查询词典 M.M.

The results show that the grain size is refined by the addition of Nd or Dy, especially combined addition is better than single addition. With the addition of 0.2 % Nd and 0.6% Dy, the grain size is reduced from 150 μm to 60 μm. Combined addition with two rare earths elements makes the tensile strength, yield strength and elongation of ZK10 alloy increase to 191.0 MPa, 69.0 MPa, and 16.6%, increasing by 89%, 43%, 232% respectively, compared with ZK10 alloy without RE element.

结果表明：ZK10镁合金中分别加入Nd和Dy均能细化晶粒，且Nd和Dy同时加入的效果优于单一加入的效果，当同时加入质量分数为0.2% Nd和0.6% Dy时，合金的平均晶粒尺寸由原来的150 μm细化至60 μm，使ZK10合金的抗拉强度和屈服强度分别提高至191.0 MPa和69.0 MPa，伸长率达到16.6%，与未加入稀土的ZK10合金相比分别提高89%，43%和232%。

The results show that dynamic softening is easy to occur in these ingots and flow stress becomes steady finally; the material constants of hot deformation are procedural parameters that stress-level coefficient α, strain rate sensibility exponent m and deformation activation energy Q are all increased with strain increasing, while stress exponent n is decreased gradually; the values α and m of the alloy homogenized are the biggest and the value n is the smallest, dynamic softening effect of the alloy is the most obvious, which can deform evenly; influence of strain on the value Q of the alloy homogenized is a little and the average value of Q is only 176.5kJ/mol, so the alloy is easy to deform; the alloy matrix shows the regular recrystallization grains when the strain is 50%; dislocation cell structure re-formed in the grains with increase of strain.

结果表明：经不同处理的Al-1Mn-1Mg合金均易发生动态软化并最终呈现稳态流变特征；热变形材料常数是过程量，随应变量的增加，应力水平参数α、应变速率敏感性指数m和热变形激活能 Q 随之增大，而应力指数 n 则逐渐减小；均匀化退火后，铝合金的α和m值最大而n值最小，动态软化效果最明显且变形均匀，在该状态下，铝合金的 Q 值受变形量影响小，平均仅为176.5kJ/mol，易进行热变形；当应变量为0.7时，基体呈现规则的再结晶晶粒组织，随着应变量的增加，晶内重新形成了位错胞结构。

The experiments proved the degree of stability reached 0.28μm and the definition of repetitiveness reached 1.376μm.

做出了实验样机，并进行了相关实验，实验结果表明，测量稳定度达到0.28μm，重复性精确度1.376μm，达到了良好的指标水平。

The axial runout of the commercial disc is about 300 μm. The equalizer used in this study was designed for 500 μm.

一般市售碟片的轴向摆动约为300 μm，本研究将轴向摆动之范围提高到500 μm，来设计所需要的等化器。

A.D. M. El Zawahry, M.D., of Cairo Egypt reported that he used Aloe Vera on his patients suffering from seborrhea, acne, alopecia, chronic leg ulcers, vulgaris, and hair loss.

1973年，M.EL.Zawahry M.D讲述他用维拉芦荟来治疗患有皮肤炎、痤疮、斑秃、慢性溃疡、脱发等病症的患者，并证明芦荟对治疗这些疾病有奇效

The conclusions can be drawn as the following:(1) According to the theoretical calculation, the porous C/C preforms with uniform pores radius from 10 μ m to 1300 μ m are beneficial to infiltration of liquid silicon. The growth of SiC was controlled by the self-diffusion of carbon atoms.

研究结果表明：(1)根据理论计算可知，在10μm～1300μm的孔径范围内，具有均一孔径的多孔体有利于液Si的渗入，SiC的生长为C原子的自扩散控制。

Arundinacea in vitro. After cultivation on PDA at 26℃ under continuous fluorescent light for 6 days, the colonies were black green and the hyphae were septate. Spore size was 30.6~17.0 μm×10.9~13.6 μm, mostly with four-septa. The central cell was dark and the third cell from the base was the largest. The DNA sequence of ribosomal ITS of the isolates was found to match 100% with an ITS sequence of Curvularia affinis in GenBank. This is the first report of leaf spot caused by C. affinis on F.

