查询词典 Pressure

The instruments used ATmega16L onboard A / D converter channels to achieve the cold wind pressure, the hot blast pressure, the furnace top pressure and cold wind current capacity four way analog acquisition;used PWM waveform produced by ATmega16L internal timing / Counter to achieve the entire differential pressure ,the cold wind flow and the permeability index three-way analog output for recording instruments; realized the cold wind pressure, the hot blast pressure, the furnace top pressure, the cold wind current capacity and the entire differential pressure five group parameter tour demonstration and the fixed-point demonstration by key-elect key's coordination during demonstration blast furnace permeable index; produced acousto-optics alarm when the permeable index across the upper and lower limits;used RS-485 realizing the communication with the superior computer.

仪表利用ATmega16L自带的A/D转换通道实现对冷风压力、热风压力、炉顶压力及冷风流量四路模拟信号的采集；通过ATmega16L内部的定时/计数器产生的PWM波形来实现对全压差、冷风流量及透气性指数三路模拟量输出供记录仪表使用；通过键选键的配合在显示高炉透气性指数的同时实现冷风压力、热风压力、炉顶压力、冷风流量及全压差五路参数的巡回显示与定点显示；当高炉透气性指数越上、下限时，仪表产生声光报警信号；仪表采用RS-485与上位机实现通信。

Ning Boheng tells limited company of hydraulic pressure motor is the professional production company that the design makes equipment of system of actuating device of gyrator of winch of motor of hydraulic pressure of type of incurvate line motor, crankshaft, hydraulic pressure, hydraulic pressure, quiet hydraulic pressure, of all kinds hydraulic pressure and hydraulic pressure.

宁波恒通液压马达有限公司是设计制造内曲线马达、曲轴式液压马达、液压绞车、液压回转器、静液压驱动装置、各类液压系统及液压设备的专业制造公司。

The study shows that the pressure transient curve of fractured wells in closed circular formation can be divided into six different flow regimes. In condition of the same fracture opening width and fracture length, compared to rectangular fracture, the pressure drop with tapered fracture is bigger, and the dimensionless pressure and pressure derivative curves are higher. In condition of the same fracture opening permeability, compared to linear declining and constant conductivity fractures, the pressure drop with exponential declining conductivity fracture is the biggest, and the dimensionless pressure and pressure derivative curves are the highest.

研究结果表明：圆形封闭地层压裂井的压力动态曲线可以划分为6个流动阶段；在相同裂缝开口宽度和相同裂缝长度的条件下，与矩形裂缝相比，楔形裂缝压力消耗大，表现为无因次压力及压力导数曲线越高；在相同裂缝开口渗透率的条件下，与导流能力呈线性降低的裂缝以及常导流能力裂缝相比，导流能力呈幂指数降低的裂缝压力消耗最大，表现为无因次压力及压力导数曲线最高。

The purpose of our work is that get the target and technique of pressure adjustment through the analysis of formation porous pressure that affects the quality of cementing, regulation of pressure change for infilling wells, technique of pressure dropping for whole block, technique of pressure discharge for high pressure, maintaining pressure in high pressure and lower penetrability formation.

突出的工作在于通过对影响固井质量的地层孔隙压力的分析得出压力剖面调整的目标，通过注水井降压规律、区块整体降压技术、高压层泄压技术、高渗低压层压力保持方法等几个方面研究提出一套压力剖面调整技术。

The basic of laboratory is for measuring and testing pressure. The main equipments of the lab. are I,II grade piston type pressure vacuometer(Difinity:±0.02%,Test range:0.25Mpa-60Mpa),Digital pressure meter,Test system and microwave tube of dynamic pressure sensor, Intelligent digital pressure verifier.The test for micropressure, low pressure, middle pressure and high pressure can be worked out.

本实验室主要进行压力的计量和测试工作，主要设备有一，二等活塞式压力真空计（准确度：± 0.02%，测量范围： 0.25Mpa— 60Mpa）；数字式压力计；动态压力传感器的标定激波管和测试系统；以及智能数字压力校验仪等仪器；可进行微压，低压，中压以及高压测试实验。

"Hydraulic safety valve" is widely used in hydraulic power systems and hydraulic equipment of safety devices, pressure devices can be limited, is a special valve, which is different from the conventional valve, the traditional use of mechanical valves metal spring as a driving force, can only be limited to low pressure, encountered more BALANCING VALVES than 10Mpa pressure limit pressure can do to increase the volume of pressurized design, the traditional role of the high-pressure valves and high pressure hydraulic power systems and hydraulic equipment The limit pressure of necessity is bulky and complicated structure, difficult to manufacture large, high production costs; in the course of the fatigue of metal spring parameters change fluctuating pressure limiting Ambassador to regular revision to ensure the normal use.

