查询词典 G-force

In the course of the embossing of the paper by clalendaring force backward uponsize, if there is not enough force to maintain the stability of the paper, then paper when printing units to imprint on the drum with corresponding bliding and bliding in the paper was accmulation amplificatory end, resulting in a throw-off point.

纸张在压印历程洋施到压延辛向后的拉辛，如果不不安纵足不亏不小的辛来保持纸张的安定的话，那么压印时纸张不离便当在压印滚筒上爆发相差的滑移，并且这栽滑移也会在纸尾处被补偿放不小，导致甩角。

From the 0 degree to 130 degree at per 10 degree migration changes of anteromedial and posterolateral bundle of the ACL were measured in comparison with the migration at 90 degree in the condition of no force and vertical force of 50 N.

分别在不受力和受纵向力50N的状态下在膝关节屈曲0度到130度之间每隔10度测量前内侧束和后外侧束相对于90度时的位移变化；并通过固定金属标记物分别推算两束的松驰和紧张时的角度。

Monte Carlo simulation technique in the grand canonical ensemble with TraPPE force field by adjusting the partial force field parameter to fitting the isotherm adsorption of pure component was employed to simulate the adsorption of methane ,ethane and the sep- aration of their mixtures in siliclite-1 respectively.

采用TraPPE力场、巨正则系综蒙特卡罗的方法，通过调节部分力场参数，拟合纯组分等温吸附的实验数据，研究了甲烷、乙烷纯组分在silicalite-1中的吸附平衡性及其共混物的分离性。

Monte Carlo simulation technique in the grand canonical ensemble with TraPPE force field by adjusting the partial force field parameter to fitting the isotherm adsorption of pure component was employed to simulate the adsorption of m ethane , ethane and the sep- aration of their mixtures in siliclite-1 respectively.

采用TraPPE力场、巨正则系综蒙特卡罗的方法，通过调节部分力场参数，拟合纯组分等温吸附的实验数据，研究了甲烷、乙烷纯组分在silicalite-1中的吸附平衡性及其共混物的分离性。

The result indicated that reasonably designing of the cable in the cable-stayed arch bridge can reduce the axile force of the entire arch and obviously reduce the hogging moment and the shearing force the skew back.

分析结果表明：与普通拱桥相比，合理的设计斜拉拱组合桥中斜拉索的参数，能够一定程度地降低整个拱肋的轴力，减小拱脚的负弯矩和剪力。

According to the internal force and external force of the cloth,the physical model is built.With this model,the dynamic simulation process of the cloth from non-balanceable state to balanceable state can be computed when collisions are not happened.

根据织物内部结构和外部受力的特点，建立物理模型，计算模型在没有碰撞的情况下，动态的模拟织物从非平衡的受力状态到平衡的受力状态之间的全过程。

Since it is not easy to judge the direction of force in a fall, much less the extent of force, the belayer must evaluate each situation and make use of the rock for the most secure position.

由于在降落过程中很难判断受力的方向，更不用说受力的大小，因此保护者必须对每一种情况进行估量，并利用岩石取得最安全的位置。

Since it is not easy to judge the direction of force in a fall, much le the extent of force, the belayer must evaluate each situation and make use of the rock for the most secure position.

由于在降落过程中很难判断受力的方向，更不用说受力的大小，因此保护者必须对每一种情况进行估量，并利用岩石取得最安全的位置。

Using bevelled punch and step punch in blanking die, carried on the rational distribution to blanking force, reduced the blanking force well which the press equipment need, and the question of insufficient press equipment pressure was solved.

在冲裁模中结合使用斜刃凸模和阶梯凸模，对冲裁力进行合理分配，很好地降低了冲压设备所需的冲裁力，解决冲压设备压力不足的问题。

The atomic force microscope invented by Binning et al in 1986 possesses very high spatial resolution. It measures the atomic force through a micro-cantilever of very little spring constant .

原子力显微镜是1986年由诺贝尔奖金获得者Binnig等人发明的一种分辨率极高的表面分析仪器，它通过检测一根弹性常数极小的微悬臂梁在样品表面。。。

Finally it offers the analysis of the fault-tolerance system as well as its test verification.

这样，运行于空间环境中的系统的设计目标就是在保证系统实时性

However, it is still difficult to find out the real reason of the increase of the keratinized gingiva during the orthodontic extrusion whether it is due to the proliferation of the gingival tissue or to its elastic nature, that is because the proliferation of the fibroblasts as well as the connective tissue changes in volume and the intra-fibers spaces were all immeasurable in most of the studies.

然而，仍然难以找到真正的原因增加的角化牙龈在正畸挤压它是否是由于扩散的牙龈组织或其弹性性质，这是因为增殖的成纤维细胞以及作为结缔组织的变化量和内部纤维空格都是不可估量的，大多数的研究。