查询词典 Min
- 与 Min 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Due to the short-run properties of continuous improvement and high-quality development and application of new materials, rotogravure, Rotary die-cutting device is currently used for blocking the liandong production speed somehow 180mm/min.
由于烫印材料性能的不断改进和高品质新材料的开发应用,卷筒纸圆压圆模切、烫印联动生产设备目前的最高速度已能达到180mm/min。
-
But the area under curve value of rutin recovered in lymph, 359.3 ± 41.0 min.
但是芸香素在淋巴液中计算出的曲线下面积为359.3 ± 41.0 min。
-
The result makes clear: CF surface acidity is luscious it is good to increase and increase effect of acid treatment of; thick saltpetre what round amount handles time as thick nitric acid to oxidize than air, when the time that handles CF when thick nitric acid is 20 Min, tensile strength of CF/TPI composite material and flexural strength rise respectively 10% with 14%, XPS shows CF surface active is right now luscious the group increases than was not being handled 35.89%.
结果表明:CF表面酸性官能团的数量随着浓硝酸处理时间的增加而增加;浓硝酸处理效果比空气氧化好,当浓硝酸处理CF的时间为20 min时,CF/TPI复合材料拉伸强度和弯曲强度分别提高10%和14%,XPS表明此时CF表面活性官能团比未处理增加35.89%。
-
Description: 1 Knife roller material: powder metallurgy high-speed steel; 2 Diameter of knife roller: 150-250 ; 3 Speed of knife roller: 200m\min; 4 Service life of knife roller: 1 million blades per time; 5 Scope of application: paper, sanitary belt and diaper, etc; and 6 Technologies:(1) sintering and forging of powder metallurgy high-speed steel;(2) vacuum high-pressure gas-quenching heat treatment.
内容说明:1,刀辊材料:粉水冶金高速钢;2,刀辊直径: 150-250 ;3,刀辊承受速度:为200m\min;4,刀辊单次复磨使用寿命1000万片/次;5,运用范畴:纸类,卫生巾,尿裤等设备;6,需解决技术:①粉末冶金高速钢烧结和锻打②真空高压气淬热处理技术。
-
The minimum spermicidal concentration being(0.05 mg/ml) in(3 min) of the sasanqua saponin sterilant was corresponded with nonoxynol spermicide and was lower than mandelic acid(0.1 mg/ml and citric acid(0.25 mg/ml.
结果 油茶皂素不育剂对雄性小鼠呈现出较优的剂量依赖性体外杀精活性,3 min时的最低杀精浓度为0.05 mg/ml,与人用杀精剂壬苯醇醚相当,比扁桃酸(0.1 mg/ml)和柠檬酸(0.25 mg/ml)低。
-
Fish were fed twice daily (0800 h and 1600 h) to visual satiation within 40 min each time for 8 weeks.
试验期间每天投喂两次(8:00和16:00),每次投喂时间约为40 min,以饱食状态为准。
-
Fish were fed twice daily (08:00 and 16:00) to visual satiation within 40 min each time.
试验采用饱食投喂方式,每天投喂两次(08:00和16:00),每次40 min左右。
-
The lifting speed of single anchor or double anchor shall not be less than 9m/ min when the anchor pull up from the sea bottom. Check the anchor whether is good stick together with anchor recess when the anchor pull into the anchor recess, check the position of housing stopper whether is right, and weather the anchor fix device and housing stopper is reliable.
当锚从海底拉出后,单锚或双锚的速度不少于9m/min,当锚拉上锚穴后,检查锚是否良好贴于锚穴上,止链器位置是否正确,锚固定装置和止链器是否可靠。
-
The methods of bulk segregant analysis , randomly amplified polymorphic DNA and sequence characterized amplified regions were used to analyze F〓 individuals of the hybrid IR24×78-15 and molecular genetic markers linked to Xa-min gene were identified.
同时,以IR24和78-15为亲本进行杂交(IR24×78-15),并采用分离群体分组分析法、随机引物扩增多态性DNA和序列特异性扩增区筛选与Xa-min连锁的分子标记。
-
Holding 5 min at 565 °C, the homogeneous semisolid microstructure with solid fraction of 57% and mean grain size of about 58 μm is obtained.
°C等温5 min,即可获得固相率为57%,颗粒平均直径为58 μm、形状圆整、分布均匀的半固态组织。
- 推荐网络例句
-
Do you know, i need you to come back
你知道吗,我需要你回来
-
Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.
1〕 杨银书,王祥生,李德昌。安徽省首次发现嗜群血蜱。
-
Chapter Three: Type classification of DE structure in Sino-Tibetan languages.
第三章汉藏语&的&字结构的类型划分。