查询词典 High Mass

Its features: high density, mass, high extensibility, high reliability and easy management.

其特点为：超高密度、海量处理、高可扩展、高可靠性、易于管理。

The results show that the addition of certain manganese in high chromium cast iron leads to a re-partitioning of alloy elements between austenite and carbide and a dropping in equilibrium phase transformation temperature although it's inappreciable for the influence of manganese on mass fractions of every phase in this cast iron. There is about 87 percent ledeburite under thermodynamic equilibrium condition and 23 to 32 percent M7C3 type carbide under thermodynamic non-equilibrium condition in the microstructure of 3C-l5Cr-4Mn-0.75Si system high chromium cast iron. Furthermore, the improvement of austenite stability and hardenability of manganese alloyed high chromium cast iron may been expected because there is a substitution between manganese and chromium that has been suggested by thermodynamic calculations.

结果表明，锰虽然对高铬铸铁中的各相数量影响不大，但一定数量的锰存在促使合金元素在奥氏体和碳化物两相中的重新分配，并降低平衡相的转变温度；在平衡条件下3C-15Cr-4Mn-0.75Si系高铬铸铁中菜氏体数量约占87%，而非平衡条件下M7C3型碳化物数量在23%-32%之间，且奥氏体中锰铬互替现象保证了奥氏体的稳定性和加锰高铬铸铁的淬透性。

The results show that the addition of certain manganese in high chromium cast iron leads to a re-partitioning of alloy elements between austenite and carbide and a dropping in equilibrium phase transformation temperature although it＇s inappreciable for the influence of manganese on mass fractions of every phase in this cast iron. There is about 87 percent ledeburite under thermodynamic equilibrium condition and 23 to 32 percent M7C3 type carbide under thermodynamic non-equilibrium condition in the microstructure of 3C-15Cr-4Mn-0.75Si system high chromium cast iron. Furthermore, the improvement of austenite stability and hardenability of manganese alloyed high chromium cast iron may been expected because there is a substitution between manganese and chromium that has been suggested by thermodynamic calculations.

结果表明，锰虽然对高铬铸铁中的各相数量影响不大，但一定数量的锰存在促使合金元素在奥氏体和碳化物两相中的重新分配，并降低平衡相的转变温度；在平衡条件下3C-15Cr-4Mn-0.75Si系高铬铸铁中莱氏体数量约占87％，而非平衡条件下M7C2型碳化物数量在23％～32％之间，且奥氏体中锰铬互替现象保证了奥氏体的稳定性和加锰高铬铸铁的淬透性。

Using characteristic description to define High-Tech fields is mainly expressed by the summary of design thought, material application,structure treatment and construction properteis. In the 1950s, Early High-Tech school focused mostly on technology application and standardization ; in the 1970s, they emphasized industrial techinic, mainly using industrialized steal profil, glass, plastic, metal sheet and tightwire of mass production to display industry succes. In 1990s, late High-Tech school proposes durable developpement concept, to pay attention to tract, to bring importat emation factor into conception, to improve energy using rate, to protect ecological environment, and to creat comfortable environment.

借助一些特征的描述来界定高技术的范畴，主要表现为设计的思想精神、对材料的运用、结构的处理及施工特点等方面的归纳和总结。20世纪50年代早期高技派集中在高技术的采用与构件的装配化、标准化；20世纪70年代强调表现工业技术，主要使用工业化批量生产的型钢、玻璃、塑料、金属板和钢索这些材料炫耀工业成就。20世纪90年代后新高技派，倡导可持续发展理念，注重场所地域性，更发挥情感在设计中的重要因素，用高技术来提高能源使用率，有效地保护生态环境，营造舒适宜人的环境。

Based on the review of the description of subtropical high and the research on its formation, fluctuation characteristics and physical mechanisms, it is found that the subtropical high is refered to the area where pressure is relatively larger. Its formation is due to the existence of mean meridional circulation that accumulates air mass to subtropical areas. The subtropical high is belt-like with meridionally non-uniform feature and this is a zonal mean point of view.

