查询词典 H-bomb

Using much cheaper Chlorine as fuel, nearly 10 Watt 3.8 micrometer HCl laser was realized by H+Cl2 and H+ClF pump reactions without changing structure of discharge driven HF/DF laser. 12 Watt HF-HCl dual-band lasing were obtained using F-ClF-H2 chain reaction pump system.

以廉价的Cl2为燃料，在不改造电激励HF/DF激光器结构的基础上，分别利用H+Cl2泵浦反应和H+ClF泵浦反应实现了近10W的中心波长3.8μm HCl激光，并利用F-ClF-H2链反应泵浦体系获得了12W的HF-HCl双波段激光。

Schauengurg[2] considered more general case and found necessary and sufficient conditions for the cosmash product coalgebra H Q to be a Hopf algebra with a Hopf subalgebra H and a weak projection !

Schauenburg在文献[2]中把Radford的研究加以推广，给出了使余smash积HQ为Hopf代数，H为HQ的子Hopf代数，且具有弱投射π：HQ→H(即π是左模余代数同态，且π|_H=id_H)的等价条件。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After preaging at 100℃for 24 h, retrogression at 200℃for 7 min, and reaging at 100℃for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210MPa in 3.0%NaCl+0.5%H2O2corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100 ℃ for 24 h, retrogression at 200 ℃ for 7 min, and reaging at 100 ℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5%H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The main component of ramie glial was pectin, hemicellulose and lignin; The single factor on degumming of ramie test was respectively analyzed with a high vigorous of pectinase KDN and TZ-888 compound enzyme （mainly xylanase and mannanase on the pH value, bath ratio, dosage of enzyme, metal ions, temperature and time.The orthogonal test of L9（34 were done by bath ratio, dosage of enzyme, temperature and time. The results showed that the best compages of KDN pectinase on degumming was 1∶12 of bath ratio,pH 8.6,1 mmol/L Mg2+,300 IU/g of KDN pectinase,35℃、6 h;the best compages of TZ-888 compound enzyme on degumming was 1∶18 of bath ratio,pH 4.0,1 mmol/L Ca2+, 500 IU/g of TZ-888 compound enzyme,45 ℃,6 h.

摘 要：本研究根据苎麻胶质的主要成分为果胶、半纤维素和木质素，用高活性的KDN果胶酶和TZ-888复合酶（主要是木聚糖酶和甘露聚糖酶）从pH值、浴比、酶用量、金属离子、温度、脱胶时间等方面进行单因素试验，然后选取影响显著的浴比、酶用量、温度，时间进行四因素三水平的脱胶试验，结果表明鲜麻采用KDN果胶酶脱胶最佳组合为浴比1：18，pH 8.6， 1 mmoL/L Mg2+，酶用量300 IU/g，温度35 ℃、时间6 h时处理，TZ-888复合酶脱胶最佳组为浴比1：12，pH 4.0， 1 mmoL/L Ca2+，酶用量500 IU/g，温度45 ℃，时间6 h进行脱胶为优化的试验条件。

This thesis takes the H corporation's central procurement department as a case study to discuss the essential considerations of the procumbent methods and process as well as how this H corporations, congealment , it's industry sectors and its uniqueness, it's procurement process and strategy, and the approach using the IT software's in making the procurement decisions, hoping from this research will provide helpful contributions to other companies and organizations.

本研究以台湾H集团公司中的联合采购中心为所要探讨的内容，透过个案分析，本文探讨H集团产业，因其多角化的经营，及其各产业之特殊性，以及在进行采购时所考虑选择采购方式及采购流程为主，讨论其IT 软体解决方案之采购策略，希望藉此研究对已推展或尚未推展之企业有所贡献，并提出一些实务上的建议作为参考。

According to the amount of alive cells and the rate of conidium production, the optimum parameters were obtained as follows: bran 100 g, mineral matter M-1 15 g, K2HPO4 0.3 g, NaCl 0.25 g, KNO3 0.1 g, CaCO3 0.8 g, natural pH, liquid seed age 84 h, inoculum volume 10%, fermentation temperature 30°C, the ratio of material to water is 10:6, fermentation time 60 h.

获得固体发酵物料的最佳参数为：麸皮100 g、M-1 15 g、磷酸氢二钾0.3 g、氯化钠0.25 g、硝酸钾0.1 g、碳酸钙0.8 g，自然pH值，液体菌种种龄84 h，接种量10%，发酵温度30°C，料水比10：6，发酵时间60 h。

We constructed a Hubert space H in which the element is continuous function and a operator T: H→H.

构造－Hilbert空间H，其中的元素是具有周期性的连续函数。

The optimal convergence rates in H-1 and L-2 norms are proved, and the convergence order in L-2 norm is one order higher than that in H-1 norm.

并分别给出了解的H-1模和L-2模的最优收敛阶估计， L-2模收敛阶比H-1模收敛阶高一阶。

The coordinate transformation and numerical integration was executed on the discretized tetrahedral elements based on which the 3-D MT vector-finite element method was implemented. A whole computation framework for 3-D vector-finite element method with unstructured mesh was given. Based on this some typical models were tested which has demonstrated that our algorithm could distinctively avoid problems caused by the fake solution and both the accuracy and efficiency were enhanced which made our algorithm has a bright future for further application.3. According to theory of Sobolev vector space and the discretization of Helmholtz space, the error estimate which was suitable for 3-D MT vector-finite element modeling was deduced by which the procedure of adaptive technique was guaranteed.4. Based on the fully unstructured tetrahedralization and optical strategy, the 3-D magnetotelluric h-adaptive vector-finite element method was presented through combining the error estimate. With this work, the accuracy and creditableness for 3-D MT complicatedly modeling was guaranteed.5. The 3-D magnetotelluric h-adaptive vector-finite element algorithm with unstructured mesh was implemented.

针对非结构化的四面体单元，采用坐标变换和数值积分方法，实现了MT三维矢量有限单元分析，建立起基于非结构化网格的三维MT矢量有限元计算流程，并对典型模型和国际标准电磁模型进行了数值模拟，结果对比和分析表明，基于非结构化网格的三维MT矢量有限元不仅消除了节点型有限元的伪解，而且具有很高的计算精度和速度，有广阔的应用前景。3、根据Sobolev函数的向量空间和Hemlholtz空间的分解，推导出基于残差的三维大地电磁矢量有限元后验误差估计公式，为三维大地电磁自适应矢量有限元数值模拟的实现奠定了基础。4、在完全非结构化四面体单元剖分及优化基础上，结合三维大地电磁矢量有限元后验误差估计公式，提出了基于非结构化网格的三维大地电磁h-型自适应矢量有限元计算策略，保证了对复杂大地电磁模型数值计算的精度和可靠性。5、实现了基于非结构化网格的三维大地电磁h-型自适应矢量有限元计算流程，对典型模型和国际标准电磁模型进行了数值模拟。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。