查询词典 N.C.

H.伸缩环转动环伸缩环垫片前轴封 S D / L D / S L M E C H A N I C A L S E A L P U M P S SD/LD/SL SERIES PUMPS The SD/LD/SL series are dependable, self priming pumps. The full motor horsepower is translated into fow via the shaft. These pumps are used for a wide range of applications, from chemical transfer to process solution recirculation to waste treatment. This series is capable of self-priming up ro 20 feet of lift. The mechanical seal is a self-cooling, Tefon bellows which is cooled by the solution being pumped. The construction materials and seals avaiable make this pump extremely versatile. The horizontal design has a working temperature from167℉ to 194℉(75℃ to 90℃), depending on the material of construction, and can handle most chemical solutions. The SD/LD/SL series pumps are designed to run outside the tank or process module. The SD/LD series pumps incorporate a FRPP molded base, legs and pump-to-motor casing. There are no bolts or metallic parts in contact with the solution being pumped.

SD/LD/SL泵是可靠的自吸泵，马达全部的马力经由轴心完全转化为流量，此型泵广泛地使用於从化学药水循环或加工溶液循环到废水处理等各种用途，此型泵可自吸达20英呎，机械轴封是自我冷却的，经由抽送的溶液来冷却，可供应的不同结构材质及轴封使此种泵的用途非常多样化，依其结构材料的不同，其卧式设计的工作温度由75℃到90℃(167℉到194℉)，而且可处理绝大部份的各种溶液，SD/LD/SL是设计用於槽外或加工模组之用，SD/LD加入一个FRPP射出成型的脚座，脚架及泵到马达的外罩，没有螺栓或金属会接触到所抽送的溶液。

After supper, in a school dormitory, Jeff is c 7 hatting with stu-de 北美文学网 nts A n , B and C yz

晚饭后，在学校宿舍里，杰夫与学生甲、乙、丙在聊天。

Results showed that with decreasing ability of the leaving group from iodo, Br, Cl, OAc to N+(CH3)3I-, the SN2 O-alkylation or C-alkylation was inhibited, and the SRN 1 path, leading to C-alkylation, was facilitated.

结果表明，离去基团的离去性能降低，SN2烷基化或烷氧基化受抑制，而是有利于SRN 1途径，使烷基化容易发生。

The yield of 〓-methoxyl or m-nitrocinnamic acids obtained from methoxycarbonylmethylenephosphonates and corresponding substituted benzaldehydes in the presence of is 11% or 13% higher than that obtained from those reactions without catalyst.

〓 [注：表中ρ、〓和C为式（2-5）中的相应系数和常数；γ为相关系数，F为F比值，〓为相应系数ρ、〓和C的偏差，〓和〓为相应系数的T检验，CL为置信水平，n为相关点数。表听数据系使用BJORK'S（1967）程序于Z-80计算机上计算结果。]

The method is as follows: n-butyl titanate, absolute ethyl alcohol, surfactant and concentrated hydrochloric acid are fully mixed and stirred for 4 to 6 hours under room temperature to obtain precursor solution, then the precursor solution is spinningly coated on a clean conductive glass substrate of an indium oxide tin coating, and then the conductive glass spinningly coated with the precursor solution is preserved for 25 to 72 hours at the temperature of between 20 and 30 DEG C and the relative humidity of between 50 and 75 percent below, and finally undergoes a high-temperature calcination at the temperature of between 350 and 700 DEG C.

将钛酸正丁酯，无水乙醇，表面活性剂和浓盐酸充分混合，在室温下搅拌4小时-6小时得到前驱剂，然后将前驱剂旋涂在清洁的氧化铟锡镀层的导电玻璃基底上，接着在20℃-30℃，相对湿度在50％-75％下，将旋涂有前驱剂的导电玻璃保存24小时-72小时，最后经过350℃-700℃高温煅烧。

As CAAX-mimetics, 1, 3-dihydro-5-phenyl-2-H-1, 4-benzodiazepin-2-one was modified by linking carboxyl groups with various carbon through N-1 and C-3, 3-(imidazol-4-yl) propion amido group with different substituents was connected at C-7; In the synthesis of bisubstrate analogues, thiocarbamido compounds was alkylated by alkyl iodide and then hydrolyzed to give alkylthiol benzoate compounds.

1，4-苯并二氮杂草-2-酮类化合物的合成过程中分别对其1、3、4和7位进行了基团变化，在1和3位连接不同长度含羧基或酯基的侧链，在7位连接不同取代的咪唑丙酰氨基。在苯甲酸硫醇酯化合物合成过程中，建立了一种硫原子连有不同长度碳链的苯甲酸硫醇酯的合成方法。

