查询词典 RMS

Methods Retrospective analysis of 8 cases confirmed by surgery and pathology of the bladder RMS clinical image data, all patients intravenous urography andor bladder angiography, of which 4 routine CT scan.

回顾性分析8例经手术病理证实的膀胱RMS的临床影像资料，全部病例均行静脉尿路造影和/或膀胱造影检查，其中4例行CT扫描。

To verify the twin CGH test result, a classic autocollimation test with a flat mirror was performed, and its result is 0.333λ PV, 0.062λ RMS.

为验证实验结果的可靠性，利用一平面镜对被测镜进行了自准直检测，结果为PV =0.333λ，RMS =0.062λ。

The text analyses GPS observation model, the characteristic of kinds of errors fountain and the adopting measures in the observation, and processes the thorough research to Bernese GPS Software Ms-Windows Version 4.2. It makes the most stable satellites as the main error. The differential way adopts non-differential way and double differential way. The positioning precision of the single point is decimeter level. RMS is within 0.01~0.02; If the ambiguity right and without week skip, the observation datum of a EPOCH-BY-EPOCH can make the short base line（S0km）positioning precision reach centimeter level.

本文分析了GPS的观测模型、观测量中各种误差源的特点及应采取的措施，并对Bernese GPS Software Ms-Windows Version 4.2 软件进行了深入的研究，它是以最稳定的卫星作为主差，采用非差和双差两种差分方法，单点定位精度在分米级，RMS能在0.01~0.02以内；在模糊度已求解正确条件下，若没有周跳，一个历元的观测数据就可以使短基线（S0km）定位精度达到厘米级。

During the process of model smoothing, there is an uncertain weight threshold, which is discussed in detail for scientific evaluating.2. In the part of "3D Model Segmentation", the vector of Gauss-Mean curvature, that of Max-Min curvature, that of RMS-Absolute curvature are compared through their performances in segmentation.

在三维模型分割方面，对高斯-均值曲率向量、最大-最小曲率向量、RMS-绝对曲率向量等三种特征向量在分割中的性能，以及指定聚类数目对分割结果的影响通过试验进行了比较。

Body weight is used as the basis for standardization to obtain ground reaction force values and impulse values. The original signal of EMG from Rectus femoris, Biceps femoris long head, Tibialis anterior and Gastrocnemius lateral head is processed by DASYLab 6.0 software to band-pass (10-500Hz), full-wave rectification and low-pass filtering (10Hz), after using the formula root mean square to get the root mean RMS value, divided by total gait cycle as the basis for standardization (100%).

肌电讯号由DASYLab 6.0软体分析股直肌、股二头肌、胫骨前肌、腓肠肌等肌群之原始肌电讯号后，进行10-500Hz的band-pass滤波处理，经全波整流上翻、10 Hz低通率波平滑化处理，再利用均方根（root mean square， RMS）公式运算后，可得均方根振幅，并以步态周期中最大肌电值进行标准化处理。

We now have to make some assumptions about the characteristic of the jitter to proceed. One assumption that seems to work is that the jitter amplitude has a Gaussiandistribution. For a jitter waveform that has a Gaussian distribution, there is a point on the Gaussian jitter distribution curve that reflects the RMS value of jitter for Gaussian distribution waveforms, just as with the wave.

一个可行的假定是Jitter幅度具有高斯发布，对于有高斯发布的Jitter波形，高斯Jitter分布曲线上有一点反映了Jitter在高斯分布波形下的RMS值，这点称为"1-sigma值，标准分布"或者"RMS Jitter"值。

The RMS—to—DC transformation is used for collecting virtual value of Ac. The voltage election elects the range of voltage. The analog—to—digital transformation realize transformation of measured voltage to corresponding digital figure. Finally the Sample Digital Display Ac Millivoltmeter is obtained.

其中RMS/DC专用芯AD637用来采集交流有效值转换，电压范围选择模块选择电压量程，模数转换使测量电压转换，最终得到所要求的数字显示交流毫伏表。

The experiment of testing a paraboloidal mirror(Φ140、f/2) with designed CGH is depicted and its test result is 0.406λ PV (peak-to-valley), 0.062λ RMS (root-mean-square).

介绍了所设计加工的双计算全息图检测Φ140、f/2凹抛物面反射镜的实验，其检测结果为：PV =0.406λ，RMS =0.062λ。

By using the KDMRF-1000F MRF polishing machine and KDMRW-1 water based MR fluid,one K4 flat work piece (80 mm in diameter) and one K9 sphere work piece (145 mm in diameter) were polished,experiments show that work piece one has a peak-to-valley value of 55.3 nm and a root-mean-square value of 5.5 nm;and work piece two has a PV value of 40.5 nm and a RMS of 5 nm,which indicates that the surface roughnesses of two work pieces have been improved obviously.

实验显示，样件一面形收敛到PV值55.3 nm，RMS值5.5 nm；样件二面形收敛到PV值40.5 nm，RMS值5 nm；样件的表面粗糙度均有显著改善。结果表明，磁流变修形技术具有高精度、高效率、高表面质量的特点。

Under the stochastic demand, one of the key problems for RMS design is how to design the capacity scalability and storage volume. Based on queuing theory, stochastic market demand model for single product family and production model of manufacturing systems were built. The queuing model and the state probability transition graph of RMS were given.

基于排队论方法，建立了单零件族随机市场需求模型与可重构制造系统的排队模型，给出了RMS的排队模型与状态瞬时强度转移图，建立了平稳条件下系统的概率平衡方程，得到了RMS与柔性制造系统的性能指标。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。