查询词典 SBR

The chain structures of S SBR2305,Buna SL25 1 and E SBR1500 were analysed by FTIR,and the influences of these three SBRs on the wear resistance,heat build up,rolling resistance and wet traction of NR/SBR blend were investigated by the compression heat build up test with constant load,DMA etc..

采用傅立叶变换红外光谱分析了溶聚丁苯橡胶S SBR2 30 5、BunaSL2 5 1及乳聚丁苯橡胶E SBR15 0 0 3种SBR的链化学结构，采用定负荷压缩生热、动态力学谱等方法研究了 3种SBR对NR/SBR并用胶耐磨性、生热、滚动阻力及抗湿滑性的影响。

The SBR reactor is composed of a series of SBR reactors placed in a fixed sequence but operated in intermission. The operating process of the reactor includes five stages: fill, react, settle, decant, and idle.

SBR 是由按照一定顺序间歇操作运行的 SBR 反应器组成的，反应器在处理废水时的操作过程包括五个阶段即：进水、曝气、沉淀、出水、闲置。

The high-performance SS emulsified quenching asphalt comprises: base material asphalt, emulsifying agent, modifier Sasobit and quenching agent SBR latex, wherein the adding ration of the emulsifying agent, modifier Sasobit and quenching agent SBR latex are separately 0.5-5%, 1-10% and 1-8%.

本发明所述的高性能SS乳化改性沥青，包括基质沥青、乳化剂、改性剂Sasobit和改性剂SBR胶乳，乳化剂、改性剂Sasobit和改性剂SBR胶乳含量分别为基质沥青重量的0.5～5％、1～10％和1～8％。

The sludge settling characteristic is satisfying with SV varying from 22 to 30 and SVI varying from 58 to 80ml/g.The sludge bulking problem has been avoided successfully. The excess sludge can be thickened to 3%-4 %. The alkalinity remains equilibrious between the nitrification and denitrification in SBR-BAF system. The COD and TP loading of SBR are 2.08kgCOD/kgMLSS·d and 41.68gTP/kgMLSS·d, respectively. The NH4+-N loading of BAF is 1.16kgNH_4~+-N/m~3.d. The total HRT is about 10 hours which is only about half of suspended growth process for simultaneous phosphorous and nitrogen removal. Under the above mentioned high loadings and short HRT, the mean removal efficiency of COD, TP, NH4+-N, TN is 96%, 98%, 93%, and 84%, respectively. The mean effluent concentration of COD, TP, NH4+-N, TN, SS is 20mg/L, 0.23 mg/L, 3.24 mg/L, 7.68 mg/L, 5 mg/L respectively, which means every index can meet the first class of Discharge Standard of Pollutants for Municipal Wastewater Treatment Plant.

最后，以上述最佳运行参数控制SBR-BAF系统运行，长期运行结果表明：系统中悬浮污泥的絮凝、沉降性能良好，SV值为22~30，SVI值为58~80，不再有污泥膨胀之虞，而且可以对剩余污泥进行重力浓缩，浓缩后污泥浓度可以达到3~4%；短程硝化和反硝化使得系统可以维持碱度平衡，无需额外补充碱度；系统在高负荷(SBR反应器COD负荷为2.08kgCOD/kgMLSS.d，TP负荷为41.68gTP/kgMLSS.d，BAF反应器NH4+-N负荷为1.16kgNH_4~+-N/m~3.d)、低水力停留时间(SBR反应器9h，BAF反应器1h，总计10h，约为同步脱氮除磷悬浮污泥工艺的一半)下稳定高效运行，对COD(不计BAF加入的外碳源)、TP、NH_4~+-N、TN的平均去除率为96%、98%、93%、84%，出水COD、TP、NH4+-N、TN、SS的平均浓度为20mg/L、0.23 mg/L、3.24 mg/L、7.68 mg/L、5 mg/L，各项水质指标均达到《城镇污水处理厂污染物排放标准》(GB 18918-2002 )一级标准的A标准的要求。

Main product has: SBR of butadiene styrene rubber - 1500, SBR - 1502, SBR - 1712, butadiene rubber BR - 9000, BR - 9073 with 6 ＃ solvent naphtha, 120 ＃ industrial aether of butyl of solvent naphtha, methylic father's younger brother, 1 - Ding Xi.

