查询词典 Pressure

In the steel-steel pressure area, if the paper has a pathwaywas of plaqueand, the pressure is anisotropism.

在钢-钢压区，如果纸页中有高低不平的斑块，压力就不均一。

If this is the pressure between the two is too big or anisotropism, you should adjust the pressure between the two; if it is a blanket of backing make UN-uniform, then it should be resurfacing.

如果是二者之间的不张力功不小或不不平衡，不离答调度两者的不张力；如果是橡皮布的衬垫物铺得不平均，那么不离答轻陈铺匀。

Pyroxene megacrysts formed under the temperatureof 1200.85-1288.85℃ and the pressure between 0.93 and 1.67GPa, amphibole megacrysts crystallizedunder the pressure of 0.83-0,89GPa, temperature about 1000℃, and anorthoclase maybe at thetemperature of 900℃ around.

辉石巨晶形成的温度压力范围分别为1200.85—1288.85℃和O.93—1.67Gpa，角闪石结晶温度在1000℃左右，压力为O.83一O.89GPa之间，歪长石巨晶结晶温度可能在900℃左右。

The questionnaire included age, sex, body height, body mass, waist circumference, hip circumference, systolic blood pressure, diastolic blood pressure, vital lung capacity,steps index, grasp strength, dorsum strength, body anteflexion in sitting position, stand in one leg with eyes closed, vertical jump, push-up, sit-up and reaction time.

项目包括年龄、性别、身高、体质量、腰围、臀围、收缩压、舒张压、肺活量、台阶指数、握力、背力、坐位体前屈、闭眼单脚站立、纵跳、俯卧撑、仰卧起坐和反应时。

Results The direct flow rate reached 0.549L/min when pressure difference was 4.90kPa(500mmH_2O), and the antidromic flow rate only reached 0.028L/min when pressure difference was 4.90kPa(500mmH_2O), the direct flow rate is much more than the antidromic flow rate.

结果：当瓣膜两端顺向的压强差为4.90kPa(500mmH_2O)时，流量可达0.549L/min；当瓣膜两端逆向的压强差为4.90kPa(500mmH_2O)时，流量为0.028L/min，顺向压差的流量大于逆向压差的流量。

It is found that a better performance was obtained when stack was located near pressure antinode, where viscous loss is low and the pressure and velocity match well.

试验表明，板叠位置应接近压力波腹。

Under the given condition of acoustic driver, the acoustic field including oscillating pressure, volume flow rate and acoustic impedance in resonator was theoretically reconstructed by using the two-microphone method. The experiment results validate that this method is applicable and accurate for the positions with non pressure antinode and node in resonator. The maximum errors near antinode and node area are up to 12.4%.

在给定双声源条件下，采用双传感器法对该系统谐振管中的声场参数（包括声压、质点速度、当地声阻抗等）分布进行理论声场重构，并通过实验分析，证实了该方法在等径谐振管内非声压腹点和节点处的适用性和准确性，而在声压腹点和节点处的误差最大达到12.4%。

Optimal pressure and flow in high pressure water generating system were selected, and aperture / slenderness ratio of nozzle was calculated.

合理选择高压水发生系统的压力和流量，计算出喷嘴的孔径与长径比。

Through transformation of parameters, the meshing design system among Hy-Vo silent chain, sprocket and hob was built up based on the research of the pitch increment and the equivalent apothem increment of the effects on the common normal line length when the Hy-Vo silent chain was wrapped around and located on the sprocket, with the proper meshing conditions of Hy-Vo silent chain and sprocket into consideration. The design method of common normal line length was put forward that can be used when the value of the sprocket pressure angle was equal or unequal to the value of the Hy-Vo chain plate pressure angle.

在分析Hy-Vo齿形链链节围在链轮轮齿上定位时其节距增量和当量边心距增量对链轮公法线长度影响的基础上，根据Hy-Vo齿形链与链轮的正确啮合条件，通过参数变化，建立了Hy-Vo齿形链－链轮－滚刀三者之间的啮合设计体系，提出了既适用于链板齿形角等于链轮压力角情况，也适用于链板齿形角不等于链轮压力角情况的Hy-Vo齿形链链轮公法线长度的计算方法。

Apparent error is found in systolic pressure in patients with hypertension, but not in diastolic pressure.

高血压病人的血压较高且有明显动脉硬化者，临床表现与血压不符时，可考虑采用有创法测量血压，以便准确了解病情。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