查询词典 B.L.

The ideal activation process parameter as follow: The nickel sulfate hexahydrate concentration 15g·L~(-1);The Sodium borohydride concentration 15g·L~(-1); The Sodium hydroxide concentration 10-15 g·L~(-1);Hydrochloric acid concentration 10-15 g·L~(-1);The activation time in A solution 9min, the activation time in B solution 90s.

理想的活化工艺参数为：硫酸镍15g·L~(-1)，硼氢化钠15g·L~(-1)，氢氧化钠10-15 g·L~(-1)，盐酸10-15 g·L~(-1)，A液中活化的时间控制在9min左右为最佳，B液中活化的最佳时间为90s。

The apparent quantum efficiency of SO〓〓/TiO〓 was 10 times of that of TiO〓 catalyst for the photocatalytic degradation of bromomethane. Therefore, the SO〓〓/TiO〓 superacid catalyst is promising for practical application in environmental remediation.It was found that both L and B acid sites exist on SO〓〓/TiO〓 photocatalyst while only L acid sites on TiO〓 photocatalyst. On the basis of experimental results, the synergistic model of superacidic centers was proposed for SO〓〓/TiO〓 photocatalyst to explain the photocatalytic behavior and the mechanism of superacidifing effects, assuming that the adjacent L and B acid sites induced by SO〓〓 comprise cooperatively the superacidic center on superacid photocatalyst. The group cooperation of the superacidic center could strengthen the surface acidity, increase surface acid sites and the adsorbtion of O〓, promote separation of photogenerated electron-hole pair, enhance the interfacial transfer of charges and reversibility of water adsorption. Consequently the excellent photocatalytic activity, reaction stability and resistibility to humidity of SO〓〓/TiO〓 superacid photocatalyst may attributed to the group cooperated effect of the superacidic center on the photocatalyst.

研究结果表明：SO〓〓与TiO〓表面的结合为螯合式双配位结构；TiO〓光催化剂表面经H〓SO〓浸渍处理后，提高了表面酸性，改善了催化剂结构和光催化性能，当H〓SO〓浸渍浓度为1.0mol.L〓、烧结温度为450℃时，可制得SO〓〓/TiO〓超强酸催化剂(H〓＜-12.14)，其结构和光催化活性得到明显改善，与TiO〓相比，SO〓〓/TiO〓光催化剂的锐钛矿含量高、晶粒小、BET比表面积大、孔径分布集中、光谱吸收边蓝移，具有优异的光催化氧化活性、稳定性及抗湿性能，光催化降解溴代甲烷的表观量子效率比TiO〓催化剂提高了一个数量级，是一种有实际应用前景的高效光催化剂；由此提出了SO〓〓/TiO〓超强酸催化剂表面集团协同作用的超强酸中心模型，认为在SO〓〓/TiO〓超强酸催化剂表面，由SO〓〓诱导的相邻L酸中心和B酸中心组成了集团协同作用的超强酸中心，其集团协同作用显著地增强了催化剂表面酸性、增大了表面酸量及O〓吸附量、促进了光生电子和空穴的分离及界面电荷转移，具有可逆吸附水的性能，是SO〓〓/TiO〓超强酸催化剂具有优异的光催化氧化活性、很好的活性稳定性及抗湿性能的重要原因。

In the bolting time and blooming time, B deficiency mainly influenced on the growth of the propagative organ of rapeseed ( Brassica Napus L.), the agronomic character was similar to the seedlings, and the B concentration range of the rapeseed varieties which responded to the B scarce was 0.005 mg/L to 0.25 mg/L.

苔期和花期，缺硼主要影响甘蓝型油菜繁殖器官的形成和发育，营养生长农艺性状的变化规律与苗期相似，品种间对缺硼反应差异最大的硼浓度范围为0.005 mg／L—0.25 mg／L。

The lowest surface tension of N_xB solution was better at 25℃, and lowest surface tension would down with carbon . cmc( critical micelle concentration) and γ_ in N_(12)B are 4.1 × 10~(-4)mol/L, 24.5 mN.m~(-1),what was smaller than LAS . The cmc of N_(12)B- NaCl are down with NaCl up.The surface tension and cmc of N_(12)B and N_(16)B are higher than that of N_(12)OB and N_(16)OB because of hydrophilic group ,but that of N_(12)B is lower than that of N_(16)B because of hydrophobic group .5. The borate structure and semipolar bond were studied in different pH by infrared spectrum .It indicated that N_xB and N_xOB have not semipolar bond at pH

4、25℃，N_xB系列都有较低的表面张力，并随碳原子数的增加而最低表面张力下降。N_(12)B比同碳原子数的十二烷基苯磺酸钠的最低表面张力34.5mN／m低，且临界胶束浓度为4.1×10~(-5)mol／L，也比LAS低，且随着NaCl浓度的增加而略有下降，比较N_(12)B和N_(16)B，由于C_(16)疏水基的异构体使N_(12)B的临界胶束浓度和临界胶束浓度时的表面张力γ_(cmc都低，由于增加了亲水基团使得N_(12)OB和N_(16)OB的表面张力和临界胶束浓度都要高于N_(12)B和N_(16)B。

N - Fmoc - L - B - homoglutamine and N - Fmoc - L - B - homoasparagine have been prepared by anidt - eistert synthesis from commercially available N - Fmoc - L - a - glutamine and Na - Fmoc - Nr - trityl - L -asparagine.

