查询词典 L.A.

Note: The decompression valve role in continuing to do, there will be a part of the oil (about 1 L / min) flow back into the tank through the vent port lost the oil pump part of the output flow, so in a system, such as the use of several cut pressure valve, you must take into account the loss of pump output flow problems.

注意： 减压阀在持续做减压作用时，会有一部分油（约1 L/min）经泄油口流回油箱而损失泵的一部分输出流量，故在一系统中，如使用数个减压阀，则必须考虑到泵输出流量的损失问题。

Our factory is specialized manufacture all kinds of special shape of the bent glass, styling, including L, U, W, Z, spherical, oval, round, cone, back to bell-shaped and many other forms, our plant would produce its own super-hot bending furnace can be custom-made glass, hot bending the maximum size of 8000mm * 3600mm * 19mm, meet a variety of curtain wall and the large size of the needs of bent glass products used in fine cosmetics Showcase, jewelry Showcase, mobile phones Showcase, fish tank, glass coffee table, TV cabinet , bedside cabinets, a few telephone, shower room, spiral staircase, building curved balcony, transportation charges booth, light roof, sightseeing elevator, arched corridors, I-processing performance and stability of hot bending glass products, the quality of Good (no mold burn marks, there is no rainbow effect), size precision (error control in 1-2mm), low price (baked finished high rate, profit-sharing client) is willing to provide our clients with quality service, welcome calls, to e-mail consultation to discuss , and we look forward to your joining!

我厂专业加工制作各种特殊异形的热弯玻璃，造型包括L，U，W，Z，球面，椭圆，圆，圆锥，回字型等多钟造型，我厂自行制作的超大热弯炉可以定做热弯玻璃最大尺寸8000mm*3600mm*19mm，满足各种幕墙及超大尺寸的热弯玻璃的需求，产品应用于精品化妆品展柜，珠宝展柜，手机展柜，鱼缸，玻璃茶几，电视柜，床头柜，电话几，淋浴房，旋转楼梯，大楼弧形阳台，交通收费岗亭，采光顶，观光电梯，拱形走廊等，我厂加工的热弯玻璃产品性能稳定，品质优良（无模具烫伤痕迹，没有彩虹现象），尺寸精准（误差控制在1-2mm，价格低廉（出炉成品率高，让利客户），愿为广大客户提供优质服务，欢迎来电，来邮件咨询洽谈，我们期待着您的加盟！

Are set processing, production and sales of integrated enterprise, Main specifications of the dual-head models to stay plate Plum wrench, dual-purpose wrench (semi-parabolic / wide parabolic), active wrench (Zhanhua Plastic / Phosphating / calibration / chrome), a full range of instrument sets sleeve, the sleeve head, then a long shot, short take-under, ratchet wrenches, Freedom Next, slide the first handle rod afterburner, universal joint, the two sides bend Handle, Express±ú, large sliding head, curved handle, L-type wrenches, tire sleeve, saw blade, circular saw blades and other products, high-quality carbon steel and medium carbon steel.

山东世达机械工具有限公司是集加工，生产，销售为一体的综合性企业，主营各种规格型号的双头呆扳梅花扳手、两用扳手、活络扳手（沾塑/磷化/刻度/镀铬）、全系列套筒组套工具、套筒头、长接杆、短接杆、棘轮扳手，自由接、滑行头手柄、加力杆、万向接头、双方弯柄、快速摇柄、大滑行头、弯柄，L型扳手、轮胎套筒、锯条、圆锯片等一系列产品，产品选用优质中碳合金钢和中碳钢。

A flat high efficiency super-broadband source was presented. We achieved a C+L-band superfluorescent source, in the region from 1524. 0 to 1600.4nm, the power of the ASE are over -12. 0dBm and the ASE profile excursion is only ±1. 4dB in the region from 1539. 2 to 1600.4nm. The power of the ASE is 22. 1mW and the power conversion efficiency is 18. 8%. 9. The amplification characteristics of thulium-doped fiber amplifier had been studied using the basic theory for fiber amplifier. The connection between the Tm-doped fluoride fiber and silicon fiber was accomplished, and we studied the TDFA and the reason that the expecting results hadn't achieved had been analyzed. The assumption of the Er-Tm-co-doped silicon fiber had been presented, and we studied the Er-Tm-co-doped silicon in cooperation with the correlative corporation, some results had been got and the further studies are carried on.

