查询词典 Min

Al-Si alloy wires with uniform cross section and very fine grains could be fabricated stably under the conditions that the interior diameter of nozzle was 0.25-0.5mm, Ar pressure was about 0.4MPa, cooled liquid flowing rate was 400r/min, melt jet flying distance was 5-10mm, melt jet entrance angle was 35°~45° and the melt superheat degree was 100~150℃.

结果表明，在喷嘴直径为0.25~0.5mm、氩气压力为0.4MPa、旋转鼓转速为400r/min、合金液飞行距离为5~10mm、合金液入射角为35°~45°及合金液过热度为100~150℃的条件下，可稳定获得横截面圆整一致、晶粒细小的合金线。

The results showed that the Xa-min gene had broad-spectrum and was highly resistant to diverse Xoo isolates.

结果表明，Xa-min是一个广谱、高抗的白叶枯病抗性基因。

The treadmill training of T-group rats were continuously trained for 4~6 weeks at the intensity of about 75% VO2max (185～24m／min,gradient of 0°,each motion lasting 50 minutes,twice a day).

运动训练组大鼠进行连续4～6wk强度约为75％VO2max18.5～24m／min，坡度为0°，每次运动50min

The treadmill training of T-group rats were continuously trained for 4~6 weeks at the intensity of about 75% VO2max (18??5～24m／min,gradient of 0°,each motion lasting 50 minutes,twice a day). Detect the content of gastrocnemius MHC mRNA by gastrocnemius reverse transcription polymerase chain reaction,and detect the changes of MHC muscle fiber and its size of cross section area through immunohistochemistry. Meanwhile,apply the electric stimulation to determine the maximal tension of isometric contraction of post-training gastrocnemius.

运动训练组大鼠进行连续4～6wk强度约为75％VO2max(18.5～24m／min，坡度为0°，每次运动50min，每天2次)的跑台训练，反转录聚合酶链式反应腓肠肌MHC mRNA含量，以免疫组化方法检测肌球蛋白肌纤维的改变情况及横截面积的大小，同时运用电刺激观察训练后腓肠肌等长收缩最大张力。

The optimal medium components were: sodium alginate 3 g/L,(NH4)2SO4 3 g/L, NaCl 20 g/L, KH2PO4 0.1 g/L, CaCl2 0.1 g/L; The optimal culture conditions were: 25 ml medium in 250 mL Erlenmeyer flask, inoculum's volume 3%, shaking speed of 150 r/min, initial pH 7.5, at 28°C for 24 h.

该菌株产酶的最佳培养基组成为：褐藻胶3 g/L、(NH4)2SO4 3 g/L、NaCl 20 g/L、KH2PO4 0.1 g/L、CaCl2 0.1 g/L；最佳培养条件为：250 mL三角烧瓶中装液量25 mL、接种量3%、摇瓶转速150 r/min、pH7.5、培养温度为28℃、培养时间为24 h。

After cultivated in the optimized medium (soy power 1.5, corn power 1.5, NaCl 1,K2HPO4 0.01, KH2PO4 0.01, CaCl2 0.4, span40 0.1,pH 10.0) at this condition (50℃,with shaking 180r/min) for 72 h in 100 mL erlenmeyer flask, the activity ofα-amylase obtained 105U.

经优化培养基(g/100 mL)(黄豆粉1.5，玉米粉1.5， NaCl 1， K2HPO4 0.01， KH2PO4 0.01， CaCl2 0.4，司盘40 0.1，pH 10.0)在50℃、装液量10%、180 r/min的摇床培养72 h后，测得酶活105 U。

The optimum fermentation conditions for HA07009 were initial pH7.0, seed age 48h, 8% inoculation amount, and the size 75 ml in 250ml Erlenmeyer flask at 200r/min, 6d.

发酵培养条件为：初始PH7.0，种龄48h，接种量8%，摇床转速为200r/min，250ml三角瓶装液量75ml，发酵培养时间6d。

The optimum inoculation conditions for HA07037 were initial pH7.0, seed cultural time 48h, 10% inoculation amount, and the size 75ml in 250ml Erlenmeyer flask at 200r/min, 6d.

发酵培养条件为：初始pH7.0，种龄48h，接种量10%，摇床转速为200r/min，250ml三角瓶装液量75ml，发酵培养时间6d。

The optimum culture medium components of DA07405 contained glucose 1.0%, sucrose 0.5%, corn powder 0.5%, soybean powder 0.75%, K2HPO4 0.05%; The optimum fermentation conditions of DA07405 were initial pH7.0, seed age 48h, 12% inoculation amount, the size 75mL in 250mL Erlenmeyer flask at 200 r/min and 28℃ for 5d.

确定菌株DA07408的最佳培养基配方及发酵条件为：葡萄糖1.0%，甘油1.5%，玉米粉0.75%，大豆粉0.75%，K2HPO4 0.05%，初始pH值7.0，种龄48h，接种量10%，200r/min发酵5d，培养温度28℃，250mL三角瓶装液量75mL。

With the single factor test and orthogonal test, the optimal culture media for HF3-04 strain producing agarase was decided as: agar 3‰, NH4NO31‰, Na2HPO4 0.5 mM, pH 8.0. The optimal fermentation conditions were inoculum size 3‰, 110ml medium in 250mL Erlenmeyer flask, rotation rate 150r∕min, culture time 48h,culture temperature 25℃.

通过正交试验确定其最佳培养基组成为琼胶3‰、硝酸铵1‰、磷酸氢二钠0.5mM、pH值8.0；该菌株的最佳培养条件为接种量1%、装液量为250ml三角瓶装入110ml发酵培养基、摇床转速150r∕min、培养温度25℃、培养时间48h。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。