查询词典 Sc

SC 810L and SC-810PSunsaturated polyester resin is the new development of the air-dry coating resin.

SC-810PS 和 SC-810L 不饱和聚酯树脂是一种气干性较好的涂层用树脂。

The position of the short SC,which is on the long SC homologous synapsis of rob(13;17and 13,17moved ,from one-fourth of long SC to one-tenth of it ,near the end of 17arm.

II。三价体中短SC侧臂在长SC臂rob(13；17)与13、17上的位置发生移动，由原来的位于长SC的1/4处移动到了1/10处，即靠近17臂端。

At zygotene,t he SC formation initiated at multiple sites in each bivalent but the regions nea r telomeres were preferred.SCs were shortened with development of SCs.Initiation of new SC and extension of existing SC occured simultaneously,and pairing in di fferent bivalents of a nucleus was not synchronised.

结果表明，小麦SC以多点式起始方式于偶线期开始形成；随SC的发育，新的SC形成和已有SC片断的延伸并存；此外，在同一核内不同二价体之间，染色体配对和SC形成并不同步；SC成熟于粗线期，而以破碎方式解体，消失于双线期。

SC acan turn pneuma fine, add appetite, increase activity and improve color pattern and anischuria of RHR rats.SC didn't have evidence effect on SHR rats'body weight, but can increase RHR rats'body weight. 3.3.3 Find The effect on endothelin、nitrogen monoxidum、atrial natriuretic peptide and renin-angiotensin system of SC .

3.3.3三草降压汤对血浆内皮素、一氧化氮、心钠素及肾素-血管紧张素系统的影响 SC能明显降低SHR、RHR两种高血压大鼠模型血浆ET浓度、升高血浆NO浓度、调整二者的平衡，这可能是其发挥降压作用的重要机制。

When the Al-Mg-Zr-Sc welding wire was used as filling material,the grains of welding seam were refined obviously,and the weld joint was greatly strengthened by forming of fine equiaxial grains layer in fusion zone .

但采用Al-Mg-Zr-Sc合金焊丝为填充材料时，焊缝晶粒组织明显细化，熔合区形成的细小等轴晶层提高了基材与焊缝填充材料的结合力，焊接接头的屈服强度比采用Al-Mg-Zr合金焊丝为填充材料时提高了100 MPa，显著提高了Al-Mg-Sc合金焊接构件的许用强度，因此焊接Al-Mg-Sc板材更宜采用Al-Mg-Sc-Zr焊丝。

On the other hand,it is demonstrated that pitting sensitivity of Al-6Mg-Zr-Sc alloy in the SRB solution is decreased and its microbiologically influenced corrosion r.

结果表明，添加Sc元素后，合金的氧化膜更加致密，具有更好的保护作用，使电极开路电位正移100 mV左右，同时Sc元素的加入降低了材料在SRB菌液中的点蚀敏感性，使材料耐微生物腐蚀性能得到提高，但是添加Sc后的合金对SRB更加敏感。

Temperature and 30 mL CO:. Under this condition, the highest ratio of rotenone can meet 0.359% counted with engineering calculation. For total compounds extraction. 6000psi. 70癈. 40mL and the ratio is 10.06%. For rotenone content in total compounds. 3000psi. 35 癈. lOmL and the high content percent is 7.59%. So when conducting SC-CO: extraction of Tephrosia vogelii.

非洲山毛豆的SC-CO_2萃取应根据萃取目的选用相应的工艺条件SC-CO_2萃取非洲山毛豆生产杀虫剂，应选用压力5000psi，温度45℃，流量30mL的工艺条件；(5)通过夹带剂对萃取效果的影响研究，结果表明加入夹带剂可显著影响非洲山毛豆的SC-CO_2萃取效果。

The studies was proceeded on the the supercritical CO2 extraction technique of rotenone from Tephrosia vogelii. The extraction influences of technology conditions were systematically groped, The research results were listed as follows:1 The analysis method applied in this paper has been proved to be suitable to technology research of the studies on the SC-CO: extraction technique of rotenone from Tephrosia vogelii. 3 indexes, extraction ratio of rotenone. extraction ratio of total compounds and rotenone content percent in total compounds weight, were carried out with HPLC quantitatively determination combined with the sample weight loss after extraction. With these 3 indexes. The extraction influences of technology conditions were evaluated by synthesis. Then the best technology conditions were ascertained for different extraction aims.2 The pretreatment of rough material should be needed before extraction. Comminuting the material to 0.28mm size is most fit to SC-CO: extraction.3 Firstly static extracting 20 min then turn to dynamic doing is the better extraction mode than other ones.4 The orthogonal experiment was conduct with 3 factors and 5 levers.

本论文通过对非洲山毛豆SC-CO_2萃取中影响萃取效果的工艺条件的研究，初步得出如下结果：(1)本论文中所采用的萃取效果评价方法适宜于非洲山毛豆中鱼藤酮的超临界流体萃取技术研究，该方法具体为：HPLC定量分析非洲山毛豆SC-CO_2萃取物中的鱼藤酮含量，再结合萃取前后处理样品的重量损失，得出鱼藤酮萃取率、萃取所得粗物质萃取率和粗物质中鱼藤酮含量三个参数，以此三个指标综合评价萃取条件对萃取效果的影响；(2)通过对原料粒度对萃取效果影响的研究，结果表明SC-CO_2萃取非洲山毛豆复叶中的鱼藤酮，原料粉碎成30目粒度叶粉时萃取效果较好；(3)通过对萃取方式与萃取效果之间关系的研究，结果表明SC-CO_2萃取非洲山毛豆中鱼藤酮应采用先静态后动态的萃取方式，静态萃取时间为20min；(4)通过温度、压力和CO_2流量三因素五水平的正交试验，结果表明温度是最主要的影响因素，压力因素对鱼藤酮萃取率的影响程度高于CO_2流量，而对于粗物质萃取率和粗物质中鱼藤酮含量CO_2流量因素高于压力。

There were soluble trophic molecules with relative molecular weight larger than 30 000 for survival and neurite growth of FMN cultures in media with SC-CMCs derived from facial and sciatic nerves of neonatal rats and with SC-CMCs derived from Wallerian degenerating facial and sciatic nerves of adult rats. It might be reasonable to choose SC from sciatic nerves of rats on account of the findings from SC cultures on facial motoneurons.

面神经和坐骨神经SC-CMC中含有促FMN存活、生长的蛋白或多肽，相对分子质量大于30 000，其活性作用与使用的蛋白浓度有关；在研究SC分泌物对FMN营养活性作用时，可考虑选择坐骨神经SC。

The results show that, the coefficients of welded joints are both greater than 0.9, but the yield strength of weld joint filled with Al-Mg-Zr-Sc welding wire is greater 100 MPa than that of filled with Al-Mg-Zr welding wire. It indicates that the Al-Mg-Zr-Sc welding wire is the best alteration of filling materials to weld of Al-Mg-Sc alloy.

但采用Al-Mg-Zr-Sc合金焊丝为填充材料时，焊缝晶粒组织明显细化，熔合区形成的细小等轴晶层提高了基材与焊缝填充材料的结合力，焊接接头的屈服强度比采用Al-Mg-Zr合金焊丝为填充材料时提高了100 MPa，显著提高了Al-Mg-Sc合金焊接构件的许用强度，因此焊接Al-Mg-Sc板材更宜采用Al-Mg-Sc-Zr焊丝。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。