查询词典 High and Dry

In leaves,the concentration of Cd and Cu been up to 168.6μg·g~(-1) and 30.1μg·g~(-1),while in roots, they have been to 610.9μg·g~(-1) and 384.6μg·g~(-1).In these concentration compages,the leaves could accumulate Cd at a high rate,Cd50mg·g~(-1) Cu50 mg·g~(-1),Cd80mg·g~(-1) Cu30 mg·g~(-1),Cd80mg·g~(-1) Cu50 mg·g~(-1).At the concentration of Cd50mg·g~(-1) Cu50 mg·g~(-1), Iris pseudacorus L. could accumulate Cd and Cu at a high rate:inleaves,Cd82.908μg·g~(-1), Cu30.722μg·g~(-1),in roots, Cd266.181μg·g~(-1), Cu395.83μg·g~(-1),and at this concentration the plant could grow well, the dry weight of leaves and roots of it were 64.3% and 81.1% of the concentration compage Cd0mg·g~(-1 Cu50 mg·g~(-1)s.

研究表明，①黄菖蒲对Cd、Cu均有较强的吸收积累能力，其中对Cd的吸收积累能力相对大于Cu：地上部Cd、Cu含量最高分别达168.6μg·g~(-1)和30.1μg·g~(-1)，根部Cd、Cu含量最高分别达610.9μg·g~(-1)和384.6μg·g~(-1)；黄菖蒲地上部分Cd积累量均随处理浓度的升高而增加，特别在处理Cd50mg·g~(-1) Cu50mg·g~(-1)组合胁迫下，黄菖蒲对Cd、Cu的积累量为：叶的Cd含量为82.908μg·g~(-1)，Cu为30.722μg·g~(-1)；根的Cd含量为266.181μg·g~(-1)，Cu395.83μg·g~(-1)，且生长良好，叶和根的干重分别为处理Cd0mg·g~(-1) Cu50 mg·g~(-1)的64.3％和81.1％。

On mountainous sites, grade Ⅰ or Ⅱ stands including land below the crown of the secondary broadleaf forest and the Chinese-fir plantation or east-facing, shady dry land could be considered for the plantation. The transmittance of crown in the areas should be 55%~60%. One-year-old high quality seedlings above 25 cm tall and 0.25 cm in diameter near the ground-level should be used. For high-yield, field cultivation, shading facility should be considered and seedlings of taller than 15 cm and greater than 0.15 cm in diameter near the ground should be applied. The appropriate density and sunlight transmittance ought to be 30 cm×30 cm and 50%, respectively.

结果表明，利用山地种植，选择透光率为55%~60%的Ⅰ、Ⅱ类立地的残次阔叶林和杉木林冠下，或地形隐蔽、东向的山垅旱地，选用苗高25 cm以上、地径0.25 cm以上的1年生优质苗木造林；利用农田进行庇荫设施高产栽培，应选用苗高在15 cm以上、地径0.15 cm以上规格的苗木栽植，适宜栽植密度为30 cm×30 cm，遮阳透光率在50%左右。

The results under the oil lubricate friction conditions were similar with those under the dry friction conditions. The wear mechanism of 3Cr13 matrix alloy was micro-cutting and distorting wear. For the composites with a low fraction of TiC particle, distorting wear dominated and cutting was partly operating. For the composites with a high fraction of TiC particle, stress fatigue wear and wear of hard phase decohesion has occurred, but the main wear mechanism was still distorting wear. When the wear experiments were performed under the oil lubricate friction conditions, the main wear mechanism has became to abrasive wear and fatigue wear for the composites with the low TiC fraction, and fatigue wear would be to dominate for the composites with the high TiC fraction. There were similar wear mechanisms in H13 and 1Cr18Ni9 matrix composites.

在干摩擦条件下，3Cr13基体合金的磨损机理为显微切削和变形磨损；低体积分数的复合材料磨损机制以变形磨损为主，兼有少量的切削磨损机制；高体积分数的复合材料磨损机制以变形磨损为主，兼有应力疲劳磨损和脆性相剥落磨损；在油润滑摩擦条件下，3Cr13基体合金的磨损以磨粒磨损为主；低体积分数的复合材料磨损为磨粒磨损和疲劳磨损；高体积分数的复合材料磨损以疲劳磨损为主。H13、1Cr18Ni9基体及其复合材料的磨损机制类似于3Cr13基体及其相同体积分数的复合材料。

The film used to produce the full color article dry plate silver with high sensitivity, high resolution, high diffraction efficiency, a further study of panchromatic panchromatic silver recording materials and recording media has an important significance.

采用此片文章制作出的全色银盐干板具有灵敏度高、分辨率高、衍射效率高等优点，对进一步研究全色银盐记录材料和全色记录介质有着重要的意义。

The company has always been adhering to the "pursuit of excellence, the observance of good faith," the purpose to insist science and technology, people-oriented modern management mode, with high-quality science and technology development talent and excellent production equipment, will be unique to the traditional formula with enzymolysis, spray dry food and other modern organic combination of bio-engineering techniques to produce high-quality products.