&气动液压安全阀&是目前广泛应用于液压动力系统和液压设备中的安全装置，也可以作限压装置，是一种特殊的阀门，它不同于传统的阀门，传统阀门用机械金属弹簧为动力，只能限中低压力，遇到超过10Mpa以上的压力限压，闸阀只能做加大体积的增压设计，因此传统阀门作用于高压和超高压的液压动力系统和液压设备的限压时必然体积笨重，结构复杂，制造难度大，产品成本高；在使用过程中金属弹簧的疲劳变化大使限压参数波动大，要经常调整才能保证正常使用。

"Hydraulic safety valve" is now widely used in hydraulic power systems and hydraulic equipment in the safety device could also serve as limited pressure device, is a special valve, unlike conventional valves, conventional valves with mechanical metal spring as a driving force, can only be limited to low pressure, the pressure encountered over more than 10Mpa limit pressure can do to increase the volume of the Safety Overflow Valve booster design, the traditional role of the high-pressure valves and high pressure hydraulic power systems and hydraulic equipment The limit pressure of necessity is bulky and complicated structure, difficult to manufacture large, high production costs; in the course of the fatigue of metal spring parameters change fluctuating pressure limiting Ambassador to regular revision to ensure the normal use.

&气动液压安全阀&是目前广泛应用于液压动力系统和液压设备中的安全装置，也可以作限压装置，是一种特殊的阀门，它不同于传统的阀门，传统阀门用机械金属弹簧为动力，只能限中低压力，遇到超过10Mpa以上的压力限压，只能做加大体积的增压设计，因此传统阀门作用于高压和超高压的液压动力系统和液压设备的限压时必然体积笨重，结构复杂，制造难度大，产品成本高；在使用过程中金属弹簧的疲劳变化大使限压参数波动大，要经常调整才能保证正常使用。

One of the following conditions for the second pressure vessel: in the pressure vessel; low-pressure container (only for the extreme toxicity of the medium and highly hazardous); low pressure reaction vessel and the low pressure storage container (only the degree of flammable or toxic medium degree of harm); low pressure shell and tube heat recovery boiler; low glass-lined pressure vessel.

2下列情况之一为第二类压力容器：中压容器；低压容器(仅限毒性程度为极度和高度危害介质)；低压反应容器和低压储存容器(仅限易燃或毒性程度为中度危害介质)；低压管壳式余热锅炉；低压搪玻璃压力容器。

Measurirg indxes included:(1) Electrocardiograh;(2) Hemodynamics: cardiac output, pump output, aortic pressire, pulmo nary artery pressure, left atrium pressure, right atrium pressure, left ventricular end systolic pressure, left ventricular end diastolic pressure, LV-dp/dt, right ventricul ar end systolic pressure, RV-dp/dt, systolic pressure time index, diastolic pressure time index, endocardial viability ratio;(3) Myocardial metabolism: coronory sinus blood flow, myocardial oxygen consumption, myocardial lactate extractiorn;(4) Ischemic myocardial area;(5) Ultrastructure of myocardium.

测量指标包括：①心电图；②血流动力学：心输出量、泵输出量、主动脉压、肺动脉压、左房压、右房压、左室收缩末压、左室舒张末压、左室压的一阶导数、右室收缩末压、右室压的一阶导数、收缩压力时间指标、舒张压力时间指标、心内膜下心肌供血比率；③心肌代谢；冠状窦血流量、心肌氧耗量、心肌乳酸摄取量；④心肌缺血面积检查及缺血心肌的超微结构观察。

Hemodynamic parameters including heart rate, cardiac output, systolic blood pressure, diastolic blood pressure, mean arterial pressure, central venous pressure,right ventricular end-diastolic pressure,left atrial pressure, and left ventricular end-diastolic pressure were monitored and recorded at 5, 60 and 180 min after cardiac resuscitation with PUCA pump.

结果无辅助、延迟辅助和即时辅助复苏持续时间分别为(38.3±5.8) min、(43.5±9.2) min和(48.7±23.8) min，3组比较差异无显著性(P＞0.05)；3组成败比分别为0/3、0/2和5/1，差异有显著性(P＜0.05)。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。