查询词典 FE

The effect of Fe on the stability of Fe aqueous solution were not markedly.

Fe对Fe的稳定性无显著影响。

Through simple Gaussian line fits, we found not only obvious Fe K line variability with no significant difference in the X-ray continuum flux between two ASCA observations which were separated by～440 days, but also rapid variabilities of Fe K line on time scales～10〓s within the second observation.

使用简单的高斯线拟合我们发现，在间隔440天左右的两次ASCA观测之间，NGC 4051的铁Kα荧光线轮廓和强度有着明显变化，而与此同时X射线连续谱流量保持不变；不仅如此，我们发现在第二次ASCA的观测过程中，NGC 4051的铁Kα荧光线有着10〓s尺度上的快速变化。

Sb can combine with Cu and P to form a low melting point compound which lowers the melting point of binary Cu-8P eutectic alloy by nearly 200℃. Bi and Cu can create compounds with low melting point(270℃) distributing at the boundaries and that is the reason why the melting point of (Cu-8P)-Bi is lower than that of binary Cu-8P eutectic alloy. The eutectic cluster can be refined with the addition of Fe, and that is the reason why the addition of Fe can decrease the melting point of Cu-8P alloy. Two means of decreasing the melting point of Cu-8P are found.

一定量的Sb与Cu， P形成低熔点相，从而大幅降低了Cu-8P合金的熔点，使其熔点降低近200℃；加入少量Bi后， Bi与Cu在共晶团晶界上形成熔点为270℃左右的低熔点化合物，且Bi的加入明显细化Cu-8P合金共晶团，从而使Cu-8P合金的熔点降低；加入Fe能明显细化Cu-8P合金的共晶团，使层片间距由8μm减为2μm以下，并使共晶团由层片状向短棒状转变，虽然Fe与Cu形成熔点为806℃的高温相，但Fe的细化作用使得Cu-8P合金的熔点降低，但降低幅度不大。

Using Mo powder,Fe-B alloy powder,and Fe powder as raw materials,and adding Cr,Ni and C alloy and agent polyvinyl butyral,Mo_2FeB_2 hard alloy was clad on a Q235 steel substrate to form a new type of cladding material with excellent wear and cor- rosion resistance property by means of vacuum liquid phase sintering technique.

以Mo粉、Fe-B合金粉、Fe粉为基本原料，掺加适量合金元素Cr，Ni，C，以及有机粘结剂聚乙烯醇缩丁醛，采用真空液相烧结法在Q235钢基体表面制备Mo_2FeB_2硬质合金覆层，获得了力学性能良好且耐磨抗蚀的新型硬质合金覆层材料。

Saturated calomel electrode , which was the characteristic peaks of Hb Fe/Fe, in pH 7.0 phosphate buffer solution.

SCE，与典型的血红素Fe/Fe氧化还原对电位一致。

Ferrotitanium , nickel and sucrose to carbonize the sucrose. TiC/ Fe-Ni composite coatings were prepared by plasma spraying of the Ti-Fe-Ni-C composite powder .

以 TiFe粉、Ni粉和蔗糖为原料，通过蔗糖的热分解碳化制备 Ti-Fe-Ni-C系反应热喷涂复合粉末，并利用等离子喷涂制备了 TiC/ Fe-Ni复合涂层。

All geothermal water samples show high concentration of F, Si, Sr and Fe.Concentration of Fe, Si, and Sr ions is mainly controlled by solubility of fluorite, quartz andchalcedony, and celestite, respectively.

其中，F离子浓度主要受控于萤石的溶解；硅含量主要受控于石英和玉髓矿物的溶解；锶离子浓度主要受控于天青石矿物的溶解。

And the optimum pH was 4-6 for the dechlorination reaction of 2,4-D, and pH between 2 and 8 were all suited for the reaction in Pd/Fe systems. Intermediate and final products of 2,4-D, HCH and chlordane with Pd/Fe were determined by GC/MS, and the possible dechlorination pathways were concluded: 2,4-D can be converted to phenoxyacetic acid through gradual hydrogenolysis, and HCH can be transformed to cyclohexatriene through dichloroelimination or dehydrochlorination.

通过GC/MS定性定量分析了三种目标污染物在Pd/Fe体系中发生还原脱氯反应过程中的反应物及最终产物，并根据反应产物推测分析了这三种有机污染物在催化还原反应体系中可能的反应途径：2，4-D主要通过逐级氢解最终生成彻底脱氯产物苯氧乙酸；而六六六则可能通过逐步双氯消除反应或脱氯化氢反应，最后生成环己三烯。

The Chondrite normalized REE pattern shows typical enrichment of LREE, with ∑REE peaking up to 318 mg kg^(-1) in central layer of the profile. Both Ce and Eu have a similar trend of variation in the profile, i.e. positive anomaly-negative anomaly-positive anomaly from bottom to top. The highest ∑REE value occurs where negative Ce and Eu anomaly and relatively higher Fe(superscript 2+)/Fe(superscript 3+) values also occur.

剖面稀土元素分布型式为轻稀土富集型，∑REE在风化壳中部达到最高值318 mg kg^(-1)，剖面上Ce和Eu均呈正异常－负异常－正异常变化趋势，∑REE最高值出现在Ce和Eu负异常和Fe(上标 2+/Fe(上标 3+)较高层位，∑REE与Fe2O3显著正相关。

Twenty four chrysoberyl and alexandrite samples from the major deposits all over the world were studi- ed qualitatively by XRF and the trace elements in chrysoberyl were gotten mainly to be Fe, Ga, Ti, in alexandrite to be Fe, Cr, Ti.

对24块世界主要产地的金绿宝石和变石进行X荧光能谱分析，得到其所含的主要微量元素分别是Fe、Ga、Ti和Fe、Cr、Ti。

"Please accept this talisman as a token of our thanks."

请收下这个护身符以表达我们的感谢。

If I have that magic, I will be more acceptable in the society.

如果我拥有那种魔法，我将更加被这个社会所容纳。