查询词典 Al

The Al/PAR/Al structure could be described as a simple circuit equivalent to parallel connection of a variable resistor and a capacitor.

Al/PAR/Al结构可以简单等效为电阻与电容的并联，而退火与自然放置将使薄膜结构趋于稳定。

Effect of different surfactants on the UV intensity of Al(superscript 3+)-MXFX have been studied. Is Cetyl Trimethy-lammonium Bromide can increase the UV intensity of Al(superscript 3+)-MXFX is discovered. Based on this reaction, the reaction conditions in detail and proposed a simple, rapid and sensitive new method for the determination of MXFX by UV method is inve stigated. This method has been applied for the determination of MXFX in tablet with satisfactory results.

通过研究不同表面活性剂对Al(上标 3+)-莫西沙星体系紫外特性的影响，发现十六烷基三甲基溴化铵对该体系有显著的增敏作用；系统研究了CTMAB-Al(上标 3+)-MXFX反应体系的紫外特性，利用这一反应体系，建立了简单、快速、灵敏的测定莫西沙星的紫外分光光度法，选择了最佳实验条件，并将此方法用于莫西沙星片剂的测定，结果满意。

In this experiment, the two high alloying Al-2 at%Cu-8 at%Mg、Al-3 at%Cu-12 at%Mg alloys were cast in cuneal mould at different cooling rates after the delicate alloy composition design.

通过合金成分设计，采用常规铸造工艺在不同的凝固速度下制备原子比Cu∶Mg=1∶4的Al-2%Cu-8%Mg、Al-3%Cu-12%Mg两种高合金化铝合金，利用XRD、OM、SEM、TEM等分析测试手段，观察了合金的组织特征。

The Ni-Fe and Mg-Al-Fe-LDH show paramagnetism at normal temperature, the calcined samples of LDHs show super-paramagnetism. The magnetization increases with the higher Fe~(3+) content and is independent of the crystal structure of LDHs. Magnetization of the calcinates of Ni-Fe-LDHs is higher than the Mg-Al-Fe-LDHs.3. Two novel SFME systems were found for the first time, that is furaldehyde/DMF/water and furaldehyde/ethanol/water system.

结果表明，Ni-Fe和Mg-Al-Fe型LDHs本身及其煅烧产物在常温下均呈现顺磁性，其煅烧产物均呈现超顺磁性；同类LDH中其煅烧产物的磁性大小与Fe~(3+)含量成正比而与LDH的晶体结构无关，Ni-Fe LDHs及其煅烧产物的磁性强于Mg-Al-Fe LDHs及其煅烧产物，。3。

The percentage of myelocytic circles in AL patients was significantly lower than in normal controls, indicating hemopoietic hypofunction in AL patients.

AL患儿骨髓细胞周期的S期细胞比例明显低于正常对照，说明AL患儿白血病细胞的增殖能力低下。

The microstructures of hypoeutectic and hyper-eutectic Al-Cu and Al-Si alloys solidified at high pressure (5 GPa) were investigated.

研究了亚共晶或过共晶Al-Cu和Al-Si合金在5 GPa压力条件下凝固的显微组织特征。

The solidification microstructures of hypoeutectic, eutectic and hypereutectic Al-Si alloys by melt temperature treatment were studied comparatively.

摘 要：对3种典型成分的铝硅合金（Al-20%Si、 Al-12%Si和Al-7%Si）进行了熔体温度处理凝固组织变化规律的比较研究。

The current theory and application of Al-Si alloy mainly focus on the study of hypoeutectic and eutectic, therefore we systematically analyzed the modification process of hypereutectic Al-Si alloy based on the methods and results of predecessors. Several factors including the modification temperature, the content of modifier, the available holding time, the times of repeat melting , the casting temperature and the speed for cooling have been studied in order to understand its effects to the composition, function and performances of primary silicon and eutectic silicon.

中文摘要本文针对目前Al-Si合金相关应用和理论的研究多集中于亚共晶和共晶合金的情况，在前人的研究成果和研究方法的基础上，对过共晶Al-Si合金变质处理进行了较为系统的分析，研究了变质剂的成分配比、变质温度、变质剂的加入量、变质后的静置时间、浇注温度及冷却速度等因素对过共晶铝硅合金中初晶硅和共晶硅的大小、形状、数量和分布的影响。

The current theory and application of Al-Si alloy mainly focus on the study of hypoeutectic and eutectic, therefore we systematically analyzed the modification process of hypereutectic Al-Si alloy based on the methods and results of predecessors. Several factors including the modification temperature, the content of modifier, the available holding time, the times of repeat melting , the casting temperature and the speed for cooling have been studied in order to understand its effects to the composition, function and performances of primary silicon and eutectic silicon.

本文针对目前Al-Si合金相关应用和理论的研究多集中于亚共晶和共晶合金的情况，在前人的研究成果和研究方法的基础上，对过共晶Al-Si合金变质处理进行了较为系统的分析，研究了变质剂的成分配比、变质温度、变质剂的加入量、变质后的静置时间、浇注温度及冷却速度等因素对过共晶铝硅合金中初晶硅和共晶硅的大小、形状、数量和分布的影响。

ZnO, MgO and SiO_2 powders were covered on top of the alloy as dopants, the effects and principles of the dopants were discussed. Based these, SiC particles were made into preforms with different distribution of air holes by changing the granularity of SiC particles and the content of graphite additive, and the oxidation growth of aluminum alloy melt into the air holes within the preform was controlled to prepare SiC/Al_2O_3/Al composite with inerratic shape. And the SiC particles effect principle to the oxidation of SiC/Al2O3/Al composite was studied.

以ZnO，MgO和SiO_2为引发剂，覆盖在合金表面，讨论了引发剂的添加效果和作用机理；在此基础上将α-SiC颗粒制作成为预制体，通过改变SiC的粒度和石墨造孔剂的含量，调整预制体内部的气孔分布，控制铝合金熔体在预制体孔隙内的氧化生长，制备出形状规则的SiC/Al2O3/Al复合材料，同时研究了SiC颗粒的存在对SiC/Al_2O_3/Al复合材料生长机理的影响。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。