查询词典 Bessemer converter

First use of sensors to convert the weight of voltage signal, and then voltage signal amplification input A / D converter, followed by A / D converter tool analog signals into digital signals, the digital signal will be sent to the microcontroller, through the process of Signal processing, and weighing function, and then the weight and keyboard input price multiply calculated lump sum, and the weight and price with LCD display.

首先用传感器把重量转换成电压信号，再将电压信号放大输入A/D转换，利用A/D转换工具将模拟信号转化为数字信号，将得到的数字信号传送至单片机，通过程序对信号进行处理，实现称重功能，然后将重量与键盘输入单价相乘计算出总价，并将重量和价格用LCD显示出来。

A zero rippled input current and continuous output current Buck-Boost converter topology converter was proposed.

针对传统Buck-Boost输入输出电流断续的缺点，提出一种基于独立电感零纹波输入电流和输出电流连续的Buck-Boost变换器，详细分析了变换器的稳态工作原理。

Sparse matrix converter; matrix converter; zero current; waveforms

论文导师朱建林，论文学位硕士，论文专业电力电子与电力传动

A phase-shifted controlling PWM DC/DC full bridge converter with softswitching is proposed and used to realize a constant current power of20A(5～48V).This full bridge converter utilizes the transformer leakageinductance(or the resonant inductance in series with transformersprimary)and the autoecious capacitance of MOSFET to achieveZVS(Zero-Voltage-Switching),as a result it can decrease the switchingwaste,increase the switching frequency,and diminish the power bulk.

本文使用一种通过移相控制进行脉宽调制的软开关全桥变换器来实现20A(5～48V)恒流源，这种全桥变换器利用变压器的漏感、原边串联谐振电感和功率管的寄生电容来实现开关管的零电压开通，降低了开关损耗，提高了开关频率，减小了电源体积。

AT89C51 is the hardcore of this part which has other peripheral chips such as A/D converter, calendric clock, voltage converter and memory.

PC机部分主要是用VB编写的程序来实现数据通讯、数据显示和数据处理的功能。

Then the voltage source type matrix converter mathematics model is established each in 3-phase static and circumrotate coordinate system, moreover by open-loop simulation, the simulation results show that the voltage source type matrix converter can realize the frequency range very broad sine wave input-output, moreover by regulating circuit parameter, the power factor in input side reaches 1 approximately, realization static VAR compensator function.

然后分别建立了电压源型矩阵变换器在三相坐标系和旋转坐标系下的数学模型，并且对电压源型矩阵变换器进行开环仿真，仿真的结果表明电压源型矩阵变换器能够实现频率范围很广的正弦波输入输出，而且通过调整电路参数使得输入侧的功率因数约为1，实现静止无功补偿器的功能。

Use aerobic converter steel-making to this kind of molten iron, desulphurization rate can exceed 30%～ commonly 35%, because this need not use pretreatment of molten iron to decoke, use aerobic converter steel-making to be able to take off sulfur only divide 0.045% the following.

对此类铁水采用氧气转炉炼钢，脱硫率一般可以超过30%～35%，因此不必采用铁水脱硫预处理，仅采用氧气转炉炼钢即可将硫脱除到0.045%以下。

Based on the research, founded on existing production conditions, production capability and technical natures of KISC, especially its own development requirements, linked with the development trend of the iron and steel industry, fully considering the continuity of equipment upgrade and technical optimization of KISC, guided under principles of validity and benefit, the writer analyses and argues that in current conditions. KISC shall not adopt the hot metal pretreatment of desiliconization, dephosphorization and desulphurization, but the end-point converter process to improve the dephosphorization effect. But according to the development plan of KISC, with its scale development, upgradeof equipment and technical conditions and implementation of a plan to use high-phosphorus ironstone, its more suitable to adopt the converter-shaped pretreatment of desiliconization, dephosphorization and desulphurization.

在此研究基础上，立足昆钢当前生产条件、生产能力和工艺特点，特别是昆钢自身发展需要，结合钢铁工业发展趋势，充分考虑昆钢现行装备改造和工艺优化的延续性，以有效性和经济性原则为指导，分析讨论了在昆钢当前条件下，不适宜采用铁水&三脱&预处理工艺，而宜考虑采用转炉复吹技术以达到改善转炉吹炼过程脱磷效果的目的；而根据昆钢的发展规划，随着昆钢的规模化发展，生产装备及工艺条件的更新改善及利用高磷铁矿计划的实施，则适宜采用转炉型&三脱&预处理技术。

Based on analysis of factory converter slag,predominate phosphorus was found concentrated in a solid solution of dicalcium silicate and tricalcium phosphate,as reported in some research about slow cooled converter slags.

研究显示，如文献中对缓冷钢渣的研究结果一样，工厂稳定化处理后的转炉钢渣中的磷主要以磷酸三钙与硅酸二钙形式的固溶体存在。

A method is also provided for reducing axial space within a dual-input clutch transmission having a torque converter, including providing an on-axis transmission pump with a housing and rotor set, providing a torque converter with a rotatable hub which is drivingly connected to the rotor set for powering of the transmission pump, and mounting the dual-input clutch to the pump housing for support.

还提供一种方法以减少带变矩器的双输入离合器变速器的轴向空间，包括提供带有壳体和转子组的同轴变速器泵，提供带有可旋转毂的变矩器，所述可旋转毂以驱动的方式连接到转子组以为变速器泵提供动力，并且将双输入离合器安装到泵壳体上以支撑。

A carrier gas such as nitrogen is directed through line 20 and valve 22 to connect with line 26 and mix with the gas sample.

如氮气之类的载体通过管线20和阀22引入，与管线26相通，与气体样品混合。

But for the most part, knaves and parasites had the command of his fortune

然而支配他的家产的大多是恶棍和寄生虫。