查询词典 Min

BP, HR, ECG and SPO2 were monitored continuously during the anesthesia; the block plane of feeling 15 min after administration of anesthetic drugs, anesthetic effect, the incidence of complications, and 1 min and 5 min Apgar score of the neonate were observed and recorded.

麻醉期连续监测BP、HR、ECG和SPO2，观察并记录给药后15 min麻醉平面、麻醉效果、并发症的发生率及新生儿1 min和5 min的Apgar评分。

Results:DPOAEs amplitude decreased significantly and rapidly after decerebration and remained at the lowest levels for 2,5,10 min. DPOAEs gradually recovered to the previous levels with time delay.

结果：在避免体温和颅温下降、缺氧等情况下，豚鼠去大脑僵直后 2 min、 5 min、 10 min 的DPOAEs幅值显著下降， 30 min 开始逐渐恢复， 60 min 基本恢复到术前水平。

Results KoA for urea varied with dialyzer model, but the effect of Qb, Qd. Urea KoA did not change significantly when Qb increased from 300 to 500 ml/min at Qd of 500, 800 and 1000 ml/min.

结果 透析液流量保持恒定时（分别为500，800，1000 ml/min），尿素KoA在血流量从300增加到400，500 ml/min时，KoA并不增加；但在血流量保持恒定时（分别为300，400，500 ml/min），尿素KoA在透析液流量从500增加到800，1000ml/min时，尿素KoA显著增加。

Firstly, the M-ary modulated Min-Sum algorithm which based on Maximum Liklihood is provided, however, can not be applied to actual decoding due to its complexity. By applying the so called Generalized Distributive Law, we simplified the Min-Sum decoding for M-ary modulated LDPC codes based on Maximum Likelihood, and obtained what we called Enhanced Min-Sum algorithm.

首先基于最大似然的原理给出了多进制调制下的Min-Sum算法，然后利用广义分配率的原理对基于最大似然译码的多进制Min-Sum算法进行了简化，首次提出了多进制调制下LDPC码的改进Min-Sum算法。

The plates are obtained by two steps: compound felt and hot pressing shaping. The opening, mixture, carding, net-paving and needling process that affect shaping process of the blending fiber needle felt are investigated. Then it is concluded that the fiber nets from the BC-272B carding machines are uniform when the rolling speeds of licker-in, cylinder, doffer roller of the roller carding machine are 900r/min, 850r/min and 15.6r/min separately. The fiber needle felt is in a good condition when the paving nets have 8 layers, the type of the felting needle is 30, the density of needling is 1800end/m2, and the depth of needling is 3mm.

纤维复合板材分混合制毡和热压成型两步完成，分别探讨了开松、混合、梳理、铺网、针刺各工序对纤维针刺毡成型的影响，得出BC-272B罗拉梳理机的刺辊转速900r／min、锡林转速850r／min、道夫转速15.6r／min时，从梳理机下来的纤网较为均匀；铺网层数为8层、刺针型号为30、植针密度1800枚／m~2、针刺深度为3mm时，纤维针刺毡的效果较好，纤维复合针刺毡单位面积重量为200g／m~2。

Subjects were 10 healthy males, consisting of 2 min of warm up(40r/min, 50W) followed by 5 min of pedaling(150 W) using an cycle ergometer at 40,60,80,100 and 120 r/min.

以10名健康男子为对象，在功率自行车上先进行40r/min，50W的2min准备活动后，进行阻力负荷150W的5min的自行车运动，踏蹬频率分别为40、60、80、100和120r/min。

Interval slope method is proposed for a class of unconstrained min-max-min problems, in which the objective functions are factorable functions. An interval algorithm is given by interval slope discard tests and interval extension of objective functions. Numerical results are also presented.

讨论目标函数为因子函数的离散无约束min-max-min问题，利用区间斜率，构造目标函数的区间扩张和区问斜率删除原则，建立了求解离散无约束min-max-min问题的区间斜率算法，并给出了数值算例。

This technique was modified as follows: the small rubber particles were purified and diluted to give a protein concentration of an absorbance at 600 nm of about 2.0～2.5; 0.5% basic fuchsin was prepared by being dissolved in 50 mmol/L Tris-HCl(pH7.4); the reaction mixtures were incubated for 30 min at 25 ℃, and centrifuged for 5 min at a speed of 5 000 r/min; and B-serum can serve as the protein samples for the positive control of rubber particle aggregation.

几个关键参数为：（1）使用纯化的小橡胶粒子，适宜浓度为在600 nm处的OD值为2.0～2.5；（2）用50 mmol/L Tris-HCl（pH7.4）配制0.5％碱性品红；（3）25 ℃条件下孵育30 min；（4）5 000 r/min离心5 min；（5）B乳清可作为阳性对照的蛋白质样品。

RESULTS There were no complications relating to ECC in all of the 240 infants.The ECC time ranged from 49 min to 184 min and the aorta cross-clamp time ranged from 17 min to 110 min.The ultrafiltration volume ranged from 150 ml to 400 ml. The intraoperative Hct ranged from 16% to 20% and the hematocrit after MUF ranged from 30% to 39%.The mechanical ventilation support time after operation ranged from 6 h to 72 h.

结果 240例患儿未发现同ECC有关的并发症，ECC时间为49～184 min、升主动脉阻断时间17～110 min，改良超滤滤出液体150～400 ml，全组患者术中Hct维持0.16～0.20，改良超滤结束Hct为0.30～0.39，术后呼吸机辅助时间6～72 h，24 h胸腔引流量30～110ml，术后输入库血量100～200 ml。

Results showed that, the specific refining energy consumption is decreased with increment of rotation speed of the primary refiner. At freeness level of about 670 mL CSF, for example, the specific refining energy consumptions is 363 kWh/t o.d. at 3000 r/min, and 305 kWh/t o.d. at 3500 r/min, which is equivalent to 16% energy saving, furthermore the specific energy consumption is only 265 kWh/t o.d. at 4000 r/min, which means 27% less refining energy required. At the same time, pulps produced at higher refiner speed have higher strength properties and lower shives contents. There is little change of optical properties of the pulps.

结果表明：小叶桉物料在相同条件下进行汽蒸、挤压和化学预浸渍后，分别采用3500 r/min和4000 r/min的盘磨转速进行第一段磨浆，浆料磨至游离度670 mL时所需磨浆电耗与3000 r/min时的相比，分别下降16%和27%；浆料中纤维束含量分别降低20%和35%；第一段磨后浆料再分别经相同盘磨转速（3000 r/min）的后续磨浆后，与相近游离度的浆料性能比较可知，随第一段磨浆盘磨转速的提高，浆料的细小组分含量略有增加，纤维束含量显著降低，强度性能有不同程度的改善，但光学性能变化不显著。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。