查询词典 TEM

Secondly, in this paper, the four typical UWB antennas of TEM horn antenna, log-periodic antenna, biconical antenna and helical antenna are theoretically analyzed and the UWB antenna design methods are generalized and discussed.

其次，本文对TEM喇叭天线、对数周期天线、双锥形天线和螺旋天线四种典型的超宽带天线进行了理论分析，总结并讨论超宽带天线的设计方法和手段。

TEM images show that the formation of shaped Au nanoparticles has been achieved by reducing Au ions in the presence of TCA using potassium bitartrate as the reductant.

TEM图像显示在TCA存在下，酒石酸氢钾直接还原金离子后形成各种形状金纳米粒子。

XRD and TEM data indicated that the crystal has cubic structure of blende with cell constant of α＝0.5390 nm in the range of 250～300 nm.

由XRD和TEM的结果显示，其结构为立方闪锌矿，晶格常数为α＝0.5390 nm。

The innovations in this investigation are as follows: 1. The cell boundary bands of hexagonal cells are observed by TEM on the anodic film formed in sulphuric solution, which is little reported in the literature.

利用TEM成功观察到形成于硫酸电解液的阳极氧化膜其胞状结构中胞壁带的存在，这在公开的文献中报道不多。

Firstly, XRD, TEM and FT-IR were used to characterize the structure of CNTs treated by dense HC1, dense HNO_3, HNO_3, H_2SO_4-HNO_3, K_2Cr_2O_7-H_2SO_4 and bromic acid. The results showed that purification treatment had no change on the structure of CNTs. But on the top of CNTs have function group such as -OH and -COOH after H_2SO_4-HNO_3 and K_2Cr_2O_7-H_2SO_4 were treated.

采用浓HCl、浓HNO_3、H_2SO_4-HNO_3、K_2Cr_2O_7-H_2SO_4、溴水共5组物质分别对CNTs进行纯化处理；借助XRD、TEM、FT-IR等分析手段对处理前后CNTs结构及形貌进行表征，发现以上5种物质纯化处理并不会对CNTs结构造成很大影响，其中H_2SO_4-HNO_3和K_2Cr_2O_7-H_2SO_4处理效果较好，除杂的同时CNTs端口带上-OH或-COOH活性官能团。

The main object of this research is to investigate synthesis of Cu23Cl Cu and CuO nanoparticles through electrospinning and heat-treated method The research is mainly focused on preparative parameter and the change of heat-treated temperature to form the nanoparticles inlaid in silicon fibers the shape and color change are dicussed First of all to prepare the Polyvinyl butyral and silica dioxide complex nanofiber by electrospinning and then to investigate different heat-treated temperature and reactive time to being an influence on the products The results detected by SEM XRD TEM EDS FTIR combined sol-gel process and electrospinning can prepare Polyvinyl butyral and silica complex nanofiber The experimental result is found when heat-treated temperature is 100~4750C it can produce Cu23Cl nanoparticles; Above 4750C~ 4900C it can produce Cu nanoparticles; Above 450~7000C it can produce CuO nanoparticles And the viscosity is lain between 20~40cp and the sol-gel process time is 3hr it can produce the thinner fibers The average diameter of the fibers are 107 88±21 01nm;Due to the nanoparticles inlaid in the silica fibers the thinner fibers can be inlaid the smaller nanoparticles so this is the result that the experiment is expected To calcine the complex fibers is to produce surface silica fibers contain Cu23Cl Cu and CuO nanoparticles due to surface plasma resonance it make the color of the fibers become yellowish green from light white green turn into the red nuclear finally As the experimental result to utilize sol-gel process combine electrospinning can produce porous silica fibers contain Cu23Cl Cu and CuO nanoparticles

本研究旨在探讨「利用放电纺丝和热处理法来合成Cu23Cl、Cu和CuO奈米粒」之研究，实验著重在制备参数与热处理温度变化对所形成的奈米粒镶嵌在二氧化矽纤维中的形态与颜色变化探讨。首先，利用放电纺丝法制备出聚乙烯醇缩丁醛及二氧化矽之奈米纤维，比较不同的热处理温度与反应时间的改变对产物生成产生影响，进而研究不同热处理温度和时间对生成奈米粒的影响。产物经由SEM、XRD、TEM、EDS和FTIR等仪器分析结果显示，结合溶胶-凝胶法(sol-gel process)和放电纺丝法可产生聚乙烯醇缩丁醛及二氧化矽复合奈米纤维。实验结果发现，若热处理温度在100~4750C下可得到Cu23Cl奈米粒，475~4900C 可得Cu奈米粒，450~7000C以上可得 CuO奈米粒。而黏度介於20~40cp间和溶胶-凝胶时间为3hr时，可产生直径比较细的纤维，纤维直径为107 88±21 01nm；且由於奈米金属颗粒镶嵌在二氧化矽纤维中，直径比较细的纤维，可以得到比较小的奈米金属颗粒，这与实验预期相符。而锻烧此复合物产生多孔的二氧化矽纤维并包含Cu23Cl、Cu和CuO奈米微粒时，由於表面电浆子共震关系，而使纤维颜色由淡白黄绿色变成黄绿色，再变红褐色。由实验结果得知，利用溶胶-凝胶法(sol-gel process)结合放电纺丝法和不同热处理温度，可产生Cu23Cl、Cu和CuO奈米粒镶嵌在二氧化矽纤维。

CdS nanoarods have been synthesized by using Cetyltrimethyl Ammonium Bromide as the soft template under γ-irradiation through the reaction of cadmium sulphide (CdSO4·8/3H2O) and thiacetamide in acidic condition for pH value of 3. The physical and chemical properties and the structure of CdS nanorods were characterized by XRD, UV-Vis, SAED, TEM and PL.

在pH=3的酸性条件下，以硫酸镉和硫代乙酰胺为反应前驱体，采用十六烷基三甲基溴化铵自组装形成的管状胶束为模板，通过γ射线辐照法成功合成了CdS纳米棒，并通过XRD、UV-Vis、SAED、TEM和PL等技术对反应中间产物及最终产物进行了表征。

The phase, particle shapes, particle size and specific surface area of the doped ceria powders were characterized by XRD, TEM and BET.

利用XRD、TEM和BET等现代物理测试方法对氧化铈纳米粉体的物相、颗粒度、分散性、颗粒形貌和比表面积等性能进行了表征，650℃焙烧的粉体呈现出良好的结晶状态，为立方萤石结构，粉体的比表面积在56.134－27.354

The evolution of the morphology of the conic structure has been studied using SEM and TEM.

最后对锥状物结构的形成过程和表面型态之发展，也利用SEM和TEM来观察研究。

The TEM observation of dislocation configuration shows that SiC whiskers can suppress the slip coplanarity in the Al-Li based alloys.

变形位错组态的TEM分析显示，SiC晶须对基体合金拉伸变形过程中由δ'相引起的共面滑移具有抑制作用。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。