- 更多网络例句与长细比相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Through the low cyclic load test of eight high strength concrete-filled square steel tubular columns, considering the effect of the axial compression ratio, steel ratio and slenderness ratio, the hysteretic curve, ductility, degradation of stiffness, energy dissipation capacity, failure mechanism and characteristics of the specimens were researched.
摘要]以轴压比、含钢率和长细比为参数,进行了8根方钢管高强混凝土柱的低周反复荷载试验,研究分析了该类构件的滞回曲线、延性、刚度退化、耗能能力、破坏机理和破坏特征;并与型钢高强混凝土柱的受力性能进行了比较分析。
-
The parameters used in the analyses include rise to span ratio, slenderness ratio, steel ratio and load conditions.
分析的参数有矢跨比、长细比、含钢率以及加载方式。
-
As a compress-bend structure, with increasing of the span, length slender ratio and carrying load of arch increase, lateral rigidity and width span ratio of arch ring minish relatively. During construction and service stages, lateral stability becomes more important and a control factor of arch bridge design.
拱肋作为压弯结构,随着跨径的增大,杆件的长细比及所承受的荷载也随之增大,拱圈横向刚度、宽跨比相对减小,在施工阶段及使用阶段横向稳定问题特别突出,常常成为拱桥设计的控制因素。
-
As a structure that is compressed and bended, with increasing of the span, length slender ratio and carrying load of arch increase, lateral rigidity and width span ratio of arch ring minish relatively. During constructing and bring to bear, lateral stability becomes especially severity and a control factor of arch bridge design.
拱作为压弯结构,随着跨径的增大,杆件的长细比及所承受的荷载也随之增大,拱圈横向刚度、宽跨比相对减小,在施工阶段及使用阶段横向稳定问题特别突出,常常成为拱桥设计的控制因素。
-
This requirement ensures that the slenderness ratio of the individual Csection between connectors is less than or equal to one-half of the slenderness ratio of the entire compression member in the case that any one of the connectors may be loosened or ineffective.
这个要求确保在任一连接件可能松脱或失效的情形下,单段U型钢的长细比小于或等于整个抗压构件长细的二分之一。
-
The results show that the most remarkable factor is the slenderness ratio, the axial compression ratio takes second place and the steel ratio is third.
结果表明,对其影响最大的为长细比,其次是轴压比,再次是含钢率。
-
By testing the bearing capacity of 6 steel reinforced high-strength concrete columns,the influence of different slenderness ratio on behaviors of the columns was analyzed.
通过6根钢骨高强混凝土柱的承载力试验,分析了长细比对柱受力性能的影响,由试验得出钢骨高强混凝土长柱的承载能力随试件长细比的增大而降低,随混凝土强度等级的提高而提高,破坏的突然性随长细比的增大而愈加明显
-
Based on this, the stability bearing capacity of steel reinforced high-strength concrete long columns were studied by changing slenderness ratio, the strength grade of
根据试验和理论分析,得出钢骨高强混凝土长柱稳定承载力随着长细比的增大而降低,随着混凝土强度等级的提高而增大;偏压柱承载力随着初始偏心距的增加而降低。
-
With Newton-Raphson and arc-length calculation method, this paper has made research on effect of various cable style, rise-span ratio and slenderness ratio on ultimate bearing capacity.
文中使用牛顿—拉弗森法和弧长法对荷载—位移平衡路径进行跟踪研究,研究了索对结构极限承载力的影响;分析中考虑了不同矢跨比和长细比等因素对索—拱结构极限承载力的影响。
-
Total of 16 CFST dumbbell shape d columns subjected to eccentric loads were tested with variation of slenderness ratio and eccentricity ratio.
共进行了10根不同长细比的钢管混凝土哑铃形轴压长柱(5根强轴向破坏,5根弱轴向破坏)的试验研究。
- 更多网络解释与长细比相关的网络解释 [注:此内容来源于网络,仅供参考]
-
sleeve valve engine:滑阀式发动机
sleeve valve 套阀 | sleeve valve engine 滑阀式发动机 | slenderness ratio 长细比
-
sleight:技巧;熟练;戏法
sleigh 雪橇 | sleight 技巧;熟练;戏法 | slenderness ratio 长细比
-
slenderness:细长
slenderness ratio 长细比 | slenderness 细长 | slew 旋转
-
slenderness ratio:长细比
sleight 技巧;熟练;戏法 | slenderness ratio 长细比 | slenderness 细长
-
slenderness ration:长细比
轴心受压构件--member in axial compression | 长细比--slenderness ration | 计算长度--effective length
-
equivalent slenderness ratio:换算长细比
equilibrium moisture content 平衡含水率(66) | equivalent slenderness ratio 换算长细比(57) | equivalent uniformly distributed live load. 等效均布活荷载(14)
-
equivalent slenderness ratio:等效长细比
长细比 slenderness ratio | 等效长细比 equivalent slenderness ratio | 支撑力 nodal bracing force
-
slenderness ratio WESTBANK:长细比
slender proportion WESTBANK 长细比 | slenderness ratio WESTBANK 长细比 | slenderness WESTBANK 细长
-
boundary slenderness ratio:界限长细比
boundary member 边缘构件 | boundary slenderness ratio 界限长细比 | bow 顺弯
-
fines herbes:细混香辛料
细度比,长宽比 fineness tatio | 细混香辛料 fines herbes | 精馏 finestill