查询词典 Fe

The inverted torsion pendulum technique (JN-1 vacuum internal friction technique) was used to test the damping capacities of Fe-Al alloys.

本文采用葛氏倒扭摆(JN—1型真空扭摆仪)测试了Fe-Al系合金的阻尼性能。

The effect of Al content on the Zener relaxation peak in annealed Fe-Al alloys has been investigated using a computer-controlled automatic inverted torsion pendulum through free-decay and forced vibration method.

在多功能内耗仪上用自由衰减和强迫振动方法研究了Al含量对退火态Fe Al合金Zener弛豫的作用。

In this paper, the North subtropical cork oak forests, fir, pine torch, Mao bamboo and Chinese fir forest soil in the budding B, Mo, Cu, Zn, Fe, Mn and effective content distribution in soil profiles in the law affecting their effective of soil factors and the different stands on soil micro-nutrient contents.

将以下中文摘要翻译成英文摘要本文研究了北亚热带栓皮栎林、杉木林、火炬松林、毛竹林和杉木萌芽林土壤中B、Mo、Cu、Zn、Fe、Mn的有效含量、在土壤剖面中的分布规律、影响其有效性的土壤因子以及不同林分对土壤微量养分含量的影响。

The content of the heavy metal element: Cd, Cr, Cu, Fe, Mn, Ni, Pb, Ti and Zn in tree rings in both two growth backgrounds: major urban road system and campus in Nanjing were examined and analyzed.

方法］对南京市区主要城市干道行道树和作为对照组的南京林业大学校园内的雪松、法国梧桐和水杉3个对应树种树木年轮重金属元素Cd、Cr、Cu、Fe、Mn、Ni、Pb、Ti、Zn含量进行了测试和对比分析。

Surface relief caused by the formation of lower bainite in an Fe-C-Si-Mn alloy has been investigated by STM. It was discovered that the subunit which is the lowest structural unit observed by TEM is actually made up of sub-subunits. The surface relief due to the formation of sub-subunit is tent-shaped, and of a non-IPS type, which indicates that the sub-subunit cannot be formed by shear. The height of relief is 60-140nm, and the maximum shape deformation is ca.

用扫描隧道显微镜对Fe-C-Si-Mn合金中的下贝氏体浮突进行了观察研究发现用透射显微镜观察到的最小结构单元——亚单元是由更小的超亚单元组成的超亚单元的浮突为&帐篷&型，而非不变平面应变型，表明它不是切变形成；超亚单元的浮突高度为60-140nm，最大形状变型量约为0.23。

The stainless steel contains an Ag-Cu binary master alloy with a weight percentage of 0.10 to 4.0 percent and the weight percentage for the rest chemical components are as follows: C less than or equal to 0.08 percent, Si less than or equal to 1.0 percent, Mn less than or equal to 2.0 percent, P less than or equal to 0.04 percent, S less than or equal to 0.03 percent, Ni 7.0 to 15.0 percent, Cr 17.0 to 20.0 percent, Mo less than or equal to 4.0 percent, N less than or equal to 0.15 percent and the rest are Fe and unavoidable impurities.

本发明公开了一种奥氏体抗菌不锈钢及其制造方法，所述不锈钢含有重量百分比为0.10～4.0％的Ag-Cu二元中间合金，其余化学成分重量百分比为：C：≤0.08，Si：≤1.0，Mn：≤2.0，P：≤0.04，S：≤0.03，Ni：7.0～15.0，Cr：17.0～20.0，Mo：≤4.0，N：≤0.15，其余为Fe和不可避免的杂质。

The effectiveness of some Fe,Ca and Na compounds have beendetermined in the steam gasification of coal.

本文对褐煤的水蒸汽气化过程中Fe、Ca 及Na 化合物的催化作用进行了考察。

After dissolution, the Cr in samples was oxidized to Cr with KMnO4.Fe(superscript 3+) and Cu(superscript 2+) were masked with NH4HF2 and thiourea, respectively. In acid solution at pH 3.0-4.0, the I2 generated from the reaction of Cr and KI could form high-sensitivity blue complex with starch. The absorbance was measured spectrophotometrically at 590 nm.

样品溶解后，用KMnO4将Cr氧化为Cr，以NH4HF2掩蔽Fe(上标 3+)、硫脲掩蔽Cu(上标 2+)后，在pH3.0~4.0的酸性溶液中，Cr与KI作用后生成的I2遇到淀粉后形成灵敏度很高的蓝色络合物，此络合物最大吸收波长为590nm。

When the charge formula among concentrate, sodium carbonate and coal powder is 100:50:10, the temperature is 980℃, time is 60 min, the direct recovery rates of main metals are that 92.29% Pb, 79.82%Sb and 84.94%Ag, the slag ratio of metals for Pb, Sb, Ag, In, Zn, Cu and Fe are 5.00%, 3.21%, 8.97%, 69.76%, 95.28%, 78.00% and 87.74% respectively, the grade of sodium sulphide in the slag is 52%, the slag ratio is 62.4%.

炉料配方为精矿：纯碱：煤粉＝100：50：10；温度为980℃，时间为60 min时，各主要金属直收率分别为：Pb 92.29、Sb 79.82、Ag 84.94，金属入渣率分别为：Pb 5.00、Sb 3.21、Ag 8.97、In 69.76、Zn 95.28、Cu 78.00、Fe 87.74，熔炼渣中硫化钠品位为52%，渣率为62.4%。

ABSTRACT Fe-3wt%Si oriented silicon steel sheets have been applied extensively to the generation, transmission and application of electricity.

Fe-3wt％Si取向硅钢片在电力的生产、传输和利用上有着广泛的应用。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。