查询词典 MC

Through observing four kinds of drying powders of MC and microencapsulating process of MC with amicroscope,it discovered that MC spray-drying powders existed in an agglomerating form,leading to good dissolution ability;among acquired microcapsule,MC cellulose and dextrin acted as continues phase,fat acted as distract phase and emulsifier distributed between water and oil,leading to astable microencapsulation system.

对各种干燥苦瓜粉及苦瓜微胶囊过程进行显微观察，发现喷雾干燥苦瓜粉以附聚的形式存在，从而具有良好的溶解特性；所形成的微胶囊中，苦瓜纤维与糊精作为连续相，脂肪球作为分散相，乳化剂则分布于水-油两相之间，从而形成稳定的微胶囊体系。

Poly/melamine cyanurate composite latex particles are prepared via soapless emulsion polymerization. XPS data and TGA analysis reveal that MC particles are encapsulated by PMMA during polymerization, resulting in the formation of a core-shell structure of PMMA/MC composite latex particles. MC can affect the thermal degradation and promote the charring of PMMA. The application of PMMA/MC in nylon 6 (PA6) indicate that the composite latex particles can improve the mechanical pro...

采用原位乳液聚合法制备了聚甲基丙烯酸甲酯/三聚氰胺氰尿酸盐复合胶粒，对其进行X光电子能谱及热重分析结果显示，在MC阻燃剂颗粒表面覆盖了一层PMMA胶膜，形成了具有核-壳结构的PMMA/MC复合胶粒；MC能影响PMMA的热降解过程并促进其成炭；在尼龙6(PA6)中的应用结果表明，PMMA/MC复合胶粒能改善PA6的力学性能和阻燃性能。

But there are few or no visible F-actin ring of blocking proteinase being released in MC of tryptase and chymase immunoreactivity MC(subscript TC and MC of chymase immunoreactivity MC(subscript C. Cell appearance was inflated and intracellular proteinase had been released.

而类胰蛋白酶和类糜蛋白酶免疫反应性的肥大细胞及类糜蛋白酶免疫反应性的肥大细胞内少见或未见明显的阻碍蛋白酶释放的丝状肌动蛋白环；细胞形态膨胀，细胞内蛋白酶已释放。

To resist co-interference of MC-CDMA system, smart antenna are used in MC-CDMA. A blind adaptive array algorithm was developed for MC-CDMA system by using recursive least-squares dispread respread multitarget array.

MC-CDMA系统中同信道干扰仍然是影响系统性能的主要因素，这就需要使用智能天线来提高系统的性能。

The strength and toughness of the nanocomposites are improved because of the addition of anao-Zno. The volume resistance strength and toughness of the nanocomposites are improved because of the addition of nano-ZnO. The volume resistance coefficient is decreased 8×10 times, surface resistance coefficient is decreased 5.7×10^4 times, and the friction coefficient is decreased 29% by adding nano-ZnO. The friction, wear properties, and the antistatic property of MC Nylon 6/ZnO nanocomposite are better obviously than MC Nylon 6. The macro stress of MC Nylon 6 structure is changed by the tensile test so that the preferred orientation of crystal surface (002+202) is more obvious.

纳米ZnO的加入起到同时增强增韧的作用；使体积电阻系数降了8×10^4倍、表面电阻系数降了5.7×10^4倍、摩擦系数降低了29%，MC尼龙6/纳米ZnO复合材料摩擦磨损性能和抗静电性能明显优于MC尼龙6；经过力学拉伸试验的破坏，引起MC尼龙6结构发生宏观应力变化，造成（002+202晶面）产生明显的择优取向。

The objective of this study is to picture the signal tranduction pathway of apoptosis induced by MC so as to further investigate the impact of MC on transcription, expression and regulation of apoptosis gene and the related biological effects; illustrate the toxicological mechanism of MC; as well as discover the new biomarkers invovled.

