查询词典 Si

The structure of the high magnetic permeability Pe-Si-Al alloy containing about 10 percent Al and 5 percent Si has been investigated.

本文叙述了利用电子显微镜对含10％Si和5％Al的Fe-Si-Al高导磁合金薄膜进行的结构研究。

The heat-reaction characteristics of Ni/Si and TiN/Ni/Si structure and the regularity for forming the NiSi ...

文中对Ni／Si和TiN／Ni／Si的热反应特性以及NiSi薄膜的形成规律进行了详细的研究。

The onset crystallization temperature of a-Si is effectively lowered due to the formation of Ni silicide, and the crystallization depends strongly on the migration of NiSi〓 precipitates.

对晶化的机理研究表明，a-Si在低温下的晶化是由于形成了Ni的硅化物，其晶化的发生是由于NiSi〓的迁移，其迁移的驱动力是由亚稳态的a-Si转变为c-Si。

A-Si: H photoconductor and nc-Si: H light blocking layer can be prepared easily in the same deposition system continuously.

此外，nc-Si：H阻光层与a-Si：H光导层在同一沉积系统中连续生长，制备方便。

The influence of different assembled condition such as assembly method, concentration of zirconium source and pH value on the effectiveness of assembly were evaluated via DSC-TG, FT-IR, Uv-vis and SAXRD et al. It showed that the assembly effectivness of uncalcined 3 Si/Zr_10# sample was best.c The optical characteristic, which including light-conduction in infrared band and polarity in visible band, of dip-coating film and membrane assembled zirconia after processing parameters of assembly optimized were observed via FT-IR and Uv-vis. The polarity was characterized by polarizing angle through calculation from light-transmittance, light-reflectance and fresnel coefficient. qualitative analysis showed that the polarity of Si/Zr_10 # dip-coating film assembled was best.d Adopting zirconium oxychloride as zirconium source, CTAB as template, employing different CTAB adding sequence, two mesoporous zirconia samples were prepared. The template effect of two samples was discussed. It showed that the effect of the sample which CTAB adding sequence was same as mesoporous silica film was better. The light-conduction in infrared band of these samples was also studied, which offered comparison to the polarity of zirconium dioxide assembled within mesopore.

结果显示：组装条件优化后的uncalcined 3 Si/Zr_10#厚膜样组装效果最好，其组装液对应的pH值最利于该锆源离子模板交换组装； c选用FT-IR、Uv-vis对组装条件优化后纳米氧化锆/介孔氧化硅厚膜、纳米氧化锆/介孔氧化硅薄膜包括红外导光性、可见光区内的偏光性在内的光学特性进行了分析，其中偏光性以膜层透光性、反光性及菲涅耳系数计算出的偏振角即布儒斯特角表征，定性分析显示，Si/Zr_10#ZrO_2/介孔氧化硅厚膜偏光性最好； d以氧氯化锆ZrOCl_2·8H_2O为锆源，CTAB为模板剂，采用不同的模板剂加入顺序，探索性地制备两介孔氧化锆样，分析了两介孔氧化锆样的模板效果，得出模板剂加入顺序同介孔氧化硅薄膜时介孔氧化锆样的模板效果较好，并分析了所得样品的导光性，为锆氧粒子引起的附加光学特性分析提供了参考和对比。

The experimental results show that the content of SiC in RBSC increases with carbon content while α-SiC is chosen as a filler. However, the residual carbon would appear in specimens when the carbon content exceeds 30% by weight. Using carbon felt, the reaction-formed SiC particles are small and uniform in size and distribution. However, when carbon felt is impregnated with phenol resin, the reaction-formed SiC is nonuniform in size and distribution. X-ray diffraction shows that the fabricated RBSC is composed of α-SiC,β-SiC, and free Si. The polytype of SiC is related to the reaction-heat during sintering.

结果表明：选用α-SiC+C粉的混合物作为生坯，SiC相的体积分数随生坯中wC的增加而增加，但过大的wC将使硅化后的试样出现残碳；选用碳毡作为生坯，反应烧结碳化硅的显微组织特点是C／Si反应生成的碳化硅颗粒均匀细小，并呈线状分布在游离硅中；浸渍过树脂的碳毡硅化处理后的显微组织特点是反应生成的碳化硅颗粒粗大且呈不均匀分布。X射线衍射结果也表明，反应烧结碳化硅陶瓷由游离Si、α-SiC、β-SiC组成，试样中不同晶型碳化硅的出现与C／Si反应的放热过程有关。

Phase transformation and morphological change of blended powder of Fe and Si (The Proportionment of atom: Fe:Si=3:1) were studied during high-energy ball milling.

研究了Fe和Si（原子比为：Fe：Si=3：1）混和粉末在高能球磨过程中的物相转变和形貌变化。

Compared to the previous software with CSPM-930a STM, the STM images gotten by my software have less drift and are more directly related to their real dimensions and geometry. The UHV-STM has been used to fabricate atomic-scale grooves by extracting the Si atoms from the Si (111)-7×7 surfaces and redeposit them to form ridges at predetermined surface sites.

利用超高真空扫描隧道显微镜，用W针尖对样品Si（111）-7×7表面的原子进行操纵，成功地在样品表面挖出了具有原子级平直边界的沟槽，并首次在样品表面布出了连续的具有一定形状的凸起的线，首次确认在样品表面布出的凸起的线是由Si原子组成的，并首次用场强梯度诱导扩散理论对针尖在样品表面的布线过程和机理进行了解释。

The epitaxial growth of Er_2O_3 films has been achieved on Si(001) and Si (111)substrates by MBE at the growth temperature of 700 ℃in an oxygen pressure of 7×10~(-6) Torr.

使用电子束外延的方法在p型Si(001)和Si(111)衬底上，在700℃、7×10-6Torr的条件下首次实现了Er2O3单晶薄膜的生长。

It is the fluorosilicic ion that exsits in the slurry and plays an important role in flotation, fluorosilicic ion not only reacted with Fe〓 on the surface of aegirine to form ionic compound, but also formed stable Si-F bond in Si-O etching reaction. Only ionic compound was obtained when it was attached to hematite surface according to the theories of coordination chemistry, Compared with SiF〓, Fatty acid ion preferentially acts with Fe〓 on the minerals surface, therefore, SiF〓 Can't obstruct the adsorption of collector on the surface of hematite completly, but can reduce the flotation recovery of aegirine selectively.

运用FTIR、XPS等测试方法仔细研究了氟硅酸盐抑制剂对含铁硅酸盐钠辉石的选择性抑制作用机理，氟硅酸盐在弱酸性条件下对赤铁矿浮选的抑制作用很微弱，而对含铁硅酸盐钠辉石强烈抑制，从而扩大了两者之间的浮选差异；SiF〓是矿浆中起抑制作用的主要成分，SiF〓不仅与钠辉石表面的Fe〓形成离子型配合物，而且还与Si-O键形成稳定的Si-F共价键，而与赤铁矿表面只能形成离子型配合物，根据晶体配位场理论，与SiF〓相比较羧酸根离子将优先与矿物表面Fe〓发生配位作用，因此SiF〓的存在并不能完全阻碍捕收剂在赤铁矿表面的吸附作用，却能够选择性地抑制钠辉石的上浮。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。