- 更多网络例句与韧相关的网络例句 [注：此内容来源于网络，仅供参考]
-
It introduced the study progress on PA toughened by modified EPDM at home and abroad,analyzed the influencing factors during toughening PA with modified EPDM,such as graft ratio,content of rubber,crystallizability of PA etc.
介绍了国内外改性EPDM增韧尼龙研究进展，分析了在改性EPDM增韧PA过程中的影响因素，如接枝率、橡胶含量、PA的结晶性能等，阐述了EPDM增韧PA的机理，最后展望了该领域的发展趋势和方向。
-
The mechanical properties of horniness segmer graft toughening epoxy resin, toughening effect and microstructure of the fracture surface of toughened condensate have been studied on.
研究了硬质链段接枝增韧环氧树脂的机械性能，分析了增韧剂的增韧效果以及增韧后固化物断面的显微结构。
-
A traditional method to improve the toughness of composites is to incorporate toughener component into the matrix system to form a two-phase structure.
为了改善BMI树脂基复合材料的抗冲击损伤能力，传统的增韧方法是在树脂基体中引入增韧剂形成两相结构，提高树脂基体的韧性，达到增韧复合材料的目的。
-
Secondly,the phase separation mechanism,phase evolution and mechanical properties of toughener/BMI diphase system were investigated to prepare for toughening composite with Ex-situ technique.
其次，针对离位增韧中增韧剂与BMI树脂之间的相分离行为，研究了增韧剂与BMI树脂的反应诱导相分离机理、相形貌演化和力学性能。
-
The midrib-bundl es have be found with follow possible evolutionary trends: amphicribral bundle- almost-amphicriral bundle collateral bundle.
讨论 了中脉维管束类型可能的演化趋势：周韧维管束→近周韧维管束→下韧维管束。
-
According to the arra ngem ent of phloem and xylem, shape of xylem and the Arranging way of xylem rays, the midrib-bundles were divided into five forms :(1) amphicribral round bundle;(2 ) pinnate-ray amphicribral reniform bundle;(3) fan-ray amphicribral reniform b undle;(4) almost-amphicribral bundle;(5) collateral bundle.
根据中脉维管束结构特点：木质部与韧皮部的位置，木质部的形状，木射线排列的方式，可分为5个类型：（1）圆形周韧维管束；（2）羽线肾形周韧维管束；（3）扇线肾形周韧维管束；（4）近周韧维管束；（5）下韧维管束。
-
A study of phase morphology of PBT/POE-g-MAH/nano-CaCO3 composite by means of scanning electron microscopy showed that the domains size of nano-CaCO3 capsulated by POE-g-MAH elastomer in composite when PBT was mixed directly with POE-g-MAH and nano-CaCO3 together or with nano-CaCO3 capsulated by POE-g-MAH elastomer is large.
采用熔体流动速率较低的EPS30R与纯POE-g-MAH共混制备的增韧改性剂，在PBT基体中的分散相变得粗大且不均匀，共混物的脆韧转变推迟。SEM显示，纯POE-g-MAH增韧剂使PBT共混物发生脆韧转变时，弹性体分散相颗粒产生塑性变形，诱发基体屈服而吸收能量。
-
This observation provided a strong support to the point that most leaves export the most of assimilates in the light time. Plasmodesmal densities between SE/CC, CC/PP, PP/PP and PP/BSC (bundle-sheath cell) decreased in weak light. Plasmodesmata were observed between CC/SE (nacreous-walled sieve element), PP/BSC in branch veins in normal light intensity, but not in weak light. Thus apoplasmic pathway may be the main mode of transport of assimilates in weak light, however symplasmic pathway may be the main mode of transport of assimilates in normal light intensity.