公司一贯秉承"追求卓越、恪守诚信"的宗旨，坚持以科技为先导、以人为本的现代化管理模式，拥有高素质的科技开发人才和精良的生产设备，将独有的传统配方与酶解、喷雾干燥等现代食品生物工程技术有机结合，生产出高质量的产品。

Since its inception 96 years, with a strong engineering and technical strength and excellent quality management, to become well-known enterprises, Dongguan City, in the various regions of the country enjoys a high reputation, the company introduced advanced foreign technology mass production of the wholesale carved sludge, cloud art card carving sludge, color sludge, rubber mud, clay, Fimo clay, anti cement, mold clay, sculpture work, oven, press mud machine, Fimo design and production, AB water, PU resin, unsaturated resin, a variety of silicone oil, the Japanese Shin-Etsu KF-96, 2-methyl silicone oil , Emulsified silicone oil , Silica gel, silicone, food defoamer, students with rubber mud, palm clay, color clay, carved clay, epoxy AB glue, green red gum, Crystal, head knot soil, Fimo clay, plastic raw materials button , water-soluble silicone oil, silicone oil emulsion, Shin-Etsu potassium-based high-temperature silicone oil and all kinds of silicone oil, Poly water, accelerator, light powder, hardening agent, caustic soda, caustic soda, titanium dioxide, bar-mode band, skim gauze, Wen Zhangbu, trimming needles, repair embryo gun oil, gun repair embryo, glass fibers, fiber cloth, hot sol, paint extinction powder, oil dry cleaners, petroleum jelly, ceramic mold release agent, green red gum, potassium soap, silicon oil, silicone, mold rubber, silicone Recycling of waste silicone resin, ceramic ...

公司自96年成立以来，以强大的工程技术实力和优良的品质管理，成为东莞市知名企业，在全国各地区享有极高的声誉，公司引进国外先进技术大量生产批发精雕油泥，云艺牌精雕油泥，彩色油泥，橡皮泥，胶泥，软陶泥，防水泥，模具泥，雕塑工作，烤箱，压泥机，软陶设计与制作，AB水，PU树脂，不饱合树脂，各种硅油，日本信越KF-96、二甲基硅油，乳化硅油，硅胶，矽利康，食品消泡剂、学生用橡皮泥、手板泥、彩色油泥、精雕泥、环氧AB胶，青红胶，水晶胶，目结土、软陶泥、按键胶原料、水溶性硅油、乳化硅油、日本信越钾基耐高温硅油及各种硅油、波丽水、促进剂、轻粉、硬化剂、片碱、烧碱、钛白粉、扎模带、脱脂纱布、蚊帐布、修边针、修胚枪油、修胚枪、玻璃纤维，纤维布、热溶胶、油漆消光粉、油污干洗剂、凡士林、陶瓷脱模剂、青红胶、钾肥皂、矽油、矽胶、模具胶、矽利康、回收废硅胶。。。

This machine use the dry and clean constringent air as energy、through airflow high-speed eject to make the grinder indoor be a grinding, classification round surface and be a pressure difference indoor then raw materials are automatically inhaled the indoor of grinder with the help of ultrasonic airflow what 4-16 spray head eject (producing the impacted energy E=1/2mv2), raw materials rotate at a high speed on the classification round surface and bring the litter store and make the raw materials granules hit and rub together to attain the supper fine materials.

本机组以干燥洁净的压缩空气为动力源，通过气流高速喷射，使粉碎室内形成一个粉碎、分级圆面，并在粉碎室内形成压力差，则物料自动吸入粉碎室，在4到16个喷头所喷出的超音速气流作用下（产生冲击能E=1/2mv2），物料在分级圆面上作高速通常在2-3马赫内，对于硬度低、脆性物料工作压力可低到0.6-0.7MPa。

The company has all kinds of towel products in the high-end specifications cotton towels, bamboo fiber towels, microfiber towel, such as series of plain weave, jacquard, spiral,, cutting, etc. twistless washcloth, towel, tea towel, and towel , bath towel, beach towel, sports towel, advertisement towel, hotel towel set, beauty towel, towel dry hair, dry hair cap, car cleaning towel, pet series with towels, and different styles bathrobe, bathrobes, etc. provide OEM Products generation processing business.

公司主要毛巾产品有各类规格的中高档全棉毛巾、竹纤维毛巾、超细纤维毛巾等系列平织、提花、螺旋、缎档、割绒、无捻等面巾、方巾、茶巾、地巾、浴巾、沙滩巾、运动巾、广告巾、宾馆套巾、美容巾、干发巾、干发帽、汽车擦拭巾、宠物系列用巾及款式各异的浴衣、浴袍等，产品均提供OEM代加工业务。

Vacuum freeze-dry technology is a new and high technology on agricultural product dehydrating dry.

真空冷冻干燥是在农产品加工中应用的高新干燥技术，特别是在我国已进入国际世贸组织和农业经济结构重大调整之下，研究和应用该项技术具有重要的现实意义。

Helicopter Design Institute of China Aviation Industry deputy chief designer, AC313 helicopter designer Xu Chaoliang description, AC313 helicopter innovation embodied in the eight key technology breakthroughs: 30 minutes drive to meet the "dry run" security requirements ; fuel system and body structure to meet the anti-crash and lightning safety requirements; driver and passenger seat crashed through the anti-dynamic security testing; body structure, control systems and meet the bird impact rotor system security requirements; airborne equipment to meet the lightning and high strength radiation protection design requirements; cockpit layout to meet the crew emergency evacuation safety requirements; rotor and composite material structure to meet the fatigue assessment based on damage tolerance requirements; mechanical systems to meet the design requirements of high energy rotor burst protection.

中航工业直升机设计研究所副总设计师、AC313直升机总设计师徐朝梁介绍，AC313型直升机的自主创新具体体现在八项关键技术的突破上：传动系统满足30分钟的&干运转&安全性要求；燃油系统和机体结构满足抗坠毁及雷击安全性要求；驾驶员和乘员座椅通过抗坠毁动态安全测试；机体结构、操纵系统及旋翼系统满足鸟撞安全性要求；机载设备满足雷击和高强辐射场防护设计要求；座舱布局满足乘员应急撤离安全性要求；旋翼和复合材料结构满足基于损伤容限疲劳评定要求；机械系统满足高能转子破裂防护设计要求。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