结果表明：该病原菌能侵染高羊茅，在26℃和光照下，在PDA培养基上培养6d后菌落呈墨绿色，菌丝有隔，分生孢子有4个横隔膜，平均大小为30.6~17.0μm×10.9~13.6μm，中部3胞暗色，第3个细胞基部膨大；其核糖体DNA-ITS序列分析表明，该菌与GenBank中近缘弯孢的同源性是100%；结合形态学特征和致病性测定，认为该菌为C。

So we designed a adaptive synchronizing controller based on hereinbefore hardware environment: first a small magnitude reference signal r is outputted to system through the signal card (to ensure that the vibrating system works in a linear state), and this signal is sent to the moving coil of vibrator through the power amplifier, so vibration is produced through electromagnetic induction. Secondly the vibration signal can feedback to the data acquiring card in the servo system through the acceleration sensor on the Vibroseis reactor M〓 and the base-plate M〓, then the computer can get the current vibrating state y〓 of the coil of vibrator according to the feedback information from the data acquiring card, and give a real time comparing between the current state y〓 and the reference output y〓 of the set-in reference model with current reference input being r , then regulates the correlative controlling parameters according to the error e〓=y〓-y〓 till y〓→y〓, finally normal signal sweeping begins with a certain phase fixed. Meanwhile a synchronization signal for seismic signal record is sent to seismograph from synchronization signal outputting component in the Vibroseis system to perform the controlling process of synchronization of sweeping phases.

为此，我们基于以上的硬件环境设计了一个自适应同步控制器：首先通过信号发生卡对系统输出小幅度的参考信号r(从而保证振动系统工作处于线性状态)，信号通过前置放大器、功率放大器等送到激震器动圈，并通过电磁感应产生振动，振动信号通过可控震源激震器反应块M〓和基板M〓上的加速度传感器反馈给伺服系统中的数据采集卡，工控计算机根据采集卡的反馈信息，获取当前激震器动圈的振动状态y〓，并实时地将该状态与内置的参考模型在当前参考输入r下的参考输出y〓进行辨识，再将两者输出误差e〓＝y〓-y〓对系统的有关控制参数进行调整，直至y〓→y〓，最后在经过某一固定的相位后，开始信号的正常扫描过程，与此同时，由可控震源系统的同步信号输出部件向地震仪送出一地震信号记录同步信号，进而完成扫描相位同步控制过程。

The experimental results used in this study were obtained in the European SIROCCO project1, which aims at a reduction of wind turbine noise by designing new blades with low trailing edge noise emissions, the project focused on two wind Turbines: an 850 kW GAMESA turbine and a 2.3 MW GE turbine, with rotor diameters of 58 m and 94 m respectively.

实验性结果被使用在这项研究被获得了用欧洲人 SIROCCO project1，瞄准风涡轮噪声减少由设计新刀片以低后缘噪声放射，项目集中于二风涡轮：一个850 千瓦GAMESA 涡轮和一个2.3 兆瓦GE 涡轮，以58 m 和94 m 电动子直径各自。

Experimental TEA CO2 laser with printed circuit board preionization is used. The laser has gain length of 90 cm. The resonator is composed of a total-reflective concave spherical mirror of curvature radius 20 m and a total-reflective plane mirror of mirror radius 4.5 mm, separated by 5 m distance.

实验中TEA CO2激光器采用印刷电路板预电离结构，增益长度90 cm，腔长5 m，球面全反射镜曲率半径20 m，输出端平面镜半径4.5 mm，得到了内环半径为4.5 mm、外环半径为5.5 mm的基模环形光斑输出。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。