查询词典 Min

The optimal preparation conditions were determined through experiments: turbidity ratio is 1:15, mass fraction of ammonium molybdate solution is 0.2%, the soaking and heating time are 5 min and 10 min respectively.

经过试验研究，确定了最佳制备条件：膨润土悬浊液配比为1：15、钼酸铵溶液质量分数为0.2%、浸泡时间为5 min、加热时间为10 min。

Therefore,it is recommended that the optimum solid solution for cold-drawn billet is follows:(1 150±10)℃×20 min,W.C.and for cold-drawn bar:(1 080±10)℃×20 min W.C..

推荐冷拉坯和冷拉材的优化固溶工艺分别是(1 150±10)℃×20 min，W.C。和(1 080±10)℃×20 min，W.C。。

Jatropha Curcas oil was used as feedstock for producing biodiesel by transesterification,and adding sodium hydroxide,potassium hydroxide or sodium methoxide as catalyst respectively. The optimal conditions were obtained:molar ratio of methanol to oil 6∶1,reaction temperature 60 ℃,reaction time 80 min,mixing intensity 600 r/min,catalyst concentration for NaOH,KOH,or CH3ONa 1.2% of oil weight,The yield of biodiesel was above 97%. The physico-chemical indices of the biodiesel obtained met the quality standard ASTM of USA and DIN V of Germany.

选用了非食用油麻疯果油为原料，以氢氧化钠、氢氧化钾、甲醇钠为催化剂，通过酯交换法制取生物柴油，研究表明最适宜工艺条件为：醇油比6∶1，反应温度60 ℃，反应时间80 min，搅拌强度为600 r/min，催化剂用量为1.2%，转化率达到97%以上，且生物柴油各项理化指标均符合美国和德国测试标准。

In the first stage, when environment temperature arrived to 37.5℃, Ta of A and B dairy barn was 35.5 and 36.7℃, respectively. And at the same time Tr was higher than 39.5℃. Specially, the high yield dairy in A barn raised to 41 ℃ at 22:00 and RR was 90/min, the RR of low yield dairy was 65/min at this time. mTs was 37.6℃ at 15:00. In the third stage, Ta of the barn was higher than outside when outside Ta was lower than 27.6℃. When the ambient temperature was lower than 28℃, the Tr of low yield dairy was between 38.5 and 39℃; if the Ta was down to 24℃, Tr of high yield dairy was lower than 39℃.

第一阶段，舍外Ta平均达37.5℃时，A、B舍内Ta分别为35.5和36.7℃，此时Tr达到39.5℃以上，尤以A舍内高产奶牛22：00最高，平均达41℃；第一阶段平均RR在65次/min以上，高产奶牛在22：00、低产奶牛在15：00最高，分别为94和95.9次/min；平均mTs高产奶牛在15：00高达37.6℃；第三阶段，舍外平均Ta在15：00最高为27.6℃时，此阶段舍内Ta均高于舍外。

With foaming degree of egg-white protein as response value, the optimum modification conditions for egg-white protein by xanthan were determined as follows: concentration of egg-white protein was 5.6%, addition amount of xanthan was 0.29%, the temperature was 45℃, the heating time was 22 min and the whipping time was 3.3 min.

以改性蛋清蛋白的发泡度作为响应值，对改性条件进行优化，最终确定了黄原胶对蛋清蛋白的最佳改性条件为：蛋清蛋白浓度为5.6%，黄原胶添加量为0.29%，加热温度为45℃，加热时间为22 min，搅打时间为3.3 min。

When at the concentration of 100 and 200 mg/L,after 18 min the knock down rates of dichlorvos were 94.5% and 100%,17 min treated the knock down rates of phoxim were 24.4% and 41.1%.

3浓度为100、200 mg/L时，敌敌畏18 min的击倒率分别为94.5%和100%，辛硫磷17 min的击倒率分别为24.4%和41.1%。

By comparison of eight micro adsorption, A resin with high adsorption rate and eluent rate was used to adsorb chlorogenic acid from extraction solution. The adsorption parameters are: the content of chlorogenic acid is 0.204 mg per mL adsorption solution, the acidity of adsorption solution is 4, the adsorption velocity of flow is 3 mL per min, the eluent is 30% ethanol, the eluting speed is 1.5 mL per min and the eluents volume is 4 times of resin volume. In the optimal adsorption condition, the final yield of CHA is 5.06%. the content of chlorogenic acid is 78.26% in dry productin.

通过对比8种大孔吸附树脂对绿原酸的吸附效果，选用对绿原酸吸附解吸性能均较好的树脂对绿原酸吸附，吸附参数如下：吸附液绿原酸的浓度为0.204mg／mL、吸附液pH值为4、流速为3mL／min，解吸参数如下：解吸剂为30％乙醇、解吸剂流速为1.5mL／min、解吸剂使用量为4倍树脂体积，在此条件下，绿原酸得率为5.06％，产物中绿原酸含量为78.26％。

The TEO was 7.5 ± 5.0 min in Group 1,8.2 ± 5.0 min in Group 2, and 9.8 ± 4.0 min inGroup 3.

组1的 TEO 是7.5±5.0分钟，组2的为8.2±5.0 min ，组3的为9.8±4.0min。

The linear ablation of the double lineations was repeated oncemore after AFL was terminated.Results:AFL in 5 cases were all terminated successfully,mean ablation frequencies:11.2±1.9 times,mean X-ray fluoroscope time:21.2±5.3 min,mean ablation energy:32 400±8 800J,mean ablation time per target:1.88 min,and without complications.

并在房扑终止后对双连线重复线性消融。5例均成功终止房扑，平均放电11.2±1.9次、X线曝光时间21.2±5.3 min、平均消融能量32 400±8 800 J、平均每靶点消融时间1.88 min，无手术相关并发症发生。

The effects of casting temperature, casting speed and intensity of cooling water on microstructure are investigated. The results show that when the casting temperature, casting speed and intensity of cooling water are 710 ℃, 100 mm/min, 0.05 m 3/min respectively, the micros...

结果表明，铸造温度为710℃，铸造速度为100mm/min，冷却水强度为0.05m3/min时的低频半连续铸锭组织均匀细小，呈现近球形，边部和中间部位的晶粒大小差别较小，其平均晶粒尺寸分别为28μm和29μm。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。