查询词典 Mises

According to the calculated result, the metal flowing law, von Mises stress and the formed outer diameter of involute spline were forecasted; also the errors between the simulation result and the object dentiform of involute spline were analyzed.

根据数值模拟的结果，讨论了齿形误差及其成因；揭示了滚轧过程中金属流动规律和应力变化情况；分析了冷滚轧前轴坯直径与成形后花键最大外径的关系，提出了轴坯直径的修改建议。

On Mises stresses were computed, and alues between dural and dorsal layers were compared.

把on Mises应力进行计算机处理，并对硬脊膜层和背层的数值进行了比较。

Flora-Endangered plants of Belarus／ Flore-Usines mises en danger de la Bélarus On June 8, 2009 the Ministry of Communications and Informatization of the Republic of Belarus will issue 2 stamps...

如果硬要将世上的人分成两类的话，除了男人/女人这个区分之外，大概还可以分成为有送礼物习惯的人，和没有送礼物习惯的人。

In this study, the position of implant inclined to the lingual side slightly. When torque force was exerted on implants the lingual, buccal, and mesiodistal maximum Von-Mises stress were 0.65MPa, 0.624MPa and 0.603MPa, respectively.

由于本实验中种植体种植的部位略偏向舌侧，当种植体受到扭力作用的时候，其舌侧、颊侧及近远中侧的最大Von-Mises应力分别为0.65MPa、0.624MPa、0.603MPa。

The criterion is similar to hyperbolic strength criterion including uniaxial compression strength and uniaxial tensile strength, which is an extended form of Griffith-Murrell criterion essentially under the condition of polyaxial stress when hydrostatic pressure is lower, and it represents the first failure type. However, the criterion is similar to generalized Mises criterion when hydrostatic pressure is higher, and it represents the second failure type. The transition part between the two criteria represents the third failure type when hydrostatic pressure is high.

该准则包含单轴抗压和抗拉强度，在静水压力较低时，实质上它是Griffith-Murrell准则在多轴应力状态下的一种扩展形式，反映脆性岩石破坏类型1；在很高静水压力下该准则可转化为广义Mises准则，反映脆性岩石破坏类型2；而当静水压力较高时，该准则处于上述两种准则的过渡阶段，反映脆性岩石破坏类型3。

Under the concentrated loading, the maximum von Mises stress in all of the four models was located on the crestal region around the neck of the implant adjacent to the pontic.

四单位种植固定桥应避免远中悬臂设计方案，在本实验所似设的条件下，植入方案力学分布更为均匀。

Firstly, a formula is presented in this paper, for theultimate strength of T-shaped unstiffened CHS-RHS joint under out-plane bendingload. The yield line model based on flexural failure of the chord face, is assumed onthe basis of Von-Mises stress distribution on the chord face.

本论文在有限元数值计算基础上，根据主管表面的应力分布，假定了基于弦杆表面塑性破坏模式下的节点屈服线模型，推导了平面外弯矩作用下非加劲节点的极限承载力公式，与有限元计算结果非常接近。

The large deformation contact non-linearity model of the rubber was constituted, and the relationship between the contact pressure and compression ratio, the change of the Von-Mises stress was found in precompact situation.

以ANSYS软件为工具，建立了橡胶材料的大变形接触非线性模型，得出了预紧状态下O形密封圈的接触应力和压缩率之间的曲线关系，当量应力的变化。

From FEM, the contact stress obeys the semi-ellipse distribution and the Mises stress and shear stress are also consistent with contact mechanics theory, but there exists offset or deflection in the symmetric lines of stress distribution, which originates from tooth bending deformation.

由有限元方法得到的渐开线轮齿的接触应力符合Hertz理论中的半椭圆分布规律，Mises应力和剪应力分布也符合接触力学理论，但应力分布的对称中心存在偏离或者偏斜现象，分析认为，是由于轮齿弯曲变形造成的。

At the same time, for the polishing plate of diamond film with the same thickness, von Mises equivalent stress and the radial displament show a ascending tendency with the increase of rotating speed, but the axial displacement firstly increases and then decreases.

同时，对于同一厚度的金刚石膜抛光装置，随着转速的提高，von Mises等效应力和径向位移呈现相似的上升趋势，轴向位移却先上升后下降。

In contrast to the ubiquitous rising-sun-with-rays military flag of the Japanese, Chinese banners and ensigns feature a range of designs.

与遍地都是的太阳军旗不同，中国人的旗帜和徽章设计得各式各样。

From their small corner of Feng's Guangzhou headquarters -- a jumble of pink leashes, squeezable rubber steaks, and plastic doggy Santas for Fido's stocking -- Soleil's designers come up with at least five new products a month.

从Feng 设在广州总部的产品展示柜台上可以看到，Soleil的设计师每月至少设计出5件新产品。