查询词典 Phosphor

In electronics, the ability of the CRT phosphor dots to withstand local over- heating due to the conversion into heat of the residual energy of the electron beam, i.e. that part of the electron beam energy that is not converted into visible light.

在电子学中，指阴极射线管的荧光粉承受局部过热的能力，这种过热是由于电子束的残余能量，即电子束没有转变成可见光的那部分能量，转变成了热。

In electronics, the ability of the CRT phosphor dots to withstand local over- heating due to the conversion into heat of the residual energy of the electron beam, i.e.

在电子学中，指阴极射线管的荧光粉承受局部过热的能力，这种过热是由于电子束的残余能量，即电子束没有转变成可见光的那部分能量，转变成了热。

Display technology whereby a rapidly moving electron gun inside the set passes across the screen, casting a beam that lights selected phosphor dots as it moves.

展示技术凭此一个迅速移动的电子在设备里面的枪掠过萤幕，铸造一根梁当它移动时，那灯选择磷光点。

The most common cause of moire is the interference between scanning lines and some other periodic structure such as a line pattern or dot pattern in the original scene, a mesh or dot pattern in the camera sensor, or the phosphor dots or other structure in a shadowmask picture tube.

引起莫尔条纹最常见因素是扫描线和某些其它周期性波纹之间的干扰，如原场景中的线或光点图形、摄象机传感器中的网纹或光点图形、遮蔽屏摄象管中的闪烁光点或其它波纹。

To solve the problem of complex process and high fabricating cost in the current fabrication techniques of carbon nanotube displays, a fully printing technique was presented to fabricate CNT-FED. All the inner structure cells, including cathode and anode electrode patterns, CNT arrays, phosphor dots and cathode and anode spacer, were fabricated by a screen printing process.

针对现有的碳纳米管场发射显示器制造技术中存在的工艺复杂、成本过高的问题，提出了用于制造碳纳米管场发射显示器的全印刷制造技术，即采用丝网印刷工艺制备CNT-FED器件内部包括各电极图形、碳纳米管阵列、荧光粉点阵和绝缘支撑层在内的所有结构。

The experimental results prove that the excitation efficiency across the phosphor of the device is not homogeneous, and its variation depends on the applied voltage.

分析表明低压驱动电致发光的机理是由于发光层中电场强度的不均匀分布。

Adding coagulation into bioreactor can enhance the removal efficiency of phosphor.

投加混凝剂可以显著提高工艺对磷的去除效率。

After long-term use of CRT monitors, three on-screen changes in the efficiency of light-emitting phosphor, or circuit board of a number of changes in component parameters, such as red, green, and blue driver transistor state changes may result in display color cast.

CRT显示器长期使用后，屏幕上的三种荧光粉发光效率发生变化，或电路板上的一些元件参数发生变化，如红、绿、蓝三色驱动三极管状态发生变化，都可能导致显示器偏色。

The initial luminous efficiency of the phosphor increases by about 2%, and reliability of packaged LED is improved, attenuation of luminous efficiency degrades 6%.

结果表明，表面处理使硅酸盐荧光粉的初始发光强度提高约2%，可靠性也有所提高，可使封装后的 LED 的光衰减少6%。

A large fraction of the cathodoluminescent can be directed through the untextured front surface of the crystal.An improvement in phosphor efficiency by a factor of 2.3 has been achieved.

在详细分析了这种理想发光模型之后，采用晶体的各向异性腐蚀工艺形成了具有近似这种结构的网状刻面屏，外发光效率提高到原来的2.3倍。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。