通过对副高的描述、形成及演变特征和物理机理的研究进行回顾，认为：副高是相对的气压的高值，是由于平均经圈环流的存在，使得有空气质量在副热带地区的堆积而形成的，成为带状，表现出在经度方向的不均匀，这是一种纬向平均的观点；同时，在这个平均的高压带上常常有闭合的单体存在，表现出纬向的不均匀。

In the dry sliding experiments of composites, friction coefficients decreased with the increase of load. Plastic deformation happened in the worn surface where Fe element was found, so PAM micro-fiber supported part of the load and prevented the further deformation. On the condition of high speed and high load, the worn surface of PAM1/nylon 6 composites was nearly melted and formed comparative uniform transfer on the surface of steel, which accounted for the rather low wear mass loss. The infrared analysis showed that the a small quantity of transition of crystal form from α into γ of nylon and its composites happened during the friction because of the high temperature and strong sheering strength.

通过对复合材料耐磨性能研究表明：复合材料的摩擦系数随载荷的增加而逐步下降，且磨损表面有明显的塑性变形；从能谱分析结果来看，复合材料表面有Fe的存在，表明PAM微纤承受了部分载荷，并阻止了基体的进一步塑性变形及粘着转移；在高速高载时，PAM1/尼龙6磨损表面处于粘流态，并在钢环表面形成了连续的转移膜，表现出较好的耐磨损性能，且在高温和强剪切力的作用下，材料基体发生了少量的α晶体向γ晶体的转移。

The agitation power consumptions in boiling systems decrease uniformly with the increase of agitation speed, whereas the relative power demand (RPD-the ratio of agitation power input of HEDT for gassed system to that for ungassed system and under the same agitation speed) can maintain at a high level for high gas loadings even when the impeller is operating with a high impeller tip speed. The gas hold-up in the boiling system is much lower than that in the cold gassed system, and the gas hold-up in boiling system increases at first and then decreases with the increase of the agitation power consumption per liquid mass P(subscript m. It implies that the boiling three-phase system has a maximum gas hold-up point. The changes of nucleation site of vapour bubble and the character of suspension of the solid particles with the rotational speed of the impeller are responsible for those behaviors mentioned.

在沸腾条件下，搅拌功率消耗随着搅拌转速的增加有所下降，但HEDT桨具有较高的载气能力，即使在高叶端线速度下，相对功率消耗仍能保持在较高的水平；沸腾体系的气含率随单位质量流体输入功率的增加表现出先增后减的规律，即存在气含率的极大值，蒸汽成核位置和固体颗粒悬浮特性随搅拌功率增加而改变是造成上述行为的主要原因；沸腾体系中的气含率远远低于常温通空气体系。

The high fat-fed group were fed with high fat diet containing 59% saturated free fatty acids. The n-3 fatty acids group was fed with 20% replacement of saturated fatty acid by C18:2 in bean oil instead of high-fat diet. The free fatty acid elements in bean oil were detected by gaschro-matography/mass-spectrometry.

对照组喂饲普通饲料，高脂组喂饲提供59%热卡的饱和脂肪酸高脂饲料，n-6脂肪酸组喂饲高脂饲料，其中提供20%热量的饱和脂肪酸由豆油中的C18：2代替。

Storage condition and available period of water spore, slant tube seed, plate colony and lyophilized vegetative mass were examined. The result showed the best seed style was lyophilized vegetative mass whose ability of high enzyme yield remains stable preserved at -20℃ for three months.

通过对水芽孢、试管斜面、平板菌落和冻干营养体保存条件及其对产酶能力影响的研究，确立冻干营养体为可直接用于摇瓶发酵的生产菌种，该菌种在-20℃保存三个月对发酵无不良影响。

NSC-7 could degrade 73.6% of rice straw within 14 d. 10 kinds of material were detected in volatile products by gas chromatography mass spectrometry, and they were mainly acetic acid, glycerol, butyric acid, and propanoic acid. NSC-7 could retain stable degrading ability and high cellulase activity after preserved in -80℃ and freeze-drying for four years. It could remain its degrading ability after 90℃ of high temperature treating for 30 min, and resume its degrading ability after subcultured 2 times after 105℃ of high temperature treating for 30 min in autoclave.

NSC-7在14 d的培养过程中，使稻秆分解73.6％；用GC-MS测定结果发酵液中检测到10种化合物成分，其中峰值较大的依次为乙酸、甘油、丁酸、丙酸； NSC-7在-80℃冷冻和冻干条件下保存4年后仍具有稳定的秸秆分解能力和纤维素内切酶活性；经90℃高温处理30 min后，仍能够保持分解能力， 105℃处理30 min后转接2次就能恢复分解能力，显示出很高的保存稳定性和热稳定性。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。