查询词典 RL

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.08-0.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.02-0.05 and 0.2 mm^3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2立方公厘左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.080.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.020.05 and 0.2 mm3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2 mm3左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

The RL's technology is noticeable and helps compensate for the FWD bias weight distribution.

RL上的技术是有目共睹的，它有助于补偿后驱带来的前后轴配重不均，但你感觉它的前面还是过重。

To decide the seeds for the draw of the Olympics the ITTF World ranking list published on 1st of July 2008 (RL 7/08) will be used.

单打项目抽签： 2008 年 7 月 1 日公布的国际乒联世界排名表（ RL 7/08 ）将被用来确定奥运会抽签的种子。

In the actual application systems of measurement, a transient process is created in a RL circuit, and then the frequency and time constant of RL circuits can be accurately estimated using numerical differentiation methods.

深入研究和分析了具有电感和电阻的电流互感器和电压互感器的等值电路，在实际测量应用中人为地造成一个RL电路的暂态过程，采用数字微分算法能够快速准确地算出RL电路的频率和时间常数，进而计算出电流互感器和电压互感器的角差。

The impedance formula of RL-C parallel resonance circuit is deduced theoretically, and some properties of resonance characteristic curve are analysed.

从理论上导出了RL－C并联谐振电路的阻抗公式，由此分析谐振特性曲线性质，并得出文献中引用的RL－C谐振特性曲线成立的充分条件

A theoretical analysis is presented for the factors influencing maximum self-induced EMF in transient process in RL circuit.

对RL电路的暂态过程中影响自感电动势最大值的因素进行了理论分析，并应用不同的仪器和方案进行了实验验证。

Boyd, RL and YS Chun, Eighteen-month evaluation of the effects of a 0.4% stannous fluoride gel on gingivitis in orthodontic patients.

博伊德， RL和伊苏春， 18个月的评估的影响为0.4 ％锡氟化物凝胶对牙龈炎在正畸患者。

Rucker are proficient in their weapon systems (RL-2) and require only the additional environmental training for a forward deployment.

Rucker训练法则的飞行员在RL-2中很精通，只需要增加环境训练来达到更进一步的调度。

Its high-capacity and strong-acid-resistance were proved. In the acid condition, the adsorption efficiency to acide green 6B and direct fast yellow RL reached above 90%. Through the adsorption rate curve on adsorption behavior of the three dyes, they were all according with pseudo-secondary adsorption rate curve. The rate constant of adsorption increased with increasing temperature. Through the adsorption isotherm of the three dyes, acide green 6B and direct fast yellow RL were according with Langmuir equation, while disperse blue 56 was according with Freundlich equation. The adsorption behavior was an endothermic process. Entropy was increasing during the adsorption. So raising temperature was in favor of adsorption.

结果表明，甲醛环氧氯丙烷交联壳聚糖对染料具有较强的吸附性能和耐酸性能，在酸性条件下，对酸性绿6B和直接耐晒黄RL的吸附效率达90％以上；拟合甲醛环氧氯丙烷交联壳聚糖对三种染料的吸附速率曲线，发现该吸附行为符合拟二级吸附速率曲线，其吸附速率常数随温度的升高而增大；通过测定不同温度下甲醛环氧氯丙烷交联壳聚糖吸附三种染料的吸附等温线表明，甲醛环氧氯丙烷交联壳聚糖对酸性绿6B和直接耐晒黄RL的吸附符合Langmuir方程，而对分散蓝56的吸附符合Freundlich方程，甲醛环氧氯丙烷交联壳聚糖对染料的吸附是一个吸热过程，吸附后体系熵增加，升温有利于吸附。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。