英语人>网络例句>Mises 相关的网络例句
Mises相关的网络例句

查询词典 Mises

与 Mises 相关的网络例句 [注:此内容来源于网络,仅供参考]

Following our result, the KS test and Cramér-von-Mises test got the best testing outcome excluding the Cauchy, student's t and Logistic distribution, and Cramér-von-Mises test is better than KS test.

根据我们的模拟结果可知,除了柯西、t及逻辑斯分布之外,KS检定法和Cramér-von-Mises检定法有较好的检测效果,并且以Cramér-von-Mises检定法优於KS检定法。

Methods A wet hip joint's sample from corpse was scaned by CT and all images of every cross-section hip joint's layer was obtained, and an hip joint's model was contructed with Unigraphics NX 2.0 and Solid Works 2006 SP 0.0 software. The models were assembled when simulated total hip arthroplasty after total hip joint prosthetic and ischiofemoral ligament model had been constructured. Analysis was done on von Mises stress distribution and amount of total hip component when simulated seated leg-crossing manuver. The bone and metal components were meshed as rigid bodies, composed of three-dimensional, all-quadrilateral rigid body elements, and hip joint capsule ligament was fully three-dimensional, hexahedral continuum elements representations. Results The current form of this ischiofemoral ligament's reconstruction finite element model provided for multi-body contact, large displacement interfacial sliding, large deformation capsule ligament representation, and clearly reflected the real ischiofemoral ligansent's anatomy and biomechanical behavior. The maximum on Mises stresses at the joint interface was more than that fur an otherwise identical hardware-only construct.

选择成人尸体髋关节行CT成像得到髋关节每层横截面图像,提取边界坐标,利用有限元分析软件Unigraphics NX 2.0和Solid-Works 2006 SP0.0构建出髋关节三维有限元模型及人工髋关节假体,并模拟全髋置换术进行装配,将坐股韧带按其术中重建位置进行构建骨骼与金属模型采用三维十节点四面体实体单元进行网格划分,关节囊六面体连接单元划分,模拟坐位腿交叉动作载荷获取假体撞击过程的角活动度和相应的von Mises应力分布情况结果所构建的多体连接、大界面划移、大变形的坐股韧带重建有限元模型,客观反映坐股韧带真实解剖形态及生物力学行为,增加坐股韧带重建的模型其关节面的最大主应力值大于仅有金属的模型。

This paper solved the optimum installed angle anchor bar in anchored joint by considering the shear dilatatility of joint and utlizing the Mises yield criterion.

本文根据基本理论分析,考虑节理的剪胀效应并利用 Mises屈服准则求解得出了加锚节理面抗剪的最优安装角。

The Von Mises angular function is used to describe the angular correlation for the distributed source and derive a novel distributed source model from the quantitative angular correlation.

利用阵列接收信号协方差阵的特征值分析了源内角度相关程度对有效信号子空间的影响。

The lower von Mises stress in the calcar region was found at the stovepipe models with a low flare stem (8.78MPa for thick and 8.23MPa for thin cement technique).

在同组模型之股骨calcar 之von Mises 应平均较低(厚骨水8.78MPa 和薄骨水8.23MPa 。

Carried out generalized Mises yield criterion , yield curve on the n flat face was circle curve, and different elected parameters correspond to external angular point circumcircle、 internal angular point circumcircle and incircle of Mohr-Coulomb unequiangular hexagon. According to unequiangular hexagon, circle yield curve which had the same area as hexagon can be found, and corresponding yield criterionwas equilateral circle yield curve.

3广义米赛斯准则在π平面上的屈服曲线为圆曲线,选择的参数不同对应有莫尔—库仑不等角六边形的外角点外接圆,内角点外接圆和内切圆,对于不等角六边形,还可以找到一个面积和六边形相等的圆屈服曲线,对应的屈服准则为等面圆屈服曲线。

Concave design showed better stress performances than convex design both on values and distributions. Rotational freedom was confined by elliptic geometry and resulted in 61.36 MPa von Mises stress, which was larger than the other motions except flexion.

在椭圆曲面设计的分析方面,因其几何外型的限制,在旋转动做下发生了相当高的von Mises应力(61.36MPa),仅次於该设计於前弯动作下时之值。

The results show as follows: Due to unfitting between the wheel tread and profile of Frog No. 9, two-point contact occurs between the wheelset and frog and the contact patches become narrow and long; the Von Mises stress and contact force in the area of the contact patch between the tread close to the flange and the frog are so great that they go far beyond the yielding limit and enter the plastic deformation stage; this will lead to serious wearing of wheelset treads and frogs.

结果表明,由于车轮踏面与9号辙叉的型面不配合,轮对与辙叉形成两点接触,且接触斑狭长,靠近轮缘处踏面和辙叉接触斑的应力及接触力非常大,其数值远远超过材料的屈服极限,进入塑性变形阶段,这将导致车轮踏面与辙叉的磨耗严重。

Results of the analysis and calculation show that results via von Mises model are approaching to that coming from Drucker -Prager model on certain total stress level, so that the grouser effect in a three-dimensional space can be analyzed.

分析和计算结果表明,在一定的总应力水平的情况下,运用von Mises模型,仍可望得到和 Drucker -Prager模型大体一致的结果,这就为履刺效应的三维分析创造了条件。

This thesis mainly discuss following issues, Theory and simple expressions for array covariance matrixes are derived when angular spread functions are symmetric distribution functions, i. e. the Uniform distribution, the Gauss distribution, the Laplace distribution and the Von Mises distribution, and a non-symmetric distribution function, i. e. the Gamma distribution. And the relation between the effective signal subspace and the array number, or and the nominal angle of the distributed source, the angular spread, the distributed functions, and the Signal-to-Noise Ratio is gained. The dimension of the effective signal subspace increases with increment of the array number. And it is more obvious to the non-symmetric distribution. The dimension of the effective signal subspace decreases with increment of the nominal angle. And the distributed source is equal to a point source as θ=π/2. The dimension of the effective signal subspace increases with increment of the angular spread.

本论文针对阵列信号处理中广泛存在的分布源现象,主要讨论了以下问题:推导了角度分布函数分别为对称的均匀分布、高斯分布、拉普拉斯分布、Von Mises分布和非对称的伽马分布时,分布源阵列接收信号协方差阵的严格模型和简化模型,得到了单个分布源的有效信号子空间随阵元数、分布源中心角、分布角、角度分布函数和信噪比的变化规律:随着阵元数的增加,对所有角度分布函数的有效信号子空间维数也随着增加,且非对称分布函数的有效信号子空间充满整个空间的可能性更大;随着分布源中心角逐步增加,有效信号子空间维数逐步减小,当θ=π/2时,等价于点源情形;随着分布源分布角逐渐加大,有效信号子空间维数也随之增加,直到有效信号子空间充满整个空间;随着信噪比的增加,有效信号子空间维数有一定程度的减少。

第1/7页 1 2 3 4 5 6 7 > 尾页
相关中文对照歌词
L'école Des Points Vitaux
L'endurance
推荐网络例句

In the days of sailing vessels the crew were afraid they would be becalmed on the ocean.

在使用帆船的时代,船员们担心他们会因为无风而无法在海洋上航行。

As long as foreign donors pay the PA's salary bill, few expect a new intifada.

只要外国继续为巴权力机构的薪水买单,希望发动新暴动的人便寥寥无几。

Speak with contempt of none,form slave to king,the meanest bee,and will use,a sting.

别用 言词贬低任何人,无论国王还是奴隶。最卑戝的蜜蜂也会用它的毒针蜇人。