描述了应用Arndt-Eistert反应合成两种含酰胺基的N-Fmoc-L-β-氨基酸的方法，讨论了在Wolff重排过程中，N-Fmoc-L-α-谷氨酰胺重氮甲基酮和N-Fmoc-L-α-天冬酰胺重氮甲基酮的各自特点及反应过程中生成的副产物。

Chapter five explores the connections between the nature of B/L and the disputes under B/L, including delivery of cargo without presenting B/L, issuing antedated B/L and non-collecting cargo.

第五章论述提单的法律性质与无单放货、倒签提单、无人提货等三大类提单纠纷之间的关系。

According to the structure characteristics of L-B composite brake beam, the finite element model of L-B brake beam based on contact is established, and the stress distribution of the brake beam in different conditions calculated is using I-DEAS software. Calculated results show that the stress concentration mainly generates in the root of brake header slider, which fit with the faults in actual operation, and provide reliable basis to improve design and optimization.

根据L-B型组合式制动梁的结构特点，运用I-DEAS软件建立基于接触的L-B型制动梁有限元模型，并计算了制动梁在不同工况下的应力分布，计算结果表明应力集中主要发生在闸瓦托滑块根部，这与实际运行中出现的故障较为吻合，为制动梁的改进设计和结构优化提供了依据。

Methods Six adult Wistar rats were randomly divided into two groups: group A (n=3) and group B (n=3). 2μl volume of 0.8mmol/L and that of 1.6mmol/L aqueous solution of MnCl2 was injected into the vitreous body of the left eye of group A and group B respectively.

6只Wister大鼠，随机分为两组，每组3只，一组左侧眼球玻璃体内注射0.8mmol/L MnCl2 2μl，一组左侧眼球玻璃体内注射1.6mmol/L MnCl2 2μl，用1.5T超导磁共振扫描，观察视觉传导通路的显示；一周后6只大鼠右侧外侧膝状体注射1mmol/L MnCl2 1μl，观察视觉皮层的定位。

Two types of three-arm or four-arm star-shaped D,L-PLGA50-b-PL-LA copolymer were synthesized via the block copolymerization of L-LA monomerwith star-shaped D,L-PLGA50 as macroinitiator and 〓 as catalyst.

以三臂或四臂星型D，L-PLGA50共聚物为大分子引发剂、〓为催化剂，引发L-LA单体的嵌段共聚合，合成了三臂或四臂星型D，L-PLGA50-b-PL-LA共聚物。

Normative references GB 150 steel pressure vessel GB 152.1 ~ 152.4 fastener hole and Shen Kong GB 196 commonDast Gate Valves thread of basic dimensions (diameter l ~ 600mm) GB 197 common thread of tolerance and fit (diameter of 1 ~ 355mm) GB 798 live bolt GB 897 stud bm = ld GB 898 stud bm = 1.25d GB 901 Dlass B and other long stud GB 5782 Hexagon head bolts B and B class GB 5796.1 ~ 5796.4 Dl 150, 300, 600 Lb Dast Steel Gate Valvestrapezoidal thread GB 6175 2 Hexagon nut B and B class GB 9112 types of steel pipe flanges GB 9113.1 ~ 9113.26 Integral steel pipe flanges GB 12220 Universal Valve Logo GB 12221 length of theDl 900, 1500 Lb Dast Steel Gate Valves valve structure of metal flange GB 12222 Multi-turn valve actuator attachment GB 12224 General requirements for steel valves GB l2228 General Valve carbon steel forgings GB 12229 Universal Valve carbon steel castings GB 12230 Universal Valve austenitic steel castings GB / T 12252 General requirements valve supplier ZB Jl6 006 test and test valve 原文来源:http://www.1zhafa.com

引用标准 GB 150 钢制压力容器 GB 152.1～152.4 紧固件通孔及沉孔 GB 196 普通螺纹基本尺寸(直径l～600mm) GB 197 普通螺纹公差与共同(直径1～355mm) GB 798 活节螺栓 GB 897 双头螺柱bm＝ld GB 898 双头螺柱bm＝1.25d GB 901 等长双头螺柱 B级 GB 5782 六角头螺栓 B和B级 GB 5796.1～5796.4 梯形螺纹 GB 6175 2型六角螺母 B和B级 GB 9112 钢制管法兰类型 GB 9113.1～9113.26 整体钢制管法兰 GB 12220 通用阀门标记 GB 12221 法兰连接金属阀门结构长度 GB 12222 多回转阀门驱动装配的连接 GB 12224 钢制阀门一般要求 GB l2228 通用阀门碳素钢锻件技术条件 GB 12229 通用阀门碳素钢铸件技术条件 GB 12230 通用阀门奥氏体钢铸件技术条件 GB/T 12252 通用阀门供货要求 ZB Jl6 006 阀门的试验与检验

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。