英语人>词典>汉英 : 返回料 的英文翻译,例句
返回料 的英文翻译、例句

返回料

基本解释 (translations)
returns

更多网络例句与返回料相关的网络例句 [注:此内容来源于网络,仅供参考]

Backhoe excavator operations each cycle, including mining, Rotary, discharge and return to the course of four.

反铲挖掘机每一作业循环包括挖掘、回转、卸料和返回等四个过程。

The granularity distribution is great improved after the filtration of stage treatment slurry on phosphogypsum (the crassitude phosphogypsum rate is increased and the fine-crushing decreased).

选用适合的分级设备对湿法磷酸反应料浆进行分级处理,分级底流送过滤机过滤洗涤,分级溢流作为晶种返回反应槽进一步长大。

After classification under flow(the crassitude phosphogypsum are crystal),the intermediate are transmitted to filter for filtration and washing.As crystal seed of classification overflow(the fine-crushing phosphogypsum are crystal)is returned to reactor and further crystal.

选用适合的分级设备对湿法磷酸反应料浆进行分级处理,分级底流送过滤机过滤、洗涤,分级溢流作为晶种返回反应槽进一步长大。

The working principle of a pump rod joint is to place the joint hoop bar stock into the stock bin. When the magic hand moves to the material receiving, with the help of gravity action, the bar stock automatically fall to the magic hand. When the pneumatic cylinder drives the magic hand to move to the designated location of the turning fixture, with the live center of the pneumatic tailstock automatically sent, the bar stock will be fixed between the apex of the lathe and the live center of the pneumatic tailstock. Then the magic hand automatically returns to the charging position with a single charging action completed, and prepares for the next charging.

它的工作原理是先将接箍棒料放置于料仓内,当机械手运动到接料位置时,棒料由于重力作用,自动掉落到机械手中,通过气缸带动机械手运动到指定车削位置时,尾座活顶尖自动送出,将棒料固定于机床顶尖与尾座活顶尖之间,机械手自动返回装料位置,完成单次供料动作,为下次送料做准备。

However, the size and amount of microporosity increase with the recycle material proportion, and the microporosity in 100% recycled alloy is much more than that in the virgin alloy.

返回料比例不超过80%时,返回料的加入对合金的高温持久性能和室温拉伸强度没有明显影响,但室温延伸率有所下降;100%返回料合金的力学性能明显下降,其高温持久寿命和室温延伸率已不能满足技术条件要求。

Through computer simulation of azeotropy rectification dehydration tower with benzene as entrainer, the optimal technical parameters were obtained as follows:①the output quantity of top tower was 69 kg/h, return benzene phasor as 58 kg/h and reflux ratio as 3, alcohol concentration in charge the higher the better, however, its maximum value influenced by water content at azeotropy point;②sensitivity analysis results indicated that the sensitivity of output quantity of top tower was the highest, alcohol concentration in charge the second and return benzene phasor and reflux ratio the lowest.

对以苯作为夹带剂的共沸精馏脱水塔进行了计算机模拟,得到了最佳工艺参数:①塔顶采出量为69 kg/h,返回苯相量为58 kg/h,回流比为3,进料乙醇浓度越高越好,但其最大值受共沸点水含量的影响。②敏感性分析的结果为塔顶采出量的灵敏度最大,进料乙醇浓度次之,而返回苯相量和回流比较小。

Given the current complexity of industrial recovery of 3'-methyl-2'-butenyl 3, 3-dimethyl-pentenoate and the decomposition problems with 2-methyl-1-butene, research was conducted on a process for direct recycling of MBDP involving an ester exchange reaction of MBDP with either methanol, trimethyl orthoacetate, or solutions of methanol and trimethyl orthoacetate.

针对目前工业上回收3,3-二甲基-4-戊烯酸-3'-甲基-2'-丁烯酯工艺复杂、异戊烯大量分解问题,研究了MBDP直接返回循环使用工艺,MBDP与甲醇、原乙酸三甲酯或与甲醇原乙酸三甲酯混合溶液进行酯交换反应的回收新工艺,比较了四异丙基钛酸酯、甲醇钠、氢氧化钾用作酯交换催化剂的效果,筛选出回收MBDP&一锅煮&最佳工艺:按照n:n:n:n=1.0:9.8:9.2:0.05物质的量比投料,74℃~78℃反应21h,MBDP转化为贲亭酸甲酯和异戊烯醇,单程转化率87.7%,用85%的磷酸中和甲醇钠,蒸出甲醇,直接用于合成贲亭酸甲酯。

Car become, bring balanced axle worker of material frame location utensil hang, transport to B line wholly always work, by oneself, take back empty material shelf return, lift, unloading set up the fixed area, the working whole journey is controlled by PLC form.

自行小车工作时将平衡轴总成带料框工位器具整体吊运至B线,返回时带回空料架,起吊、下料设置固定区域,工作全程由PLC程式控制。

The way that concentrated slurry under requirement returns directly to the storage tank of feed slurry helps to keep the stability of feed concentration, which is the solution to the fluctuation of discharge concentration.

采取浓度未达标的浓缩完成液直接返回浓缩前储罐的方法,可以保持进料浓度稳定,系统控制的稳定性大大提高,解决了降膜蒸发系统由于进料浓度波动带来的启动波动大、控制困难等问题。

The reject flap in the discharge chute should be driven to the "reject" position, then back again, several times at 10s intervals to ensure complete cleaning.

在出 料槽内的分料风门,应该被打开到分料状态,然后再返回,以 10 秒钟的间隔反复进行几次,确保清洗干净。

更多网络解释与返回料相关的网络解释 [注:此内容来源于网络,仅供参考]

revert metallics:金属物返料

revert 返料,下脚料 | revert metallics 金属物返料 | revert scrap 返回废钢