道的3维湍流模型，用FLUENT软件对尺寸相同的U形光滑流道和肋化流道中单相流体的传热和流动进行了数值模拟，得到了两种流道的传热和阻力性能关系曲线及速度矢量图、温度场，分析了光滑流道和肋化流道的局部换热系数及沿程压降变化，结果表明流道的肋化能有效的增强传热，而且使流体的流动和传热更加均匀，但也较大地增大了阻力。

Main produces:1,Piping producing equipments: 3D Digital Control Bender, Coil Straightening Guillotine, Pipe terminal Molding, Digital Control Flute Shape Pipe Machine, Digital Control Distributor Drill, Automatic Grid loading and Groove rolling Equipment, Automatic 2-end Digital Control Chamfer Equipment, Tee Flaring / Flating Equipment2,Heat Exchanger Producing Equipment: Long-U Shape Benders, Short-U Shape Benders, Horizontal Expanders3,Others: Hydraulic Pressure Single Benders, Pipe Pressing Machine, Digital Control Double-head Chamfer Machine, S-shape Feeding and Shaping Machine, Welding Machine, Hydraulic Sawing MachineWe are stick to the spirit of strict quality management, sustaining technology progress and perfect after service, service for our customers.

主要产品：1、配管加工设备：三维数控弯管机、盘管校直切断机、管端成型、数控笛形管机、数控分配器钻孔机、自动装网滚槽机、全自动双端数控倒角机、三通扩口机。2、空调换热器生产设备：长U弯管机、小U弯管机、卧式涨管机。3、其它加工设备：液压单弯机、压管机、数控双头倒角机、S形送料整形机、展架焊接机、液压锯床。

Results show that maximum activities of LiP and Lac reach 11.3 u/g at the 12th day and 0.0992 u/g at the 15th day, rapidly degraded during 10～20 d, and the total loss rate of dry corn stalk is 18.94% after cultivation for 25d. The relative contents of celluloses and hemicellulose are decreased from 27.1% to 13.1% and from 20.3% to 11.9%, respectively after enzymolysis for 6 d.

黄孢原毛平革菌培养12 d时木素过氧化物酶酶活达到最大值11.3 u/g，15d时漆酶酶活达到最大值0.0992 u/g，秸秆降解集中在10～20 d，第25d时菌解结束，干基总损失率为18.94%；再经过6 d的酶解，纤维素、半纤维素的相对含量分别从27.1%、20.3%下降到13.1%、11.9%。

Zircons were picked out from diabases in The Luobusa ophiolite, whose ~(206)Pb/~(238)U apparent ages SHRIMP U-Pb dating show very complex , but a majority of which distribute between the 148.3Ma and 174.2Ma.

罗布莎蛇绿岩辉绿岩中的锆石SHRIMP U-Pb ~(206)pb/~(238)U表观年龄呈现复杂的分布格局，主体年龄在148.3～174.2Ma范围之内，获得高精度的锆石谐和年龄为162.9±2.8Ma，即罗布莎蛇绿岩的形成年龄。

Converts c to upper case, used for Perl-style \u and \U formating operations.

将 c 转为大写，用于 Perl 风格的 \u 和 \U 格式化操作。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了