主要产品有：丁苯橡胶 SBR－ 1500、 SBR－ 1502、 SBR－ 1712，顺丁橡胶 BR－ 9000、 BR－ 9073和 6＃溶剂油、 120＃工业用溶剂油、甲基叔丁基醚、 1－丁烯。

Stable nitritation is realized because the nitrobacter is sensitive to the changing environment. When the dissolved oxygen and pH values in SBRⅠ and SBRⅡ are 2. 4-3. 0mg/L, 7. 0-8. 5, 1. 5-2. 0mg/L and 7. 0-8. 5 respectively, a lot of nitrate isn't found during operation in two months, and nitrosation rate is over 80% in two aerobic reactors.

将SBRⅠ、SBRⅡ好氧反应器的溶解氧、pH分别控制在7.0-8.5、2.4-3.0mg／L及7.0-8.5、1.5-2.0mg／L时，依赖SBR反应器水质波动大、硝酸菌对环境变化敏感的特点，在较高浓度NH〓-N条件下，实现了稳定的亚硝化反应，系统运行近两个月，没有大量硝酸盐的积累，两个好氧反应器的亚硝化率均在80％以上。

Nitrosomonas is successfully cultured in two aerobic reactors in this paper. Experimental results show that two-stage SBR is superior to one-stage SBR at the same hydraulic residence time. Stable nitritation is realized because the nitrobacter is sensitive to the changing environment.

在两个SBR好氧反应器中成功培养出大量的亚硝酸菌，研究结果表明：在水力停留时间相同时，两级SBR好氧反应器的脱氮效率优于一级SBR好氧反应器。

Nitrosomonas is successfully cultured in two aerobic reactors in this paper. Experimental results show that two-stage SBR is superior to one-stage SBR at the same hydraulic residence time.

在两个SBR好氧反应器中成功培养出大量的亚硝酸菌，研究结果表明：在水力停留时间相同时，两级SBR好氧反应器的脱氮效率优于一级SBR好氧反应器。

Tensile strength and t- ear strength increased by 119%and27.4% compared to ungraft SBR Vulcanizates; The Tg of SBR ro- se after grafting and heat-resistence ability of SBR–g–is better than u- ngrafting SBR.

在获得接枝率高而且性能良好的SBR-g-的基础上，采用动态硫化法制备SBR–g–增容丁苯橡胶/聚氯乙烯热塑性弹性体（SBR/PVC TPV），研究SBR-g-对SBR/PVC TPV的增容效果。

The grafting effect and mechanism was charac- terized by FTIR,The heat stability of unvulcanized and dynamical mechanical proper- ty of vulc- lcanizates of SBR and SBR-g- were tested by TG and DMA respectively. medium-resistance properties of SBR and SBR-g- vulcan- izates were also investigated.The results showed that addition of St accelerated GMA grafting onto SBR and control the decomposition of SBR. When the conditions were GMA/St/DCP was 8/4/0.3 and grafting temperature was 160℃.

结果表明，St对提高接枝率、抑制SBR的降解起到了积极的作用；SBR中聚丁二烯的α－H和双键共同参与了GMA/St熔融接枝反应；当SBR/GMA/St/DCP=100/8/4/0.3、接枝温度为160℃时，SBR的接枝率较高（23.78%），SBR–g–硫化胶的拉伸强度和撕裂强度比SBR硫化胶的分别提高了119%和27.4%；SBR–（GMA--co-St）未硫化胶的Tg比SBR未硫化胶的高，而耐热分解性能优于SBR未硫化胶；SBR–g–硫化胶在低温条件下的刚性增大、弹性降低、具有较低的内耗，在常温下的阻尼性能较高，但弹性性能保持较好；SBR–g–硫化胶的耐热稳定性以及耐非极性有机溶剂的性能优于SBR硫化胶。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。