实验结果得到了覆盖C+L-波段的超荧光光源，在1524.0-1600.4nm波长范围内，自发辐射谱的功率均高于-12.0dBm；在1539.2-1600.4nm波长范围内，自发辐射谱不平坦度为±1.4dB；荧光总功率为22.1mW，功率转换效率为18.8%； 9、应用光纤放大器的基本理论，理论分析和研究了掺铥光纤放大器的放大特性；解决了氟化物掺铥光纤与硅基光纤的连接问题，进行了TDFA的实验研究，分析了没有得到预期结果的原因；最后提出了铒-铥共掺硅基光纤的构想，并与有关单位合作，共同研制了铒-铥共掺硅基光纤，得到了一些前期结果，进一步的研究仍在进行当中。

Which part of a stop for Miduoban, density not less than 0.80g/cm3 otherwise affect loading capacity and formation; Wet rate not less than 6.5%, but not too high, can not self-regulate on the basis of climate change; Surface craft, touching them with their hands or face is one-dimensional relief, relief to face the best; formaldehyde emissions 1.1mg/L reach Europe E1 class standards, and a test report on shaving board, staining the curing plates.

其中间基材部分为中密度板，密度不能低于0.80g/cm3，否则影响承重力和平整性；含水率不能低于6.5%，但也不能过高，否则无法根据气候的变化自行调节；表面工艺，用手触摸辨别是浮雕面还是平面的，浮雕面的为最好；甲醛释放量1.1mg/L，达到欧洲E1级标准，且有检测报告，警惕刨花板、染色的防潮板。

L FINALLY, SET THE NUMBER OF GUN SHOOTS, POWER ON THE CONSOLE, THE INITIAL SETTING GUN SHOOTINGS IS SIX SHOOTINGS, TO HOLD "B KEY". PRESS THE A KEY "N" NUMBER. THEN THE GUN SHOOTS WILL BE "N" SHOOTS.

l 最后在主机上设置射击的次数以及力量，初始射击次数为6次，按住 B 键不放并按压 A 键 N 次那么射击次数就为 N 次。

Results Under these conditions, all the test samples containing≥0.10mg/L NO2(superscript -) can produce a positive response of the characteristic red-purple color, whereas, the samples will produce a negative response when the level of NO2(superscript -) was below the limit.

在此情况下，所有含NO2≥0.10mg/L的检验水样均产生紫红色阳性反应，而给出阴性反应的水样表明NO2含量低于此限值。

In "This Is Not a President," Diane Rubenstein suggests that George Bush is a living example of trompe l'oeil and, at times, resembles the 19th-century female hysterics studied by Freud.

&这不是总统&学员Rubenstein表明布什是一个活生生的例子，狂l回家，有时，像十九世纪女性研究弗洛伊德危言耸听。

A century ago, progressive English thinkers such as J.A. Hobson and L.T.

一百年前，英国进步思想家约翰·阿特金森·霍布森和霍布豪斯L。

The optimum technical conditions were obtained as follows: the experimental drift tube at a temperature of 90 ℃, mobile phase of acetonitrile∶ water=70∶30, flow rate as 1 mL/min, nitrogen flow rate as 2.0 L/min, and a good separation of glucose and xylose in the hydrolysate.

实验条件优化得出在漂移管温度为90 ℃，流动相为乙腈∶水（70∶30），流速为1 mL/min，氮气流速为2.0 L/min条件下，经Shodex Asahipak NH2P-50(4.6 m×250 mm，5 μm)色谱柱后，可以将水解液中的主要糖成分葡萄糖和木糖进行良好的分离。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。