在筛管/伴胞、伴胞/韧皮薄壁细胞、韧皮薄壁细胞/韧皮薄壁细胞和韧皮薄壁细胞/维管束鞘细胞之间的胞间连丝密度都在弱光条件下下降，在正常光照强度下支脉筛管/伴胞和韧皮薄壁细胞/维管束鞘细胞之间可以观察到胞间连丝，而在弱光下几乎观察不到胞间连丝的存在，所以同化物的运输在弱光条件下可能以质外体运输为主，而在正常光照强度下，共质体运输可能是主要的运输方式。
-
It reveals that the cavetation damage is more important than the cold-drawing for polymer toughening by rigid particles.
在此基础上讨论了①刚性有机粒子增韧、②刚性无机粒子增韧、③刚性粒子和橡胶混杂填充增韧聚合物的基本概念、分析方法、界面的作用、脆韧转变的判据和机理。
-
The basic principle of the toughening and modifying on bismaleimide resin was introduced, the characteristics and the modifying effects of the toughening and modifying with thermoplastic resin, the combination of aromatic diamine and epoxy resin, organic silicone, allyl compounds, cyanate ester resin, the blends of three-dimensional braided carbon and Kevlar fabrics and so on were discussed.
介绍双马来酰亚胺树脂增韧改性的基本原理，论述了热塑性树脂增韧改性、芳香族二胺和环氧树脂相结合增韧改性、有机硅增韧改性、烯丙基系列化合物增韧改性、氰酸酯树脂增韧改性、三维编织碳纤维和凯夫拉纤维混合增韧改性等方法的特点与改性效果。
- 更多网络解释与韧相关的网络解释 [注：此内容来源于网络，仅供参考]
-
breaking tenacity：断裂韧度;破裂韧度
断裂应力,破裂应力 breaking stress | 断裂韧度,破裂韧度 breaking tenacity | 断裂韧度,破裂韧度 breaking toughness
-
dimple fracture：韧窝断口
韧窝断口(dimple fracture) 韧窝是金属塑性断裂的主要微观特征. 它是材料在微区范围内塑性变形产生的显微空洞,经形核、长大、聚集最后相互连接而导致断裂后,在断口表面上所留下的痕迹. 韧窝的大小包括平均直 ...
-
Firmware version：(韧体版本):UPS 内的韧体版本
a. Enable Alarm:本事件发生时执行或不执行此项保护动作. | Firmware Version (韧体版本):UPS 内的韧体版本. | Rating VA (额定VA):UPS 的额定功率.
-
Gt Fortitude：强韧加强:强韧鉴定
iton will 钢铁意志:意志鉴定+2 | gt fortitude 强韧加强:强韧鉴定+2 | Lightnig reflexes 闪电反射:反射鉴定+2
-
amphicribral bundle：周韧维管束
维管束还可以根据初生木质部和初生韧皮部排列方式的不同而分为外韧维管束(collateral bundle)、双韧维管束(bicollateral bundle)、周韧维管束(amphicribral bundle)和周木维管束(amphivasal bundle)四种类型(图3-40).
-
bicollateral bundle：双韧维管束
维管束还可以根据初生木质部和初生韧皮部排列方式的不同而分为外韧维管束(collateral bundle)、双韧维管束(bicollateral bundle)、周韧维管束(amphicribral bundle)和周木维管束(amphivasal bundle)四种类型(图3-40).
-
Stereum Sanguinolentum：细绒韧革菌
91.血痕韧革菌Stereum Sanguinolentum | 92.细绒韧革菌Stereum Sanguinolentum | 93.毛韧革菌Stereum hirsutum
-
Stereum fasciatum：扁韧革菌
韧革菌科Stereaceae | 89.扁韧革菌Stereum fasciatum | 90.红褐韧革菌Stereum rufum
-
Stereum rufum：红褐韧革菌
89.扁韧革菌Stereum fasciatum | 90.红褐韧革菌Stereum rufum | 91.血痕韧革菌Stereum Sanguinolentum
-
toughened glass：韧化玻璃
tough-brittle transition韧-脆转移 | toughened glass韧化玻璃 | toughened polystyrene韧化聚苯乙烯