查询词典 S.

The paper realizes the configuration software system frame based on web by the comparison between C/S and B/S mode.

通过对两层C/S模式、B/S模式的比较，提出了基于Web的组态软件的系统框架。

Xiao S , was a weak-kneed and diffident person. He didn't like smoking and drinking apart from serving others. Even though his wife was running wild outside, Xiao S used to help his parents-in-law with some heavy housework.

小 S ，人很老实，很内向，既不抽烟也不喝酒，就是愿意为他人服务——尽管妻子在外面胡闹，小 S 还是经常到岳父家干家务活。

After addition of surface active agent into sprinkling solution, for particle of 1 μm size, the filtration rate has increased from 40% to 70% approximately under the condition of head wind velocity of 1.5 m/s and spr4nkling density of 2.36 kg/(m^2s), and the filtration rate has increased from 30% to 60% approximately under the condition of head wind velocity of 2.8 m/s and sprinkling density of 2.36 kg/(m^2s).

在喷淋溶液中添加表面活性剂后，对于粒径为1 μm的尘粒，在迎面风速为1.5 m/s、淋水密度为2.36 kg/的条件下，过滤效率由40%左右上升至70%左右。在迎面风速为2.8 m/s、淋水密度为2.36 kg/条件下，过滤效率由30%左右上升至60%左右。

"Kv ·= constant" principle, a sense of freedom laminated springs and valve switching power systems Plug Valves constitute △ P / S =εL S-feeling film work area,ε-spring Hook coefficient, L-valve stroke From this position of valve travel decisions every size of △ P value, if the valve travel position of the Kv and inversely proportional to the G = Kv · a constant value.

&Kv·=常数&原理，自由弹簧和感压膜构成阀门开关动力系统△P/S=εL S—感膜工作面积，ε—弹簧的胡克系数，L—阀行程由此可知阀门的每一个行程位置决定△P值的大小，如果阀行程位的Kv与成反比，则G=Kv·是恒定值。

About the system software structure, this paper analyzed the merit and defect of two-floor C/S structure and multi-floor C/S structure.

在系统的软件结构上，本文分析了两层C／S结构和多层C／S结构的优缺点。

Aiming at the character of vehicle multiple performance detecting test trade, a C/S and B/S combined mode is presented.

针对汽车综合性能检测行业的特点，提出了基于C／S和B／S相结合的模式。

According to time-temperature characteristic of hot stamping, tensile experiments were carried out for hot stamping steel USIBOR1500 at the temperature 600℃~800℃ and strain rate 0.01/s~0.5/s on the test machine Gleeble3800 and corresponding stress-strain curves were obtained.

根据热冲压工艺的时间－温度特征，采用Gleeble3800热模拟系统，在温度600℃~900℃、应变速率0.01/s~0.5/s下，对热冲压钢板USIBOR1500进行热拉伸实验，获得了相应的应力－应变曲线。

Our result has demonstrated that synchrotron X-rays have similar damage effects to SAMs with –CH3 or O=C-OH tail group, and S-Ag bond is much resistant to X-ray induced damage than S-Au bond.

因此，以比较硫-金属键结强度的方法来做为受到同步辐射X光破坏程度的指标，本研究显示：同步辐射X光对-CH3及O=C-OH尾端官能基之硫醇分子的破坏作用相近，且S-Ag键结抵抗X光破坏能力比S-Au为强。

Sewage pump suction pipe and outlet pipe flow of not less than 0.7m / s, and should not be greater than 2.0m / s.

排污泵吸水管和出水管流速不应小于0.7m/s，并不宜大于2.0m/s。

The standard flow channel valve can be used: the United States NIBCO T-580-70 Valve; S-580-70 Valve (2), available to full-flow channel valve indented Path: The United States NIBCO T-585-70 Valve; S-585-70 Valve 2, check valve: Path DN65 valve should be used the following Swing Y-shaped structure, and in accordance with the United States valves and pipe fittings Manufacturers Standardization Society MSS-SP80 standards of manufacture, working pressure 125 lbs class, in line with the United States Society for Testing and Materials Standard Bronze ASTMB62 valve, configuration, Teflon flap valve seat, or seat configuration flexibility of the spring-driven lift-type check valve.

可采用的标准流道阀门：美国尼伯科T-580-70球阀；S-580-70球阀（2）、可采用的不缩径全流道阀门：美国尼伯科T-585-70球阀；S-585-70球阀 2、止回阀：通径DN65以下的止回阀应该采用Y形旋启式结构，并按照美国阀门和管件制造商标准化协会MSS-SP80标准制造，工作压力125磅级，符合美国材料试验协会ASTMB62标准的青铜阀体，配置聚四氟乙烯阀座阀瓣，或配置弹性阀座的弹簧驱动升降式止回阀。

She gently rebuff ed him, but agreed that they could be friends

她婉言拒绝了，但同意作为朋友相处。

If in the penal farm, you were sure to be criticized.

要是在劳改农场，你等着挨绳子吧！