Two series of polyurethane acrylate grafted acrylic resins (Acr-g-TPU-PETA and Acr-gPPU-PETA) self-emulsifying systems are obtained by grafting -NCO group modified polyurethane acrylates with acrylic copolymer prepared from n-butyl acrylate, styrene,βhydroxyethyl methacrylate and acrylic acid The self-emulsifying systems showed Newtonian fluidity with viscosity closed to that of water, the solid contents were around 30% The T〓 of 15～4℃ for dried film before photocuring favored film formation at room temperature DSC and DMA results showed that PU-PETA is compatible with acrylic resin in the grafted resin The TG and dTG curves for Acr-g-PU-PETA samples were substantially different from the corresponding blends, and the brodened dTG peaks for photocured grafted resin suggest that there might be multiple interactions among chain segments The photocued film of the grafted resins self-emulsifying system exhibited good overall properties with polyurethane acrylate grafts ranging from 30% to 50%, and Acr-g-TPU-PETA series showed better properties than Acr-gPPU-PETA series The adhesion of the photocured film was 1～2 grade, impact strength was 50kg-cm and flexibility was 1mm The Shore hardness and the adhesion of the film decreased markedly if PETA was replaced by HEMA as photoactive group due to the lower C=C double bond content in the grafted resin The polyhydroxy amine-linked thioxanthones photoinitiators can be evenly dispersed in self-emulsifying system without color spot appearing in the dried film The films photocured with IV〓～IV〓 generally exhibited higher Shore hardness, gloss and solventresistance than that cured with Irgacure 2959 and did not induce the rusting of the iron substrate Pigmenting with titanium oxide had no effect on the photocuring The polyhydroxy amine-linked thioxanthone IV〓 and IV〓 can be new candidates for the formulation of titanium oxide pigmented photocurable water-borne coatings for their pale-yellow appearance and slight interference with the color of the coatings WB 4759 with high water-solubility coalesced and separated from the dried resin film, and even induced the rusting of iron substrate.

以丙烯酸丁酯，甲基丙烯酸-β-羟乙酯，丙烯酸及苯乙烯合成厂丙烯酸共聚树脂，并与含-NCO端基的聚氨酯丙烯酸酯接枝反应，经水性化后，得到两个系列（Acr-g-TPU-PETA和Acr-g-PPU-PETA）各5个不同配比的丙烯酸树脂接枝聚氨酯丙烯酸酯自乳化体系，粘度与水相近，为牛顿流体，固含量30％左右。光固化前干燥涂膜的玻璃化转变温度在-15℃～4℃之间，有利于室温下成膜。DSC及DMA谱表明两种树脂基本相容。Acr-g-PU-PETA的热失重行为明显不同于共混材料，接枝样dTG峰明显宽化，表明接枝样中链段之间的相互作刚有多重性，丙烯酸树脂与聚氨酯之间有一定的相容性。接枝树脂自乳化体系光固化涂层的综合性能以聚氨酯丙烯酸酯成分为50％～30％者相对较好，且以Acr-g-TPU-PETA系列更理想。光固化膜的附着力为1～2级，冲击强度为50kg·cm，柔软性多为1mm。以HEMA代替PETA作为接枝树脂的活性基团，碳—碳双键密度太低，光固化膜交联点太少，硬度和附着力均较差。多羟基胺连硫杂蒽酮光引发剂能均匀分散于树脂自乳化体系和接枝树脂干膜中，不出现色斑，光固化膜肖氏硬度一般高于以Irgacure 2959为光引发剂的光固化膜，光泽度及耐丁酮溶剂性能均有所提高，不会诱导铁基生锈，钛白着色对光固化结果几乎没有影响。本论文所合成的多羟基胺连硫杂蒽酮光引发剂IV〓与IV〓为浅黄色，对光固化涂层的颜色干扰较小，为配制钛白着色光固化水性涂料提供了新的光引发剂。水溶性太强的WB 4759在干膜中易聚结析出，且对所附着的铁基有诱导锈蚀作用。

Not that anyone on the faculty at C.C.N.Y. is any great shakes, but some of those coeds ...

倒不是说这个人是'纽约城市学院'教员里的某个人就真有多可怕，主要是那些个八卦小女生。。。。。。

BOSTON -- Chien-Ming Wang may never receive the kudos generally lauded upon the game's top hurlers, his high winning percentage overlooked as a result of pitching toward contact instead of the league lead in strikeouts.

c2 i2 ？2 C f# C， T9 N Wwww.wangfans.com 王建民或许没有得过球赛最好投手这样的名声，从他的投球虽不能看出他在大联盟的三振率，但却可以看出他的高胜投率。

Alkylbenzene, normal alkanes and alkylcyclohexane on the pyrolysates of P. Boryanum at 300℃ had uniform distribution and the relative content of them was similar, indicating that they originated from same precursors. Fatty acids, alcohol and ketone in algal cell are the possible precursors. For example, the precursor of relatively abundant C〓 alkylbenzene and alkylbenzene with C〓 side chain perhaps related with palmitic acid. N-alkylnaphthalene in pyrolysates at 300℃ probably derived from alkylation of cleavage products of aromatic steranes and terpanes.

在盘星藻300℃热解产物中，烷基苯、正烷烃和烷基环己烷碳数分布一致、各化合物的相对含量接近，表明它们有相同的来源，藻类体内的脂肪酸、醇和酮及细胞壁等物质可能是其母质，相对含量较高的碳数为16及侧链碳数为16的烷基苯类化合物，其前身物可能与软脂酸有关。300℃热解产物中的正烷基萘类化合物，可能由芳香甾、萜类的降解产物与直链烃类加成烷基化而形成。

The basic concept of FOP can be summarized as to further optimize effective prescription according to the standard of curative effects and with the aid of modern science and technology and theories of traditional Chinese medicine.

其基本内涵可概括为：以确有疗效的中药复方为研究对象，以现代科学技术和传统中医药理论为技术支持，以该复方所治病证的药效响应为评价标准，以优化重组疗效更优的新复方为研究目的。

Ever since our world has been a world, native forests have been indiscriminately exploited by man.

自从我们的世界一直是世界原生森林被任意剥削人。