本研究工作的目的是通过功能基因组分析的技术平台，探讨微囊藻毒素诱导肝组织细胞凋亡的信号转导通路，以便在此基础上，进一步深入研究该毒素对凋亡功能基因在转录、表达、调控水平上的影响，及由此引发的生物学效应；揭示微囊藻毒素的凋亡毒理机制，同时发现新的生物标记物。

Some methods aiming at the two problems have been researched. First, the optimal number of ATE site can be calculated based on a cost model of DAT-ATE. Second, the problem of test schedule which is equitant with two-dimensional Bin-Packing problem is presented. Then a TCG denotation satisfied with T-admissible rule is more convenient for combinational optimization. With Simulated annealing algorithm, better test scheduling results can be achieved; but there is no great optimization space because the efficiency of scheduling is greater than 90%. Third, A novel test compression method——Multi-capture testing is proposed to compress the stimuli. And the ATPG results show that MC achieves high compression ratio which is greater than 90% in some large-scale circuits. MISR, widely used in LBIST, is employed to compress the responses. The aliasing analysis demonstrates that the fault coverage reduction is little due to the existence of aliasing. Fourth, an improved TIC (called S-TIC) aiming at structured test is proposed based on ARM's TIC. A MC scheduling algorithm is proposed to compute the SoC test time and combine MC vectors to SoC test vectors. The scheduling results shows that test time is greatly reduced when using the proper scheduling priority.

首先，给出了低成本ATE的成本模型，根据此模型得到最低测试成本时系统级测试调度的基本参数——测试Site数；其次，本文将DAT-Scan方式的SoC测试调度等价为两维BP问题，为有效地求解该问题，将该BP问题表示为TCG图并通过模拟退火算法解决其求解过于复杂的问题，调度的结果表明该方法在测试时间上有一定改善，并指出DAT-Scan测试调度效率已经大于90％，进一步优化的空间较小；第三，本文尝试通过测试压缩来解决激励所需的测试带宽，提出了Multi-capture结构并解决了MC测试过程中的&矢量&退化问题，MC测试的ATPG结果表明其测试压缩率很高（大电路接近90％）；第四，在激励获得很高压缩比的情况下，测试响应也需压缩，本文采用LBIST中常用的MISR作为MC测试的响应压缩电路，理论分析和实验结果都证明了MC测试的别名对故障覆盖率影响较小（小于2％），并对两类别名的成因做了具体分析；第五，在MC测试及其响应压缩的基础上，本文改进了ARM公司的测试控制器TIC使之适合于MC测试，为了解决MC测试矢量合成问题，本文抽取了MC测试模型，通过固定优先级的MC测试调度模拟将MC矢量合成为ATE矢量，并模拟出了总的MC测试时间。

Figure 3 Monopolistic versus Perfect Competition Monopolistically Competitive Firm Price MC Markup Perfectly Competitive Firm Price MC ATC ATC P P = MC Marginal cost MR Demand P = MR 0 Quantity produced Efficient scale Quantity 0 Quantity produced = Efficient scale Quantity Excess capacity

图3。 垄断竞争和完全竞争垄断竞争企业价格价格加成价格完全竞争企业 MC ATC P = MC MC ATC 边际成本 P = MR 需求曲线 MR 生产量有效规模需求产量生产量=有效规模产量过剩市场能力

Figure 3 Monopolistic versus Perfect Competition Monopolistically Competitive Firm Price MC Price Perfectly Competitive Firm ATC MC ATC P P = MC P = MR MR Demand 0 Quantity produced Efficient scale Quantity 0 Quantity produced = Efficient scale Quantity

图3。 垄断竞争与完全竞争垄断竞争企业价格 MC ATC 价格 MC ATC 完全竞争企业 P 过剩生产能力需求产量生产量有效规模 P = MC P = MR 需求曲线产量产量=有效规模产量

heological properties at a low shear rate range(10-2-10s-1) and the glass transition temperatures for PEK-C with different moleCular weithts have been studied by using a cone/plate rheometer and DSC' The activation energy for melt flow increases with Mw The dependence of Tg on molecular weight exhibits two linear range and the value of nitersect agrees with the critical molecular weight , Mc' which is first reported for PEK-C' Mc value obtained according to η0 is about 8× 104 g/mol and the relation between Mc and temperature was dis-cussed.

用锥权流变仪及DSC的方法研究了5种不同分子量的酞侧基聚芳醚酮在低剪切速率区（10－2－10s－1）的流变行为及其分子量与玻璃化转变温度的关系。结果表明，样品的粘流活化能随分子量的增加而增大，Tg随分子量的变化是二个线性区，其交点值与所求的样品的临界分子量值相对应。利用测得的零剪切粘度值（η0）首次求得了PEK—C的临界分子量值。同时也讨论了Mc与温度及η0和Tg与分子量的关系。

Metrorrhagia is also gynaecological problems of common diseases.

崩漏是妇科常见病也是疑难症。

WordFTP gives you the convenience and timesaving you need.

wordftp让您的方便和省时您所需要的。